2008 FORD EXPLORER key

4. To attach the new wiper to the
wiper arm, align the cross pin and
keyway (denoted with the arrows)
and firmly press the wiper blade
into the wiper arm until an audible
snap is heard.
ENGINE OIL
Checking the engine oil
Refer to thescheduled maintenance informationfor the appropriate
intervals for checking the engine oil.
1. Make sure the vehicle is on level ground.
2. Turn the engine off and wait a few minutes for the oil to drain into the
oil pan.
3. Set the parking brake and ensure the gearshift is securely latched in P
(Park).
4. Open the hood. Protect yourself from engine heat.
5. Locate and carefully remove the engine oil level dipstick.
•4.0L V6 engine
2008 Explorer(exp)
Owners Guide (post-2002-fmt)
USA(fus)
Maintenance and Specifications
340

detected by the OBD-II may not have symptoms that are apparent,
continued driving with theService engine soon
indicator on can
result in increased emissions, lower fuel economy, reduced engine and
transmission smoothness, and lead to more costly repairs.
Readiness for Inspection/Maintenance (I/M) testing
Some state/provincial and local governments may have
Inspection/Maintenance (I/M) programs to inspect the emission control
equipment on your vehicle. Failure to pass this inspection could prevent
you from getting a vehicle registration. Your vehicle may not pass the I/M
test if theService engine soon
indicator is on or not working
properly (bulb is burned out), or if the OBD-II system has determined
that some of the emission control systems have not been properly
checked. In this case, the vehicle is considered not ready for I/M testing.
If theService engine soon
indicator is on or the bulb does not
work, the vehicle may need to be serviced. Refer to the On board
diagnostics (OBD-II) description in this chapter.
If the vehicle’s engine or transmission has just been serviced, or the
battery has recently run down or been replaced, the OBD-II system may
indicate that the vehicle is not ready for I/M testing. To determine if the
vehicle is ready for I/M testing, turn the ignition key to the ON position
for 15 seconds without cranking the engine. If theService engine
soon
indicator blinks eight times, it means that the vehicle is not
ready for I/M testing; if theService engine soon
indicator stays on
solid, it means that the vehicle is ready for I/M testing.
The OBD-II system is designed to check the emission control system
during normal driving. A complete check may take several days. If the
vehicle is not ready for I/M testing, the following driving cycle consisting
of mixed city and highway driving may be performed:
15 minutes of steady driving on an expressway/highway followed by 20
minutes of stop-and-go driving with at least four 30-second idle periods.
Allow the vehicle to sit for at least eight hours without starting the
engine. Then, start the engine and complete the above driving cycle. The
engine must warm up to its normal operating temperature. Once started,
do not turn off the engine until the above driving cycle is complete. If
the vehicle is still not ready for I/M testing, the above driving cycle will
have to be repeated.
2008 Explorer(exp)
Owners Guide (post-2002-fmt)
USA(fus)
Maintenance and Specifications
364

Illuminated visor mirror .............98
Infant seats
(see Safety seats) .....................211
Inspection/maintenance (I/M)
testing ........................................364
Instrument panel
cleaning ...................................330
cluster ........................................12
J
Jack ....................................301, 304
positioning .......................301, 306
storage .............................301, 304
Jump-starting your vehicle ......311
K
Keyless entry system ...............157
autolock ...........................146, 148
keypad .....................................158
locking and unlocking doors ..159
programming entry code .......158
Keys ...........................................160
positions of the ignition .........256
L
Lamps
bulb replacement
specifications chart ..................92
daytime running light ...............88
fog lamps ...................................87
headlamps .................................87
interior lamps ...........................91
Liftgate ......................................144
remote release ........................153
Lights, warning and indicator ....12
anti-lock brakes (ABS) ..........262
Load limits .................................242Loading instructions .................248
Locks
autolock ...........................146, 148
childproof ................................151
doors ........................................146
Lubricant specifications ...........370
Lug nuts ....................................310
Luggage rack .............................145
Lumbar support, seats .....165, 167
M
Message center .................115, 127
english/metric button .....118, 131
system check button ......118, 131
warning messages ...........123, 137
Mirrors ...............................103–104
automatic dimming rearview
mirror ......................................103
fold away .................................105
heated ......................................105
side view mirrors (power) .....104
Moon roof ..................................111
Motorcraft parts ........332, 353, 369
N
Navigation system .......................78
O
Octane rating ............................357
Oil (see Engine oil) ..................340
P
Parking brake ............................263
Parts (see Motorcraft parts) ....369
2008 Explorer(exp)
Owners Guide (post-2002-fmt)
USA(fus)
Index
382