2008 Citroen C4 PICASSO DAG ignition
[x] Cancel search: ignitionPage 75 of 266
76
II
If there is a malfunction, have the system checked by a CITROËN dealer.
The function displays the following types of message :Operation :
Y o u h a v e i d e n t i fi e d a p a r k i n g s p a c e :
1. Press button A to select the function.
2. Activate the direction indicator on the side where the space is to be measured.
3. During the measuring, go forward the length of the space, at a speed less than 20 km/h (approx. 12 mph), to prepare for your manœuvre.
The system then measures the size of the space.
4. The system informs you of t h e l e v e l o f d i f fi c u l t y o f t h e manœuvre via a message on the multifunction screen accompanied by a gong.
5. Depending on the message issued by the system, you may or may not be able to perform the manœuvre.
Parking possible
P a r k i n g d i f fi c u l t
Parking not advised
Note : The function deselects itself automatically :
- when you engage reverse gear,
- when you switch off the ignition,
- if measuring is not requested,
- w i t h i n fi v e m i n u t e s o f s e l e c t i o n of the function,
- if the vehicle speed exceeds the threshold of 70 km/h (approx. 45 mph) for one minute.
Warning : if the lateral distance between your vehicle and the parking space is too large, the system may not be able the measure the space.
Notes :
- The function remains available after each measurement and thus can measure more than one space during your search.
- In bad weather conditions or in winter, make sure that the sen-sors are not covered by dirt, or by ice or snow.
- The parking space sensor func-tion deactivates the front park-ing assistance during the space measuring phase when you are in forward gear.
P A R K I N G S P A C E S E N S O R
Page 76 of 266
A
II
77
SAFETY RECOMMENDATIONS
The ESP system offers increased driving safety but is not in place to encourage the driver to take addi-tional risks or to drive at excessive speeds.
The functioning of this system is subject to compliance with the manufacturer’s recommendations on wheels (tyres and rims), brake parts and electronic components, as well as with CITROËN’s as-parts and electronic components, components,
sembly and repair procedures.
After any collision, have this system checked by a CITROËN dealer.After any collision, have this system , have t
Electronic stability programme (ESP) and traction control (ASR)
These systems are closely connected to the ABS and additional to it. In the event of a loss of control of the vehicle by the driver, the ESP system acts automatically on one or more brakes and also on the engine to bring the vehicle back on trajectory. The ASR system optimises traction and prevents wheel spin by acting on the brakes of the driving wheels, as well as on the engine. It also improves steering stability during acceleration.
Operation :
When either the ESP or ASR system is in operation, the ESP/ASR warning l a m p fl a s h e s.
Deactivation
In exceptional conditions (vehicle stuck in snow, soft ground, e tc.) it may prove useful to deactivate the ESP/ASR system to allow the wheels to spin and thus regain traction.
- Press on control A, the ESP/ASR warning lamp and the control light up. The ESP/ASR systems are no longer active.
The ESP/ASR systems will activate again :
- Automatically after the ignition has been switched off.
- Automatically above a speed of 50 km/h (30 mph).
- Manually with a new press on control A.
Operational anomaly
If the systems malfunction, the ESP/ASR warning lamp comes on, ac-companied by a sound signal and a message on the multifunction display. Contact a CITROËN dealer to have the system checked.companied by a sound signal and a message on the multifunction by a sound
E L E C T R O N I C S T A B I L I T Y P R O G R A M M E
Page 77 of 266
78
II
Direction indicators
Left : downwards.
Right : upwards.
For a change of direction, operate the control stalk to go beyond the “tight spot”. It will revert automati-cally to its initial position with the return of the steering wheel.
H e a d l a m p fl a s h
Pull the control stalk towards you.
T h e h e a d l a m p fl a s h i s p o s s i b l e even with the ignition switched off.
Horn
P r e s s a t t h e l o w e r p a r t o f t h e fi x e d centred controls steering wheel.
Emergency activation of the hazard warning lamps
A heavy deceleration of the vehi-cle will cause the hazard lamps to activate automatically.
