2008 DODGE SPRINTER wheel

464 Practical hintsWhat to do if ...
5
6
When towing a trailer:
The red brake system indicator
lamp is lit while the engine is run-
ning.
A signal also sounds.
WAR NING
G
The trailer's brake booster is malfunctioning.
The vehicle's driving and braking characteris-
tics may change. There is a risk of the trailer
overbraking.
\1Also observe the messages in the dis-
play on vehicles with steering wheel
buttons (\2page 489).
\1S t o p y o u r v e h i c l e a s s o o n a s i t i s s a f e t o
do so.
\1Do not drive any further.
\1Consult an authorized Sprinter Dealer.
Problem
Possible cause / result
Suggested solutions
nf_BA.book Page 464 Friday, January 25, 2008 3:53 PM

466 Practical hintsWhat to do if ...
5
-
The yellow ABS indicator
lamp is lit while the engine is
running.
WA RNING
G
ABS has been deactivated due to a malfunction.
ESP
®, ASR and BAS as well as cruise control have
also been deactivated as a result.
The brake system continues to function with the nor-
mal braking effect but with no electronic support.
The wheels could therefore lock up, for example if
the brakes are applied with maximum force.
\1Also observe the messages in the dis-
play on vehicles with steering wheel
buttons (\2page 489).
\1Continue driving, but with even greater
care.
\1Have the system checked at an autho-
rized Sprinter Dealer as soon as possi-
ble.
WA RNING
G
ABS is temporarily unavailable.
Self diagnosis may not have been completed yet.
The brake system is still available with the normal
braking effect.
\1Drive on for a distance of more than
13 mph (20 km / h).
ABS is available again if the message
goes out.
Problem
Possible cause / result
Suggested solutions
nf_BA.book Page 466 Friday, January 25, 2008 3:53 PM

467 Practical hints
What to do if ...
5

ABS has been deactivated due to undervoltage.
The battery may not be being charged.
The brake system continues to function with the nor-
mal braking effect but with no electronic support.
The wheels could therefore lock up, for example if
the brakes are applied with maximum force.
\1Continue driving, but with even greater
care.
\1Have the system checked at an autho-
rized Sprinter Dealer as soon as possi-
ble.
Problem
Possible cause / result
Suggested solutions
nf_BA.book Page 467 Friday, January 25, 2008 3:53 PM

468 Practical hintsWhat to do if ...
5
#
The yellow ESP
® indicator
lamp is lit while the engine is
running.
WA RNING
G
ESP
® has been deactivated due to a malfunction.
Cruise control is also switched off as a result.
Vehicle stability is no longer automatically controlled
in good time.
Engine power output may be reduced.
\1Also observe the messages in the dis-
play on vehicles with steering wheel
buttons (\2page 489).
\1Continue driving, but with even greater
care.
\1Have the system checked at an autho-
rized Sprinter Dealer as soon as possi-
ble.
ESP
® has been deactivated due to undervoltage.
The battery may not be being charged.
Vehicle stability is no longer automatically controlled
in good time.
Engine power output may be reduced.
\1Continue driving, but with even greater
care.
\1Have the system checked at an autho-
rized Sprinter Dealer as soon as possi-
ble.
Problem
Possible cause / result
Suggested solutions
nf_BA.book Page 468 Friday, January 25, 2008 3:53 PM

481 Practical hints
What to do if ...
5
Warning (Continued)
G
USA only: Your vehicle has also been
equipped with a TPMS malfunction indicator
to indicate when the system is not operating
properly. The TPMS malfunction indicator is
combined with the low tire pressure telltale.
When the system detects a malfunction, the
telltale will flash for approximately 1 minute
and then remain continuously illuminated.
This sequence will continue upon subsequent
vehicle start-ups as long as the malfunction
exists. When the malfunction indicator is illu-
minated, the system may not be able to de-
tect or signal low tire pressure as intended.
Continued
Warning (Continued)
G
TPMS malfunctions may occur for a vari-
ety of reasons, including the installation
of incompatible replacement or alternate
tires or wheels on the vehicle that prevent
the TPMS from functioning properly. Al-
ways check the TPMS malfunction telltale
after replacing one or more tires or
wheels on your vehicle to ensure that the
replacement or alternate tires and wheels
allow the TPMS to continue to function
properly.
nf_BA.book Page 481 Friday, January 25, 2008 3:53 PM

484 Practical hintsDisplay messages
5
Warnings, malfunctions or additional in-
formation may also be shown in the dis-
play. The following table shows
messages which could appear in the dis-
play.
Certain messages are accompanied by a
warning signal or a permanent tone.
iAll warning / indicator lamps (except
the turn signal indicator lamps) and
the display are activated when the ig-
nition is switched on.
Please check that they are working
properly before commencing a jour-
ney.
Display messages on vehicles
without steering wheel buttons
Warning
G
No messages can be displayed if there is
a failure of the instrument cluster and / or
the display. You will not then be able to
see information about the vehicle status,
such as speed and outside temperature,
warning and indicator lamps, malfunction
and warning messages or the failure of
systems. Handling characteristics may be
affected.
Continued
nf_BA.book Page 484 Friday, January 25, 2008 3:53 PM

487 Practical hints
Display messages
5
NOThe message is displayed for 30 seconds.TPMSThe message is also displayed after
30 seconds.
The TPMS is malfunctioning.
\1Have the TPMS checked at an autho-
rized Sprinter Dealer as soon as possi-
ble.
The tire pressure monitor is not receiving sig-
nals from one or more wheels because:
\4a wheel was replaced with the spare
wheel, which is not equipped with a wheel
electronics unit
\4the maximum temperature in one of the
wheel electronics units has been exceed-
ed
\4one of the wheel electronics units is mal-
functioning
\1Have wheels with wheel electronics
units mounted at an authorized Sprint-
er Dealer.
Display messages
Possible cause / result
Possible solution
nf_BA.book Page 487 Friday, January 25, 2008 3:53 PM

489 Practical hints
Display messages
5
The operating system shows warnings,
malfunctions or additional information in
the display.
Certain messages are accompanied by a
warning signal or a permanent tone.
High-priority messages are highlighted
in red in the display.
Please respond in accordance with the
messages and follow the additional
notes in these Operating instructions.
\4
Low-priority messages can be ac-
knowledged using the
è
, ·
,
j
or
k
buttons on the steer-
ing wheel or using the reset button
on the instrument cluster
(
\2
page 142). They are then stored
in the malfunction memory.
\4
Highest-priority messages cannot be
acknowledged and are automatically
stored in the malfunction memory.
If you select the Malfunction memory
menu in the operating system
(
\2
page 160), the acknowledged and
unacknowledged messages will appear.
Display messages on vehicles with
steering wheel buttons
Warning
G
No messages can be displayed if there is
a failure of the instrument cluster and / or
the display. You will not then be able to
see information about the vehicle status,
such as speed and outside temperature,
warning and indicator lamps, malfunction
and warning messages or the failure of
systems. Handling characteristics may be
affected.
Continued
nf_BA.book Page 489 Friday, January 25, 2008 3:53 PM