2008 Citroen C8 DAG seat

49
II
W I N D O W S
ALWAYS PAY ATTENTION TO WHERE CHILDREN ARE WHEN OPENING OR CLOSING WINDOWS.
- Always remove the ignition key when leaving the vehicle, even for
short periods.
- If the driver is operating the passenger’s electric window con trol, the
driver should ensure that no passenger is obstructing the window from
closing.
- The driver should check that the electric windows are used prop erly by
the passengers.
- Should there be any risk of a person becoming trapped by a wi ndow
closing, you should immediately reverse the window movement. To d o
this, reverse the position of the control concerned.
Child safety precaution
The electrical security is operated
by pressing the control located on
the electric windows control panel.
This deactivates movement of the
rear electric windows, sliding side
doors and second and third row
sun roofs.
Doors can still be opened from the
outside and controlled electrically
from the front seat position.
Note:
the electric windows can
also be operated for a limited
time after the ignition has been
switched off (including after the
front doors have been opened).
Closing and opening of the win -
dows using the remote control :
see “Remote control”.
Security windows with
restricted opening
To open the quarter window, pull
the lever and push the glass.
To close, pull and press the lever
to lock it.

77
III
9 - Visibility programme (max button)
To demist or defrost the windows rapidly (hu
-
midity, no. of passengers, frosty weather), the
“AUTO” programme may not be suficient.
10 - Adjustment of rear ventilation (REAR) or
equalisation of the adjustments of 3
and 4 to those made with the control
on the driver’s side (MONO)
Press the button, the ventilation symbol ap -
pears on the display. 11 - Adjusting the low of air to the rear
seat positions (sliding side door pillars
on right hand side and left hand side)
Then select the visibility programme by pressing the
“MAX” button.
The visibility programme warning lamp lights up.
This activates the air conditioning, the low of air and
the defrosting of the rear screen, for optimum sharing
of the ventilation between windscreen and side win -
dows. It deactivates the air recycling.
The air low adjustment thumbwheels for the 2nd row
lateral air vents are operational.
To deactivate the rear ventilation commands, press the
button again, the rear ventilation symbol goes out. If button
10 has been actioned, these thumbwheels
allow the 2nd row passengers to adjust their air low.
+/-: increase or decrease in air low.
AUTO: control of adjustments by front passengers.
0: stop.
12 - Demisting - Defrosting
While it is operating, the warning lamp lights
and the symbol appears on the display.
This control is for rapid defrosting or demisting of the
rear screen, it acts automatically on the low of air, the
distribution of air, the air conditioning and the entry o f
air.
To switch it off, give another press either on the same
button or on the “AUTO” button.
A U T O M A T I C A I R C O N D I T I O N I N G

A
4 III
Lateral blinds
Lateral blinds are available for the
2nd and/or 3rd row rear seat po -
sitions.
In the 2nd row:
Pull the lateral blind by the tabs.
To avoid damaging the blind when
opening the door, check that the
two tabs are correctly secured.
In the 3rd row:
Position the corresponding hook
in the location A. Oddments pocket (Big screen
instrument panel)
Front seat drawers
A storage drawer is positioned
beneath each front seat. Lift and
pull forwards.
I N T E R I O R C O M F O R T

 III
To reactivate the front
passenger’s airbag
Do not forget to reactivate the air-
bag function; to do that, with igni -
tion switched off:
- Insert and turn the key to the “ON” position, the airbag is
activated.
The warning lamp in the instru -
ment panel comes on for a few
seconds when you switch the igni -
tion on.
The front passenger’s airbag can
be deactivated. Passenger’s airbag
deactivation
In order to be able to use a “rear-
facing” child seat in the front pas
-
senger position, it is essential to
deactivate the passenger airbag.
- With the ignition switched off, insert the ignition key into the
control switch A.
- Turn the key to the “OFF”
position, the passenger airbag is
then deactivated.
The front passenger airbag deac -
tivation warning lamp in the instru -
ment panel lights up (ignition on).
On switching on the ignition, a
message on the multifunction dis -
play reminds you that the passen -
ger’s airbag is deactivated.
In the front passenger’s seat position,
it is essential to deactivate the front passenger’s airbag
whenever a “rear-facing” child seat is installed there.
Otherwise the child risks being killed or seriously i njured
should the airbag deploy.
A I R B A G S

7
III
CHILD SEATS secured by means of the vehicle seat belt
In conformity with Directive 2000/3, the table below tells
you to what ex-
tent each of the seat positions in your vehicle may take a chil d seat that
is secured by means of the vehicle seat belt and approved as “Uni versal”
depending on the weight of the child.
U : Seat position suitable for installation of a unive rsal rear-facing child seat and a universal forward -facing child seat
L- : Only the child seats indicated can be installed in the seat position concerned (depending on destinat ion). Consult the
section “User Precautions”, chapter on “Child Safet y” at the end of the handbook.
X : Seat position not suitable for installation of a c hild seat of the weight group indicated.
(a) If you are installing a “rear-facing” child sea t in the front passenger’s seat position, it is essential to deactivate the front
passenger’s airbag.
Before installing your child in the front passenger’s seat posi tion, consult the legislation in force in your country on
the carrying of children in this position.
Seat Weight of childUp to 10 kg /
Up to 13 kg
(groups 0 and 0+)9 - 18 kg
(group 1) 15 - 25 kg
(group 2) 22 - 36 kg
(group 3)
1st row Front passenger seat (a)
U U U U
2nd row Lateral seat
U U U U
Central seat U U U U
3rd row Lateral seat
Lateral seat row 2 or 3 L1 L4 L2, L3, L4 L2, L3, L4
Lateral seat
Central seat row 2 U U U U
Lateral seat
Rear 3-seater bench L1 L4 L2, L3, L4 L2, L3, L4
Central seat
Rear 3-seater bench X X
L2, L3, L4 L2, L3, L4
C H I L D R E S T R A I N T S
Consult the section “User Precau-
tions”, chapter on “Child Safety” at
the end of the handbook, to ensure
that you install your child in condi-
tions of maximum safety.

