2008 DODGE SPRINTER ECU

60 SafetyOccupant safety
2
The use of infant or child restraints is re-
quired by law in all 50 states, the District
of Columbia, the U.S. territories and all
Canadian provinces.
Infants and small children should be
seated in an appropriate infant or child
restraint system properly secured by a
lap / shoulder belt or, if so equipped, a
top tether anchorage point and a child
restraint lower anchorage system that
complies with U.S. Federal Motor Vehi-
cle Safety Standards 213 and 225 and
Canadian Motor Vehicle Safety Standard
213 and 210.2.A statement by the child restraint manu-
facturer of compliance with this stan-
dard can be found on the instruction
label on the restraint and in the instruc-
tion manual provided with the restraint.
When using any infant or child restraint
system, make sure to carefully read and
follow all manufacturer’s instructions for
installation and use.
Please read and observe warning labels
affixed to inside of vehicle and to infant
or child restraints.
Passenger sun visor with warning sticker
nf_BA.book Page 60 Friday, January 25, 2008 3:53 PM

61 Safety
Occupant safety
2
Warning symbol for rearward-facing child
seat
ISOFIX child seat securing system/
Child seat anchors - LATCH typeISOFIX is a standardized securing sys-
tem on the rear seats for special LATCH
(Lower
Anchors and
Tethers for
Ch
il-
dren) child restraint systems with
matching mounting fittings.
The LATCH type anchors for child re-
straint systems are installed between
the seat cushion and the backrest:
\4
on the outside left and right on nar-
row rear bench seats with 3 seats
\4
on the outside left on rear bench
seats with 2 seats
N00.00-2620-31
iNon-LATCH type child seats may also
be used and can installed using the
vehicle’s seat belt system. Install
child seat according to manufactur-
er’s instructions.
nf_BA.book Page 61 Friday, January 25, 2008 3:53 PM

62 SafetyOccupant safety
2
Warning
G
A LATCH type child restraint system that
has been secured using the ISOFIX child
seat securing system is unable to provide
adequate protection for children who
weigh more than 48 lbs (22 kg). For this
reason, only secure children weighing
less than 48 lbs (22 kg) in a LATCH type
child restraint system secured using the
ISOFIX child seat securing system. If the
child weighs more than 48 lbs (22 kg),
you should secure the LATCH type child
restraint system with a lap-shoulder belt.
Warning
G
If the child restraint system has not been
installed correctly on a suitable vehicle
seat, the child cannot be restrained in the
event of an accident or sudden braking
and could be seriously or fatally injured.
You must therefore observe the installa-
tion instructions issued by the child re-
straint system manufacturer when
installing a child restraint system.
Continued
Warning (Continued)
G
On the rear bench seat, only use LATCH
type child restraint systems with ISOFIX
child seat mountings that have been rec-
ommended by the manufacturer.An incorrectly installed child restraint sys-
tem could come loose and the child or
other vehicle occupants could be fatally
injured. You must therefore make sure
that the child restraint system is engaged
in the securing rings on the left and right-
hand sides after it has been installed.
nf_BA.book Page 62 Friday, January 25, 2008 3:53 PM

63 Safety
Occupant safety
2
1Securing rings - LATCH type anchors
Warning
G
If the child restraint system or its securing
system, for example the ISOFIX child seat
securing system, are damaged or have
been subjected to a load in an accident,
the child secured in it could suffer severe
or fatal injuries in the event of an acci-
dent, heavy braking or a sudden change
of direction.
Continued
Warning (Continued)
G
For this reason, have restraint systems
and their mountings checked immediately
and replaced if necessary at a qualified
specialist workshop which has the neces-
sary specialist knowledge and tools to
carry out the work required if they are
damaged or have been subjected to a
load in an accident.The manufacturer recommends that you
use an authorized Sprinter Dealer for this
purpose. In particular, work relevant to
safety or on safety-related systems must
be carried out at a qualified specialist
workshop.
!
CAUTION
Take care not to trap the seat belt on
the middle seat when you install the
child restraint system.
nf_BA.book Page 63 Friday, January 25, 2008 3:53 PM

