2008 FORD C MAX rear light

Downloaded from www.Manualslib.com manuals search engine LIGHTING CONTROL
Lighting control positions
OffA
Side and tail lampsB
HeadlampsC
Front fog lampsD
Rear fog lampsE
Parking lampsF
Parking lamps
CAUTION
Prolonged use of the parkinglamps will discharge the battery.
Switch off the ignition.
Push the lighting control inwards andturn it to position F.
Main and dipped beam
Pull the lever fully towards thesteering wheel to switch betweenmain and dipped beam.
Headlamp flasher
Pull the lever slightly towards thesteering wheel.
Home safe lighting
Switch the ignition off and pull thedirection indicator lever towards thesteering wheel to switch theheadlamps on. You will hear a shorttone. The headlamps will go offautomatically after 3 minutes with anydoor open, or 30 seconds after thelast door has been closed.
With all doors closed, but within the30 second delay, opening any doorwill result in the 3 minute timerstarting again.
The home safe lights can becancelled by either pulling thedirection indicator lever towards thesteering wheel again or by turningthe ignition switch ON.
64
LightingE71094DBCAFE E71095

Downloaded from www.Manualslib.com manuals search engine AUTOLAMPS
Note:If you have switchedautolamps on, you can only switchthe main beam on when autolampshas switched the headlamps on.
The headlamps will come on and gooff automatically depending on theambient light.
FRONT FOG LAMPS
WARNING
Only use the front fog lampswhen visibility is considerablyrestricted by fog, snow or rain.
Note:You cannot switch the frontfog lamps on if you have switchedautolamps on.
REAR FOG LAMPS
WARNING
Do not use the rear fog lampswhen it is raining or snowing andvisibility is more than 50 metres.
Note:You cannot switch the rearfog lamps on if you have switchedautolamps on.
65
LightingE73840A E71096 E71097

Downloaded from www.Manualslib.com manuals search engine HEADLAMP LEVELLING
Without headlamp levellingA
With headlamp levellingB
The level of the headlamp beams canbe adjusted according to the vehicleload.
Recommended headlamp levelling control positions
Control position
Load
Load in luggage
compartment1
Persons
Rear seatsFront seats
0--1-2
1-31-2
2max.31-2
66
LightingE78044 E65990

Downloaded from www.Manualslib.com manuals search engine Control position
Load
Load in luggage
compartment1
Persons
Rear seatsFront seats
3max.-1
4max.32
1 See Technical specifications (page 228). Higher control positions (+1)
may be necessary when towing a trailer.
67
Lighting

Downloaded from www.Manualslib.com manuals search engine CHANGING A BULB
WARNINGS
On vehicles fitted with Xenonheadlamps, have the headlampbulbs changed by an expert. Thereis a risk of injury due to high voltage.
During operation, the bulbs andtheir surroundings get hot.Switch off the lights and let the bulbscool down before replacing them.
Always switch off lights and ignitionbefore replacing any bulb.
Never touch the glass of the bulbs.Fit only bulbs having a UV filter.Always replace a faulty bulb with anew one of the same type. Afterreplacing a bulb, check that the lightsoperate correctly.
Headlamps, side lamps,direction indicators
Note:It is necessary to remove theheadlamp assembly to remove anyof the bulbs.
Removing the headlampassembly
Open the bonnet.
Remove the screw.
WARNING
When re-installing the lampassembly, make sure that thewiring connectors and retaining clipsare engaged properly.
Press down the retaining clips at therear of the lamp assembly using ascrewdriver and carefully pull out thelamp assembly.
74
LightingE78106 E78107

Downloaded from www.Manualslib.com manuals search engine Install in the reverse order.
Rear lamps
Open the tailgate.
Remove the pillar panel trim insidethe luggage compartment.
Remove the sidewall panel trim togain access to the second wing nut.
Remove the wingnuts. Make sure thewing nuts do not fall into the opening.
Pull off the rear lamp assembly outof the two plastic retainers on thebody panel.
Disconnect the wiring connector.
Loosen the screws and remove thecomplete bulb holder.
80
LightingE78122 E78123 E78124 E78125

Downloaded from www.Manualslib.com manuals search engine Brake lamp P21 wattA
Direction indicator PY21 watt(orange)B
Reversing lamp P21 wattC
Rear fog lamp/tail lampP21/4 WattD
Note:Vehicles may not have a taillamp if an LED board is fitted. TheLED board is not a serviceable item,please consult your dealer if this fails.
Turn the bulb anticlockwise underslight pressure and remove it.Replace the bulb.
Install in the reverse order. Afterinstallation, check that the lightsoperate correctly.
Central brake lamp
Consult an expert.
Number plate lamp
5 watt festoon
Loosen the two screws, and removethe lamp assembly.
Install in the reverse order.
Interior and reading lamps
Switch off the lights.
Insert a flat-bladed screwdriver intothe recess between the body of theunit and the lens at the opposite sideto the switches. Gently prise out thelens a short way. Take hold of theside of the lens and lift it off the unit.
81
LightingE78126 E72556 E7812812

Downloaded from www.Manualslib.com manuals search engine ELECTRIC WINDOWS
WARNING
Do not operate the electricwindows unless they are freefrom obstruction.
Note:If you operate the switchesoften during a short period of time,the system might become inoperablefor a certain time to prevent damagedue to overheating.
Switch on the ignition to operate theelectric windows.
Global opening and closing
You can also operate the electricwindows with the ignition off via theglobal opening and closing function.See Locks (page 40).
Driver's door switches
You can operate all the windows withthe switches on the door trim panelof the driver’s door.
Opening and closing thewindows automatically
Press or lift the switch to the secondaction point and release itcompletely. Press or lift it again tostop the windows.
Safety switch for rearwindows
Note:You can always operate therear windows from the driver’s door.
A switch in the driver’s door disablesthe rear electric window switches.
The light in the switch comes on andthe lights in the rear window switchesgo off when the rear windows aredisabled.
Anti-trap function
WARNING
Careless closing of the windowscan override the protectionfunction and cause injuries.
84
Windows and mirrorsE70848 E70850