2008 Citroen C8 DAG fuel
[x] Cancel search: fuelPage 1 of 194
4 I
IN BRIEF
E X T E R I O R
Parking assistance
Audible and/or visual front parking
assistance. 64
2 buttons
Pull the handle of
the sliding door to
trigger its electrical
opening. 4 buttons
A press on either of
the buttons allows
you to electrically
open the corres-
ponding sliding
door. F u e l l a p o p e n
W i t h t h e f u e l l a p
open during refuel-
ling, a safety sys-
tem restricts the
opening of the sli-
ding door.
16
122
Right-
hand
door
Left-
hand
door
Page 23 of 194
2 II
3-PART INSTRUMENT PANEL
BIG SCREEN INSTRUMENT
PANEL
Speed
indicator NaviDrive
MULTIFUNCTION DISPLAY Rev counter
(In the period of running-in, see “Running-in”.)
Coolant temperature warning
lamp
Coolant temperature gaugeFuel
gauge
Low fuel level
warning C E N T R A L I N S T R U M E N T P A N E L
Coolant temperature
gauge
Coolant temperature
warning lamp
Low fuel level warning
Rev counter
(In the period of running-
in, see “Running-in”.)Speed
indicator Fuel
gauge
MULTIFUNCTION DISPLAY
Page 24 of 194
2
II
Coolant temperature gauge
With the needle or indicator in zone A, the temperature
is correct.
If the needle or indicator enters zone B, the temperature
is too high. The central STOP a l e r t w a r n i n g l a m p a n d
t h e e n g i n e c o o l a n t l e v e l o r t e m p e r a t u r e w a r n i n g l a m p
both light up, accompanied by an audible signal and a
message on the multifunction screen.
It is essential to stop the vehicle. 1 - Low fuel level
warning
I f t h e w a r n i n g l a m p c o m e s
on, accompanied by a mes-
sage on the MULTIFUNC-
TION DISPLAY, you still
h a v e f u e l s u f i c i e n t f o r a p -
prox. 30 miles.
I f i t l a s h e s , t h i s i n d i c a t e s
a malfunctioning of the fuel
gauge.
Consult your CITROËN
dealer.
2 - Coolant temperature warning lamp
T h e S T O P w a r n i n g l a m p
l a s h e s w h e n t h e c o o l a n t
t e m p e r a t u r e w a r n i n g l a m p
is lit.
T h e l i g h t i n g o f t h i s w a r n i n g
lamp is accompanied by an
audible signal and a mes-
sage on the MULTIFUNC-
TION DISPLAY.
It is essential to stop the vehicle, contact a CITROËN
dealer. 3-part instrument
panel
Big screen
instrument panel
Engine coolant level too low
E n g i n e c o o l a n t l e v e l t o o l o w i s i n d i c a t e d b y a n a u d i b l e
signal and a message on the MULTIFUNCTION
DISPLAY.
Big screen instrument
panel
3-part
instrument panel C E N T R A L I N S T R U M E N T P A N E L
Page 30 of 194
35
II
M U L T I F U N C T I O N D I S P L A Y
D i s p l a y C
To adjust the date and the time:
- Press on
A.
- Use B to select the icon
“ P e r s o n a l i s a t i o n - C o n i g u r a t i o n ”
t h e n c o n i r m y o u r c h o i c e w i t h a
press on C.
- S e l e c t t h e d i s p l a y c o n i g u r a t i o n using B . C o n i r m w i t h a p r e s s
on C.
- Select the date and time adjustment, using B, then
c o n i r m w i t h a p r e s s o n C.
- Use B to select the values to be
m o d i i e d . C o n i r m w i t h a p r e s s
on C.
- Make your adjustments using B,
v a l i d a t i n g e a c h a d j u s t m e n t w i t h
a press on C.
- Validate on “OK” on the display. To choose units:
- Press on
A.
- Use B to select the icon
“ P e r s o n a l i s a t i o n - C o n i g u r a t i o n ”
t h e n c o n i r m y o u r c h o i c e w i t h a
press on C.
- S e l e c t t h e d i s p l a y c o n i g u r a t i o n using B . C o n i r m w i t h a p r e s s
on C.
- Then select the sub-menu for U n i t s . C o n i r m w i t h a p r e s s
on C.
- Using B, select the unit to
b e m o d i i e d ( T e m p e r a t u r e o r
C o n s u m p t i o n ) t h e n v a l i d a t e w i t h
a press on C.
- Validate on “OK” on the display.
Note: This choice concerns all
the types of information (fuel
consumption, speed, etc.) that
appear on the displays.
To choose the language:
- Press on A.
- Use B to select the icon
“ P e r s o n a l i s a t i o n - C o n i g u r a t i o n ”
t h e n c o n i r m y o u r c h o i c e w i t h a
press on C.
- Select the choice of language, using B.
- Using B, select the desired
language and validate your
c h o i c e w i t h a p r e s s o n C.