 III
Take care to comply with the itting instructions
given in the child seat manufacturer’s user guide.
ISOFIX anchorages and the
ISOFIX ixing system
The rear seat positions in your
vehicle are equipped with ISOFIX
anchorages.
These consist of 2 rings situated
between the backrest and the seat
cushion, approx. 28 cm apart.
ISOFIX child seats have 2 latches
which are easy to attach on these
rings.
This ixing system is intended for
children weighing up to 18 kg.
An incorrect installation of a child
seat in a vehicle compromises the
protection of the child in the event
of a collision. The ISOFIX system
guarantees you a convenient, so
-
lid and reliable ixing for your child
seat in your vehicle. The ISOFIX child seats approved for use in your vehicle are : the
ISOFIX
KIDDY and the ISOFIX RÖMER Duo (1).
They are sold by the CITROËN network.
ISOFIX KIDDY
It can be installed “rear-facing” from birth to 13 kg and “forward -facing”
from 9 to 18 kg.
Advice for the installation of your ISOFIX KIDDY child sea t:
In the 2nd row, the vehicle seat should be slid as far back as possible and :- in the “rear-facing” position, the shell of the seat should be in contact with
the backrest of the corresponding front seat.
- in the “forward-facing” position, the corresponding front seat should be
adjusted to an intermediate fore/aft position, backrest uprig ht.
The speciic ISOFIX KIDDY child seat must not be installed in an y of the
3rd row rear seat positions.
ISOFIX RÖMER Duo Il
It can only be installed “forward-facing”, for children from 9 to 18 kg.
Advice for installation of your ISOFIX RÖMER Duo child seat:
Use of the top belt, also called Top Tether, is not nece ssary. When the seat
is installed in the rear of the vehicle, the corresponding fro nt seat should
be adjusted so that the feet of the child are not touchi ng the backrest of
the front seat.
These child seats can also be installed in seat positions tha t do not have
ISOFIX ixings. In this case, they must be secured to the vehicle sea t by
means of the vehicle seat belt.
(1) On the ISOFIX anchorages in your vehicle, you may ix only the
ISOFIX child seats that are approved for your vehicle.
C H I L D R E S T R A I N T S

1
2
5
6
7
4
3
90 III
Manual adjustments
Head restraint
To raise or lower it, pull it towards the
front and simultaneously slide it.
The adjustment is correct if the top
edge of the head restraint is level with
the top of the head.
Its angle can also be adjusted.
To remove it, bring it to the high position, raise the
tab with the aid of a coin and at the same time pull it
forwards and upwards.
Note: Never drive the vehicle without the head res -
traints itted.
Rotating the seats: it is forbidden to rotate the seat, or to use the seat in its rearward facing coniguration, when the vehicle is in motion.
Lumbar support
Turn the control and adjust to the desi
-
red position.
Rotating the seats
With the vehicle stopped, parking bra -
ke applied:
- return the backrest to the fully upright position,
- place the seat in an intermediate
longitudinal position and at maximum height,
- on the driver’s side, adjust the steering wheel as far forward as possible,
- pull the end of the parking brake lever, so as to position
it horizontally along the loor (see “Brakes”),
- lift the control 3 and pivot the seat inwards. Reach
Lift the control bar and adjust to the de
-
sired position.
Armrest
To place it in the vertical position , lift
it from its position of use until it locks.
Backrest angle
Use the control to adjust the backrest
angle.
Driver’s seat height
Raise or lower the control the number
of times required to obtain the desired
position.
To return it to positions of use, from the vertical,

fold fully down then lift to the desired position.
F R O N T S E A T S

12
91
III
Heated seats
The front seats can be heated in
-
dividually. Use the controls located
at the side of the seats, and select
one of the three heating levels :
0: OFF
1: Low
2: Medium
3: High
Seat temperature is adjusted ac -
cordingly.
Note: The heated seats will only
operate when the engine is run -
ning.
Note: The seats can still be moved on a temporary basis:
- when opening one of the front doors.
- after switching off the ignition. Electrically operated
adjustments
Œ
Driver’s seat height and
reach
 Backrest angle
ŒRaise or lower the rear part of the control to raise or lower t
he
seat.
ŒSlide the control forwards or rearwards to adjust the seat
forwards or rearwards.
Push the top of the control forwards or rearwards to adjust the
backrest angle. F R O N T S E A T S