They will cease automatically on reacceleration of the vehicle or manually if you press on the hazard lamps button on the dashboard.
Driving with the hazard lamps activated renders the direction indicators inoperational.
Distress signal
The distress signal operates all the direction indicators simultaneously.
Only make use of this in a situa-tion of danger, for an emergency s t o p o r i f y o u fi n d y o u r s e l f d r i v i n g i n exceptional weather conditions.
The distress signal will operate even with the ignition switched off.
S I G N A L L I N G
Sound signal for vehicle lamps left on
With the ignition switched off, the signal will activate when the driv-er’s door is opened, to indicate that lamps have been left on.
It will cease when the door is closed, the lamps switched off, or the ignition switched on again.
This signal is inactive if the auto-matic lighting of headlamps and /or the guide-me-home lighting are activated.
Page 78 of 266
4
3
A
2 1II
79
All lamps off
LIGHTING CONTROL
1 Stop
2 Automatic lighting
3 Sidelamps
4 Dipped beams / Main beams
Sidelamps on
Dipped beams / main beams on
Turn the ring A forwards.
Turn the ring A forwards.
Automatic lighting of headlamps
The sidelamps and dipped beams come on automatically when the a m b i e n t l i g h t i s i n s u f fi c i e n t o r i f t h e windscreen wipers are in continuous operation.
Pull the control stalk fully towards you to swap between dipped beams and main beams.
EXTERIOR SIDE LIGHTERS
These illuminate :
- the zones facing the driver’s and passenger’s doors,
- the zones forward of the door mirrors and rearward of the front doors.
I l l u m i n a t i o n / e x t i n c t i o n
The side lighters come on :
- when you unlock the vehicle or press on the lighting button on the remote control.
- when you remove the key from the ignition,
- when you open a door,
- when you use the remote control to locate your vehicle.
They are timed to go out automatically.
They go out as soon as the light is a g a i n s u f fi c i e n t o r a p p r o x . 5 m i n u t e s after the windscreen wipers have ceased.
To activate this function, place the control A on position 2.
Do not cover the sunlight sen-sor which is located behind the interior rear view mirror and visible from outside the wind-screen.
Turn the ring A forwards.
S I G N A L L I N G
Page 79 of 266
4
3
A
2 1II
79
All lamps off
LIGHTING CONTROL
1 Stop
2 Automatic lighting
3 Sidelamps
4 Dipped beams / Main beams
Sidelamps on
Dipped beams / main beams on
Turn the ring A forwards.
Turn the ring A forwards.
Automatic lighting of headlamps
The sidelamps and dipped beams come on automatically when the a m b i e n t l i g h t i s i n s u f fi c i e n t o r i f t h e windscreen wipers are in continuous operation.
Pull the control stalk fully towards you to swap between dipped beams and main beams.
EXTERIOR SIDE LIGHTERS
These illuminate :
- the zones facing the driver’s and passenger’s doors,
- the zones forward of the door mirrors and rearward of the front doors.
I l l u m i n a t i o n / e x t i n c t i o n
The side lighters come on :
- when you unlock the vehicle or press on the lighting button on the remote control.
- when you remove the key from the ignition,
- when you open a door,
- when you use the remote control to locate your vehicle.
They are timed to go out automatically.
They go out as soon as the light is a g a i n s u f fi c i e n t o r a p p r o x . 5 m i n u t e s after the windscreen wipers have ceased.
To activate this function, place the control A on position 2.
Do not cover the sunlight sen-sor which is located behind the interior rear view mirror and visible from outside the wind-screen.
Turn the ring A forwards.
S I G N A L L I N G
Page 80 of 266
A
80
II
FRONT AND REAR FOGLAMPS (Ring A)
In foggy conditions, if the ambient brightness is not such as to activate the automatic lighting, it is up to you to switch on your dipped beams manually, along with your foglamps as necessary.
These operate in con-junction with the side-lamps, the dipped beams or the main beams.
Headlamps adjustment
Depending on the vehicle load, it is recommended that you correct the height of your headlamp beams.
