2008 DODGE VIPER transmission

WARNING!
A hot exhaust system can start a fire if you park over
materials that can burn. Such materials might be
grass or leaves coming in contact with your exhaust
system. Do not park or operate your vehicle in areas
where your exhaust system can contact anything that
can burn.
In unusual situations involving grossly malfunctioning
engine operation, a scorching odor may indicate severe
and abnormal catalyst overheating. If this should occur,
safely bring the vehicle to a complete stop, shut the
engine off, and allow the vehicle to cool. Thereafter,
obtain service, including a tune-up to manufacturer's
specifications immediately.
To minimize the possibility of catalytic converter damage:
²Do not shut off the engine or interrupt the ignition
when the transmission is in gear and the vehicle is in
motion.
²Do not try to start the engine by pushing or towing the
vehicle.
²Do not idle the engine with any spark plug wires
disconnected or removed, such as when diagnostic
testing, or for prolonged periods during very rough
idling or malfunctioning operating conditions.
Ignition Wiring System and Ignition Timing
The ignition cables should be kept clean and the termi-
nals fully seated. Do not remove the nipple assemblies
from the coil towers. Cracked, damaged, or faulty cables
should be replaced. See your authorized dealer for ser-
vice.
MAINTAINING YOUR VEHICLE 205
7

Transmission
Transmission Fluid Level Check
Check the fluid in the transmission when performing
other underhood services.
Check the fluid level by removing the fill plug located on
the left side of the transmission. The fluid level should be
at the bottom of the fill hole. Add fluid, if necessary, to
maintain the proper level. Refer to the ªFluids, Lubri-
cants, and Genuine Partsº for the correct fluid type.
CAUTION!
Using a transmission fluid other than the manufac-
turer's recommended fluid may cause deterioration
in transmission shift quality and/or damage to the
transmission. Refer to the ªFluids, Lubricants, and
Genuine Partsº for the correct fluid type.
Change Transmission Fluid
Change the fluid at the intervals specified in the Main-
tenance Schedules in this manual. If contaminated with
water, change the fluid immediately. See your authorized
dealer for service.
Hydraulic Clutch
Master Cylinder Ð Clutch Fluid Level Check
Check the fluid in the clutch master cylinder when
performing underhood services.
Clean the top of the master cylinder area before removing
the cap. If necessary, add fluid to the reservoir.
Do Not Overfill. Overfilling can cause clutch release
problems as the clutch wears. A low fluid level may
indicate a leak, in which case, hydraulic clutch linkage
replacement may be required. The fluid level in the
reservoir will rise as the clutch wears - Do Not Remove
Fluid.
228 MAINTAINING YOUR VEHICLE

Chassis
Component Fluid, Lubricant, or Genuine Part
Transmission MopartATF+4 Automatic Transmission Fluid.
Rear Axle MopartSynthetic Gear and Axle Lubricant SAE 75W-140 or equivalent, with
Limited Slip Additive Friction Modifier
Brake Master Cylinder MopartBrake & Clutch Fluid DOT 4 Motor Vehicle or equivalent.
Power Steering Reservoir MopartPower Steering Fluid + 4, MopartATF+4 Automatic Transmission
Fluid.
MAINTAINING YOUR VEHICLE 253
7

At Each Stop for Fuel
²Check the engine oil level about 5 minutes after a fully
warmed engine is shut off. Checking the oil level while
the vehicle is on level ground will improve the accu-
racy of the oil level reading. Add oil only when the
level is at or below the ADD or MIN mark.
²Check the windshield washer solvent and add if
required.
Once a Month
²Check tire pressure and look for unusual wear or
damage.
²Inspect the battery, and clean and tighten the terminals
as required.
²Check the fluid levels of the coolant reservoir, brake
master cylinder, power steering, and transmission,
and add as needed.
²Check all lights and all other electrical items for correct
operation.
At Each Oil Change
²Change the engine oil filter.
²Inspect the exhaust system.
NOTE:Also, inspect the exhaust system if you notice a
change in the sound of the exhaust system, or if the
exhaust fumes can be detected inside the vehicle.
²Inspect the brake hoses.
²Inspect the suspension components.
²Lubricate door hinges and check springs.
²Check the engine coolant level, hoses, and clamps.
²Check power steering fluid level.
258 MAINTENANCE SCHEDULES
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S

Miles 3,000 6,000 9,000 12,000 15,000 18,000
(Kilometers) (5 000) (10 000) (15 000) (20 000) (25 000) (30 000)
Changeengine oilandengine oil filter,if not
replaced at 3 months.XXXXX X
Rotate the tires.LLXX X
Inspect and replace theair cleaner filterif
necessary.X
Inspect the transmission fluid. X
Inspect the brake linings. X
Change the rear axle fluid. X
Change the brake fluid. X
Lubricate the front and rear suspension ball
joints.X
260 SCHEDULE ªBº
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S

Miles 21,000 24,000 27,000 30,000 33,000 36,000
(Kilometers) (35 000) (40 000) (45 000) (50 000) (55 000) (60 000)
Changeengine oilandengine oil filter,if not
replaced at 3 months.XXXXX X
Rotate the tires.LLXX X
Inspect and replace theair cleaner filterif
necessary.X
Inspect and replace thePCV valveif neces-
sary.X
Change the transmission fluid. X
Inspect the transmission fluid.X
Inspect the brake linings. X X
Change the rear axle fluid. X X
Change the brake and clutch fluid. X
Change the brake fluid.X
Lubricate the front and rear suspension ball
joints.X
SCHEDULE ªBº 261
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S

Miles 39,000 42,000 45,000 48,000 51,000 54,000
(Kilometers) (65 000) (70 000) (75 000) (80 000) (85 000) (90 000)
Changeengine oilandengine oil filter,if not
replaced at 3 months.XXXXX X
Rotate the tires.LLXX X
Inspect and replace theengine air cleaner fil-
terif necessary.X
Inspect and replace the Auto Tension Drive
Belt if necessary.X
Change the transmission fluid. X
Inspect the brake linings. X
Change the rear axle fluid. X
Change the brake and clutch fluid. X
Lubricate the front and rear suspension ball
joints.X
262 SCHEDULE ªBº
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S

Miles 57,000 60,000 63,000 66,000 69,000 72,000
(Kilometers) (95 000) (100 000) (105 000) (110 000) (115 000) (120 000)
Changeengine oilandengine oil filter,if not re-
placed at 3 months.XXXXXX
Rotate the tires.LL
XXX
Inspect and replace theair cleaner filterif necessary.
X
Inspect and replace thePCV valveif necessary.
X
Flush and replace engine coolant at 60 months, if
not done at 102,000 miles.X
Inspect and replace the Auto Tension Drive Belt if
necessary. ³X
Inspect the transmission fluid.
X
Change the transmission fluid.X
Inspect the brake linings. X X
Change the rear axle fluid. X X
Change the brake fluid. X
Change the brake and clutch fluid.X
Lubricate the front and rear suspension ball joints. X
SCHEDULE ªBº 263
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S