- Validate on “OK” on the display.
To adjust the display
brightness:
- Press on
A.
- Use B to select the icon
“ P e r s o n a l i s a t i o n - C o n i g u r a t i o n ”
t h e n c o n i r m y o u r c h o i c e w i t h a
press on C.
- S e l e c t t h e d i s p l a y c o n i g u r a t i o n using B . C o n i r m w i t h a p r e s s
on C.
- Select the adjustment of b r i g h t n e s s . C o n i r m w i t h a p r e s s
on C.
- Use B to select normal or other
display mode, then validate
w i t h a p r e s s o n C. To adjust
the brightness, select the
symbols “+” or “-” a n d c o n i r m
y o u r a d j u s t m e n t w i t h a p r e s s
on C.
- Validate on “OK” on the display.
Page 31 of 194
3 II
NaviDrive display
Display C
T R I P C O M P U T E R
Range
This indicates the mileage that can still be travelled
using the fuel remaining in the tank.
When the distance remaining to be travelled is less
than around 30 km (approx. 20 miles), only three
dashes are visible.
Instantaneous fuel consumption
This is calculated from consumption over the previous
2 s e c o n d s . T h i s f u n c t i o n i s o n l y a v a i l a b l e w h e n
travelling at over 30 km/h (approx. 20 mph).
Distance travelled
It indicates the distance travelled since the trip computer
w a s l a s t r e s e t t o z e r o .
Average fuel consumption
The average fuel consumption is calculated from the
last reset of the computer.
Average speed
The average speed is obtained, from the last reset of
the computer, by dividing the distance covered by the
time taken (ignition on).
Distance remaining to be travelled
To enter it, see Multifunction display.
Page 33 of 194
3 II
NaviDrive display
Display C
T R I P C O M P U T E R
Range
This indicates the mileage that can still be travelled
using the fuel remaining in the tank.
When the distance remaining to be travelled is less
than around 30 km (approx. 20 miles), only three
dashes are visible.
Instantaneous fuel consumption
This is calculated from consumption over the previous
2 s e c o n d s . T h i s f u n c t i o n i s o n l y a v a i l a b l e w h e n
travelling at over 30 km/h (approx. 20 mph).
Distance travelled
It indicates the distance travelled since the trip computer
w a s l a s t r e s e t t o z e r o .
Average fuel consumption
The average fuel consumption is calculated from the
last reset of the computer.
Average speed
The average speed is obtained, from the last reset of
the computer, by dividing the distance covered by the
time taken (ignition on).
Distance remaining to be travelled
To enter it, see Multifunction display.
Page 34 of 194
37
II
Displays C and NaviDrive
The trip computer gives access to 3 types of instantaneous informat ion:
- Range
- Instantaneous consumption
- Distance remaining to be travelled.
I t a l s o g i v e s y o u a c c e s s t o 3 t y p e s o f i n f o r m a t i o n f o r t w o J o u r n e y s 1 a n d 2 :
- Distance travelled
- Average consumption
- Average speed.
The journeys
J o u r n e y s 1 a n d 2 a r e i d e n t i c a l b u t i n d e p e n d e n t o f e a c h o t h e r . F o r e x a m p l e ,
y o u c a n u s e J o u r n e y 1 f o r d a i l y c a l c u l a t i o n s a n d J o u r n e y 2 f o r m o n t h l y
calculations.
To reset a journey to zero
When the desired journey is displayed, give a long press on th e end of the
w i p e r s t a l k .
To select the different types of
i n f o r m a t i o n a n d d i s p l a y s , b r i e l y
p r e s s t h e e n d o f t h e w i n d s c r e e n
w i p e r c o n t r o l .
To reset trip computer informa-
tion to zero
, press continuously
f o r a f e w s e c o n d s o n t h e e n d o f
t h e s t a l k w h e n o n e o f t h e i n f o r m a -
tion types is displayed.
- Distance travelled.
- Average fuel consumption.
- Average speed.
A press on the “ MODE” button
brings up a permanent display of
the trip computer information. T R I P C O M P U T E R
Page 35 of 194
3 II
NaviDrive display
Display C
T R I P C O M P U T E R
Range
This indicates the mileage that can still be travelled
using the fuel remaining in the tank.
When the distance remaining to be travelled is less
than around 30 km (approx. 20 miles), only three
dashes are visible.
Instantaneous fuel consumption
This is calculated from consumption over the previous
2 s e c o n d s . T h i s f u n c t i o n i s o n l y a v a i l a b l e w h e n
travelling at over 30 km/h (approx. 20 mph).
Distance travelled
It indicates the distance travelled since the trip computer
w a s l a s t r e s e t t o z e r o .
Average fuel consumption
The average fuel consumption is calculated from the
last reset of the computer.
Average speed
The average speed is obtained, from the last reset of
the computer, by dividing the distance covered by the
time taken (ignition on).
Distance remaining to be travelled
To enter it, see Multifunction display.