2008 DODGE SPRINTER flat tire

[x] Cancel search: flat tire

Page 482 of 666

DODGE SPRINTER 2008 2.G Owners Manual 480 Practical hintsWhat to do if ...
5
Warning!
G
Each tire, including the spare (if provided), 
should be checked monthly when cold 
and inflated to the inflation pressure rec-
ommended by the vehicl

Page 496 of 666

DODGE SPRINTER 2008 2.G Owners Manual 494 Practical hintsDisplay messages
5
Tire pres.
Adjust pres.
The pressure is too low in one or more tires.
\1Check and correct tire inflation pressure 
as required.
Tire pres.
monitor
inoperative
The

Page 509 of 666

DODGE SPRINTER 2008 2.G Owners Manual 507 Practical hints
Display messages
5
C
Warning
Tire defect
One or more tires are deflating.
The respective tire is shown in the multifunc-
tion display.
\1Carefully bring the vehicle to a halt, avoi

Page 519 of 666

DODGE SPRINTER 2008 2.G Owners Manual 517 Practical hints
Where will I find...?
5
\1
Remove jack
4
 upward out of the 
retainer.
If you are replacing the tires on the vehi-
cle, you may use the spare wheel as a 
road wheel provided that:

Page 549 of 666

DODGE SPRINTER 2008 2.G Owners Manual 547 Practical hints
Flat tire
5
\3 Flat tireThe vehicle is either equipped with a 
spare wheel or the Premium tire seal-
ant*.
The spare wheel is located under the 
rear end of the vehicle if the vehi

Page 550 of 666

DODGE SPRINTER 2008 2.G Owners Manual 548 Practical hintsFlat tire
5
\1
Park the vehicle as far away as pos-
sible from traffic and on a level, firm, 
and non-slip surface.
\1
Switch on the hazard warning lamps.
\1
Apply the handbrake.
\1

Page 551 of 666

DODGE SPRINTER 2008 2.G Owners Manual 549 Practical hints
Flat tire
5
Preparing the vehiclePrepare the vehicle as described 
(\2
page 548).
\1
Prevent the vehicle from rolling away 
using chocks or similar.On a level road:
\1
Place the ch

Page 552 of 666

DODGE SPRINTER 2008 2.G Owners Manual 550 Practical hintsFlat tire
5
Hydraulic jack
\1
Assemble the three-part pump lever 
for the jack.
 1Pressure release screw\1
Close pressure release screw
1
.
\1
To do this, turn the flattened section