On the dashboard beside the driver :
0 Unladen
1 Partial load
2 Medium load
3 Full load.
Note : Vehicles equipped with Xenon dual-function directional headlamps have an automatic adjustment of headlamps depending on load.
For a vehicle equipped with rear foglamps :
- 1st turn forwards : lighting of rear foglamps.
- 1st turn rearwards: extinction of rear foglamps.
For a vehicle equipped with front and rear foglamps:
- 1st turn forwards: lighting of front foglamps.
- 2nd turn forwards: lighting of rear foglamps.
- 1st turn rearwards: extinction of rear foglamps.
- 2nd turn rearwards: extinction of front foglamps.
Note : Foglamps should be used only in conditions of fog or snowfall.
GUIDE-ME-HOME LIGHTING
With the ignition off, this func-tion temporarily switches on your headlamps to give you exterior lighting when you are leaving your vehicle.
This function is activated :
Page 81 of 266
A
80
II
FRONT AND REAR FOGLAMPS (Ring A)
In foggy conditions, if the ambient brightness is not such as to activate the automatic lighting, it is up to you to switch on your dipped beams manually, along with your foglamps as necessary.
These operate in con-junction with the side-lamps, the dipped beams or the main beams.
Headlamps adjustment
Depending on the vehicle load, it is recommended that you correct the height of your headlamp beams.
On the dashboard beside the driver :
0 Unladen
1 Partial load
2 Medium load
3 Full load.
Note : Vehicles equipped with Xenon dual-function directional headlamps have an automatic adjustment of headlamps depending on load.
For a vehicle equipped with rear foglamps :
- 1st turn forwards : lighting of rear foglamps.
- 1st turn rearwards: extinction of rear foglamps.
For a vehicle equipped with front and rear foglamps:
- 1st turn forwards: lighting of front foglamps.
- 2nd turn forwards: lighting of rear foglamps.
- 1st turn rearwards: extinction of rear foglamps.
- 2nd turn rearwards: extinction of front foglamps.
Note : Foglamps should be used only in conditions of fog or snowfall.
GUIDE-ME-HOME LIGHTING
With the ignition off, this func-tion temporarily switches on your headlamps to give you exterior lighting when you are leaving your vehicle.
This function is activated :
Page 82 of 266
3
2
1
0
4
II
81
Windscreen wipe
3 Rapid wipe.
2 Normal wipe.
1 Intermittent wipe.
0 Stop.
4 Automatic wipe by pressing downwards, and single wipe.
Note : To deactivate automatic wipe :
- go to position 1, then return to position 0.
Position 1 : The wipe interval will adjust automatically depending on the speed of the vehicle.
Note : In position 2 or 3 : when the vehicle is stationary the wipe interval will reduce automatically.
F o r s a f e t y , t h e w i p e r s y s t e m i s d e a c t i v a t e d a p p r o x . o n e m i n u t e a f t e r you switch off the ignition.
When you switch on the ignition, to reactivate the function :
- return to the Stopposition,
- go to the position desired.
Vehicle equipped with a rain sensor
Position 4 by pressing downwards : The wipe interval will adjust auto-matically as a function of the intensity of the rain.
Note : A press downwards produces a single wipe without deactivating automatic wipe.
IMPORTANT :
Do not cover the rain sensor, which is located behind the interior rear view mirror and visible from outside the windscreen.
If washing the vehicle, switch off the ignition or deactiva te automatic wipe.
Changing the wiper blades
For replacement, the wipers should be stopped in themaintenance position.
Switch off the ignition, then within a minute action the wiper control stalk. The wipers will position themselves in the middle of the wi ndscreen.
After replacement, the wipers will resume their normal position when you switch on the ignition and action the wiper stalk.
For optimum wiping, change the wiper blades once they start t o leave marks on the screen ; otherwise, change them once or twice a year (e .g. in autumn and in spring).For safety, the wiper system is deactivated approx. one minute after you switch off the ignition.
W A S H / W I P E