Page 14 of 257
–
17
F A M I L I A R I S A T I O N
GOOD VENTILATION
To obtain the best from the system, we advise:
I would like ...
Heating or manual Air Conditioning
Air distribution A i r fl o wAir recirculation/Fresh air intakeTemperatureA/C
HEATING
COOLING
DEMISTING
DEFROSTING
Page 44 of 257
45
III
C O M F O R T
This system automatically regulates t e m p e r a t u r e , a i r fl o w a n d a i r d i s t r i b u -tion in the passenger compartment according to the temperature select-ed (for each side, right and left).
It provides an optimum level of comfort regardless of the climatic conditions, b y p e r m a n e n t u s e of the automatic air conditioning mode (press the AUTO button) and with a l l t h e v e n t s o p e n.
H a v i n g n o a i r fl o w p r e v e n t s t h e a i r c o n -ditioning and the system in general from working.
2 - A d j u s t m e n t o f t e m p e r a t u r e o n l e f t h a n d s i d e
1 - A u t o m a t i c o p e r a t i o n
To display the desired tem-perature, rotate control 2or 3:
AUTOMATIC AIR CONDITIONING
The display HIplay (high) corre-sponds to a demand for max-imum heating (above 27).
The display LO (low) cor-responds to a demand for maximum air conditioning (below 15).
A press on this control, con- fi r m e d b y t h e d i s p l a y o f " A / C "and "AUTO", automatically manages all the 5 following functions according to the tempera-ture chosen:
- Flow of air.
- Cabin temperature.
- Distribution of air.
- Air conditioning.
- Recycling of air.
To enable the system to operate, all the air vents should be kept open.
3 - A d j u s t m e n t o f t e m p e r a t u r e o n r i g h t h a n d s i d e
- To the left to lower the temperature
- To the right to raise the temperature
The difference between the tem-peratures on the right and on the left cannot be greater than 3.
An adjustment around 21 will provide a temperature that is comfortable. Depending on your requirements, an adjustment between 18 and 24 is normal.
This is the normal operating mode.
T o p r e v e n t m i s t i n g o f t h e i n t e r i o r o f t h e v e h i c l e i n c o l d a n d d a m p c o n d i t i o n s , t h e u s e o f A U T O m o d e i s r e c o m m e n d e d .
Page 50 of 257
51
III
C O M F O R T
H e a t e d s e a t s
The front seats can be heated inde-pendently. Use the controls placed on the sides of the seats, turning them to select one of three heating levels:
0: Off.
1: Gentle heat.
2: Medium heat.
3: Strong heat.
The seat temperature will adjust ac-cordingly.
Note: The heated seats will only op-erate when the engine is running.
Note: The seats can still be moved on a temporary basis:
- when opening one of the front doors.
- after switching off the ignition.
E l e c t r i c a l l y o p e r a t e d a d j u s t m e n t s
A d j u s t m e n t o f s e a t h e i g h t , a n g l e a n d r e a c h
A d j u s t m e n t o f b a c k r e s t a n g l e a n d l u m b a r s u p p o r t
Raise or lower the front of control 1 to make the front of the seat cushion higher or lower.
Raise or lower the rear of control 1 to make the seat higher or lower.
Action control 1 to the front or to the rear to move the seat forward or back.
Push the top of control 2forward or back to adjust the backrest angle.
Raise or lower control 2to increase or decrease the lumbar support.
Page 81 of 257
77
VI
I N T E R I O R C O M F O R T
Luggage securing rings
U s e t h e 2 s i d e fi x i n g s a t t h e r e a r , a s well as the 6 anchoring rings on the b o o t fl o o r a n d t h e r e a r s e a t b a c k r e s t , to secure your loads.
For safety reasons, in case of hard braking, heavy objects should be placed as far forward as possible.
P r o t e c t i v e n e t
This helps to secure objects stowed in the boot.
BOOT
B o o t h o o k
Removing the rear shelf ( 3 - d o o r m o d e l )
- Detach the cords.
- Carefully lift then pull, tilting it slightly on one side.
Removing the rear shelf ( 5 - d o o r m o d e l )
- Detach the cords.
- Carefully lift then pull.
A v o i d u s i n g t h e r e a r s h e l f f o r h e a v y o r h a r d i t e m s .
T h e s e c o u l d b e d a n g e r o u s i f t h r o w n a r o u n d d u r i n g h a r s h b r a k i n g o r , i f t h e y t o u c h t h e r e a r s c r e e n , c o u l d d a m a g e t h e heating elements.
Page 191 of 257
179
XIII
A U D I O
QUESTIONANSWERSOLUTION
The pre-set stations do not work (no sound, 87.5 Mhz is displayed, etc.).
The waveband selected is not the correct one.Press on the button BAND AST to retrieve the wave band (AM, FM1, F M 2 , F M A S T ) w h e r e t h e s t a t i o n s have been memorised.
T r a f fi c A n n o u n c e m e n t s ( T A ) is displayed, but I do not receive any road information.
The particular radio station is not in the r e g i o n a l t r a f fi c i n f o r m a t i o n n e t w o r k .Change to a radio station which does b r o a d c a s t t r a f fi c i n f o r m a t i o n .
The reception quality of the radio station being listened to gradually deteriorates or the pre-set stations do not work (no sound, 87.5 Mhz displayed, etc.).
The vehicle is too distant from the transmitter of the station being listened to, or no transmitter is present in the geographical area you are passing through.
Activate the RDS function to allow the system to check whether a more powerful transmitter is to be found in the geographical area.
The environment (hills, high buildings, tunnels, underground car parks, etc.) is blocking reception, even in RDS mode.
This phenomenon is normal and does not imply anything wrong with the radio.
The aerial is absent or has been damaged (for example after going through a car wash or in an underground car park).
Have the aerial checked by a CITROËN dealer.Have the aerial checked by a Have the aerial checked by a
Cutting of sound for 1 or 2 s e c o n d s i n r a d i o m o d e .
The RDS system during this brief sound cut-off is searching for a better frequency that might offer improved reception of the station.
Deactivate the RDS function if the phenomenon occurs too frequently and always on the same journey.
When the engine is not running, the radio stops after a few minutes.
When the engine is switched off, the working time for the radio depends on the vehicle n the engine is switched off, the working n the engine is switched of
battery charge.
The interruption is normal: the radio goes into economy mode, cutting off in order to save the erruption is normal: the radio goes into erruption is normal: the radio goes into
vehicle’s battery.
You have to start the engine so as to increase the battery charge.
The message "the audio system is overheating" appears on the screen.
In order to protect the audio equipment in excessive ambient temperatures, the radio goes into an automatic thermic protection mode which results in a reduction in sound volume or stopping of the CD player.
Switch off the audio system for a few minutes in order to allow the system to cool down.
