2008 DODGE SPRINTER change wheel

547 Practical hints
Flat tire
5
\3 Flat tireThe vehicle is either equipped with a
spare wheel or the Premium tire seal-
ant*.
The spare wheel is located under the
rear end of the vehicle if the vehicle is
not equipped with Premium tire sealant*
(\2
page 517).When you replace a tire, the manufactur-
er also recommends that you replace
the tire valve.
Warning
G
Defective or worn tires, and tire pressures
that are either too high or too low, can
cause significant changes in the vehicle’s
handling and braking characteristics.
There is an increased risk of an accident.
Replace the tires, including the spare tire,
at least every 6 years, regardless of the
degree of treadwear. Check the tire pres-
sure on the spare wheel at regular inter-
vals.
!
CAUTION
For safety reasons, the following tire
valves from the company Schrader
must be used on the vehicles:
\4
TR 600 for vehicle model type
2500
\4
TR 418 for vehicle model type
3500
nf_BA.book Page 547 Friday, January 25, 2008 3:53 PM

549 Practical hints
Flat tire
5
Preparing the vehiclePrepare the vehicle as described
(\2
page 548).
\1
Prevent the vehicle from rolling away
using chocks or similar.On a level road:
\1
Place the chocks in front of and be-
hind the wheel diagonally opposite
to the wheel that is to be changed.
\1
Take the vehicle tool kit and the jack
from the footwell on the passenger’s
side (
\2
page 515).
\1
Remove the spare wheel from the
spare wheel bracket (
\2
page 517).
\1
For wheels with wheel bolts remove
the wheel cover.
Wheel with wheel bolts\1
Loosen the wheel bolts and nuts on
the wheel you wish to change about
one turn. Do not remove them.
As an extension for the wheel
wrench, use the shaft from the jack’s
3-part pump lever that has the larg-
est diameter.
Warning
G
The vehicle could slip off the jack on uphill
and downhill gradients.
To avoid the risk of causing serious or fa-
tal injury, or damage to the vehicle, do not
change wheels on uphill and downhill gra-
dients.
N40.10-2162-31
nf_BA.book Page 549 Friday, January 25, 2008 3:53 PM

553 Practical hints
Flat tire
5
\1
Push the wheel onto the wheel hub
and press it on.
Wheels with centering by wheel bolts:
\1
Screw in the wheel bolts and tighten
them finger-tight.
1Wheel bolt for light-alloy wheel
2Wheel bolt for steel wheelor wheels wit h whe el n uts :
!
CAUTION
If your vehicle is equipped with the
tire pressure monitor, each wheel
has an electronic component.
Tire mounting tools should not be ap-
plied in the area of the valve, as this
could damage the electronic compo-
nents.
Have the tires changed only at an
authorized Sprinter Dealer.
Warning
G
Do not tighten the wheel bolts and wheel
nuts completely while the vehicle is still
jacked up. The vehicle could tip.
iOn vehicles with light-alloy wheels,
you will find short wheel bolts suit-
able for the steel spare wheel in the
vehicle tool kit.N40.10-2175-31
nf_BA.book Page 553 Friday, January 25, 2008 3:53 PM