64 SafetyOccupant safety
2
TopTetherThe TopTether anchorages are on the
feet of the rear bench seat.1Head restraints
2TopTether anchorages
Warning
G
Do not leave children unsupervised in the
vehicle, even if they are secured by a child
restraint system. The children could:
\4injure themselves on parts of the ve-
hicle
\4be seriously or even fatally injured by
prolonged exposure to extreme heat
or cold
Warning
G
Do not expose child restraint systems to
direct sunlight. Metallic parts of the child
restraint system could heat up, for exam-
ple, and the child could burn him / herself
on the hot parts.
If the children open a door, they could:
\4cause injury to others as a result
\4
get out of the vehicle and could either in-
jure themselves when doing so or they
could be injured by passing vehicles
\4sustain serious injuries if they were to
fall out of the vehicle, due in particular
to the height of the passenger com-
partment from the ground
nf_BA.book Page 64 Friday, January 25, 2008 3:53 PM

85 Controls in detail
Opening and closing
3
Remote control with key
1 To unlock the sliding doors and
rear doors and opens or closes the elec-
tric sliding door*
2ΠUnlocking button
3‹ Locking button
4Release button for mechanical key
5Battery check lamp.
Warning
G
Do not leave children unsupervised in the
vehicle, even if they are secured by a child
restraint system.The children could:injure themselves on parts of the vehicleunlock the door on vehicles with an elec-
tric sliding door by pressing the central
locking button, and then open the doors
and thereby injure other persons
Continued
Warning (Continued)
G
get out of the vehicle and could either in-
jure themselves when doing so or they
could be injured by passing vehiclesbe severely or even fatally injured by pro-
longed exposure to intense heat
!Do not expose the key to high levels
of electromagnetic radiation, other-
wise this may interfere with the func-
tions of the key.
Protect the key from moisture to pre-
vent malfunctions.
nf_BA.book Page 85 Friday, January 25, 2008 3:53 PM

104 Controls in detailOpening and closing
3
\1To close:
make sure that the left-
hand rear door is closed.
\1
Pull the right-hand rear door firmly
closed by the door handle.
\1To lock:
slide catch
2
to the right.
Only the rear door is locked.
The white marking is no longer visi-
ble.
Using the central locking switch, you
can centrally lock or unlock from the in-
side either the entire vehicle or the slid-
ing doors and rear doors only.The central locking switch is located on
the center console.
Locking and unlocking centrally
from the inside
Warning
G
Do not leave children unsupervised in the
vehicle, even if they are secured by a child
restraint system. The children could:\4injure themselves on parts of the
vehicle\4be severely or even fatally injured by
prolonged exposure to intense heat\4If the children open a door, they could:\4cause injury to others as a result
Continued
Warning (Continued)
G
\4get out of the vehicle and could either
injure themselves when doing so or
they could be injured by passing
vehicles\4sustain serious injuries if they were to
fall out of the vehicle, due in particular
to the height of the passenger com-
partment from the ground
nf_BA.book Page 104 Friday, January 25, 2008 3:53 PM

124 Controls in detailSeats
3
\1
Remove key
1
from partition sliding
door.
\1
Fold seat cushion
2
down or up.
The seat cushion is held in the rele-
vant position.
Warning
G
When folding down the seat cushion, make
sure that nobody can become trapped.The Warning to the co-driver is increased
in the event of sudden steering move-
ments or an accident if there is a key in-
serted in the partition sliding door lock.Remove the key from the partition sliding
door before using the folding seat.
Rear bench seatWarning
G
All release levers on the legs of the rear
bench seat must be parallel to the vehicle
floor. A rear bench seat with 2 seats may
only be installed left-sided.You can obtain information from any au-
thorized Sprinter Dealer.
Continued
Warning (Continued)
G
The integrated seat belt can only offer the
degree of protection for which it is de-
signed if you install the specified rear
bench seats correctly. Therefore, you
must have the rear bench seat with four
seats installed only by a qualified special-
ist workshop, e.g., an authorized Sprinter
Dealer.Keep the seat bench mounting cups in the
vehicle floor free from dirt and foreign ob-
jects. This is the only way to guarantee
that the locking mechanisms will engage
securely.
Continued
nf_BA.book Page 124 Friday, January 25, 2008 3:53 PM