Page 51 of 257
52 III
C O M F O R T
M e m o r i s a t i o n o f d r i v i n g positions
You have the possibility to memorise two driving positions, via the buttons M / 1 and M / 2.
M e m o r i s a t i o n u s i n g t h e b u t t o n s
To memorise, using the buttons located on the side of the seat:
- turn the ignition key to the drive position,
- adjust your seat and your exterior rear view mirrors,
- press on button M then imme-diately on button 1 " fi r s t d r i v i n g position" or on button 2 "second driving position".
The memorisation is recognised by an audible signal. Memorising of a new position cancels the previous one.
R e c a l l o f a m e m o r i s e d d r i v i n g position
V e h i c l e s t o p p e d (ignition on or engine running)
- P r e s s b r i e fl y o n b u t t o n 1 or 2 or to recall the corresponding memo-rised position.
Note: a f t e r fi v e c o n s e c u t i v e r e c a l l s of a memorised position, this func-tion will be deactivated until the engine is started.
V e h i c l e m o v i n g
- Keep button 1 or 2 pressed to recall the corresponding memo-rised position.
Page 52 of 257
53
III
C O M F O R T
B e f o r e f o l d i n g t h e s e a t
Before tipping the rear seat, make sure that the seat belts will not be snagged or trapped by the seat and its catches.
Position them carefully to the sides of the backrests.
R e a r h e a d r e s t r a i n t s
The rear head restraints have two positions:
- A low stowed position when the seat is not occupied.
- A raised position to optimise the safety of the passenger, by rais-ing it to its stop, i n c l u d i n g w h e n u s e d w i t h a f o r w a r d f a c i n g c h i l d seat.
To lower the head restraints, press on the unlocking controls.
To remove them, pull upwards as far as permitted, then press on the unlocking controls.
Note: Never drive the vehicle with- o u t t h e h e a d r e s t r a i n t s fi t t e d .
R e a r a r m r e s t
- Lower the rear armrest to improve your comfort.
- Lift the cover for access to its stor-age box.
This can contain a storage box, two cup holders and two pen holders.
REAR SEATS
F o l d i n g t h e s e a t c u s h i o n
- raise the front of the seat cush-ion,
- tilt it towards the front seats.
When repositioning the seat base, make sure that the seat belt buckles are back in place.
Note: When you fold a rear seat cushion, you should also fold the corresponding backrest.
Page 75 of 257
71
V
V I S I B I L I T Y
1 - Spotlamps
A press on one of the buttons will switch the corresponding spotlamp on or off.
They will not come on if the ignition is switched off or the vehicle is in economy mode.
Automatic lighting of interior lamps
- When you enter the vehicle:
They come on immediately you unlock the vehicle or open a door.
They go out 30 seconds after doors have been closed, or after the ignition has been switched on.
- When you leave the vehicle:
They come on when you remove the ignition key (for about 30 seconds), or when a door is opened.
They go out after 30 seconds with the doors closed, or immediately the vehicle is locked.
In this position, the interior lamp comes on when you open a door or the boot.
In this position, it is deacti-vated and switched off per-manently.
In the front, the spotlamps are deac-tivated.
In this position, lighting is permanent.
2 - Front and rear interior lamps
INTERIOR LIGHTING
Welcome lighting
Page 86 of 257
82
VII
C H I L D S A F E T Y
Incorrect installation of a child seat in a vehicle compromises protection of the child in the event of a colli-sion.
The ISOFIX fastening system ena-bles you to reduce those risks posed b y i n c o r r e c t fi t t i n g , o f f e r i n g y o u a c o n v e n i e n t , s t r o n g a n d r e l i a b l e fi t -ting for a child seat in your vehicle.
The ISOFIX child seat recommended for your vehicle is: ISOFIX RÖMER Duo:recommended for yourmend
It is sold by the CITROËN net-work. This seat has an upper strap, which must be attached to the ISOFIX "upper tether".
The RÖMER Duo Plus ISOFIX is a p p r o v e d s p e c i fi c a l l y f o r y o u r v e h i c l e .
If it is installed in a rear seat position, the vehicle’s corresponding front seat should be adjusted so that the child’s feet do not touch the backrest of this front seat.
This ISOFIX child seat can also be installed in seat positions that are not equipped with ISOFIX anchoring points. In this case, it is compulsory to secure it to the vehicle seat by means of the vehicle seat belt.
Page 110 of 257
100
IX
D R I V I N G
The 6-speed electronic gear-box offers a choice of two driving modes:
6-SPEED ELECTRONIC GEARBOX
A manual mode with two methods of operation:
Note: if you are in automatic mode, an instant manual mode activates whenever you action one of the con-trols at the steering wheel.
- the paddle controls behind the steering wheel.
- the gear lever in position M,
Display in the instrument panel
N. Neutral
R. Reverse
1, 2, 3, 4, 5, 6. Gears in manual mode
A1, A2, A3, A4, A5, A6. Gears in automatic mode.
S. Sport (Sport driving style)
For each of these two modes, a Sport option (corresponding to a more dynamic style of driving) is also available.
An automated mode with the gear lever in position A.
Page 119 of 257
108
IX
D R I V I N G
Operation in Sport or Snow automatic mode
Select the driving mode:
- Normal, for regular use, the warning lamps S and are not illuminated.
-Sport, for more responsive driving, to provide maximum performance and acceleration.
- Snow, for smooth driving in wintry conditions.
Page 122 of 257
111
IX
D R I V I N G
Deactivation of cruise control with memorised speed
- Either by pressing the brake pedal or the clutch pedal.
- Or with a press on button 3.
- Or when ESP or ASR is active.
Note: cruise control is disengaged when the gear lever is in neutral position.
These actions bring up the display "OFF" in zone A in the instrument panel.
These actions do not cancel your cruise speed which remains dis-played on the instrument panel.
Cruise control must only be used where road conditions permit driving at a constant speed.
Do not use it on congested roads or when weather and road conditions are poor.
The driver must still remain attentive and in complete con-trol of the vehicle.
You are recommended to keep your feet within range of the pedals.To avoid any interference with the pedals:To avoid any To avoid any
- ensure that any over-mats a r e c o r r e c t l y fi t t e d ,
- never superimpose one over-mat on another.
Reactivation of cruise control
- by recalling the memorised speed:
Following a deactivation, press on button 3. Your vehicle auto-matically resumes the memorised cruise speed displayed in zone A.
- by selecting the current speed:
Press on button 2 or 4 as soon as the desired speed is reached. The information "OFF" will then disap-pear from zone A.
In the event of a malfunction, a message is displayed, accompanied by a sound signal and lighting of the SERVICE warning lamp.
Consult your CITROËN dealer.
To cancel the function
- by moving the control from posi-tion "REG" to position 0.
- by stopping the engine.
The cruise speed chosen pre-viously is no longer memorised.
Page 124 of 257
113
IX
D R I V I N G
To stop the function
- move the control from position "LIM" to position 0.
- or stop the engine.
The speed that you chose is memo-rised.
In the event of a malfunction, a message is displayed, accompanied by a sound signal and lighting of the SERVICE warning lamp.
Consult your CITROËN dealer.
A fl o o r m a t n o t r e c o m -mended by CITROËN risks sliding under the accelerator pedal, thus preventing you from pressing past the tight spot.
It will then be impossible to exit from the desired limitation, unless by acting on the steer-ing wheel control.
The driver must still remain atten-tive and in complete control of the vehicle.
We advise the driver to keep their feet close to the pedals.
Note: if during speed limitation, the system cannot keep to the maxi-mum speed (especially on a steep descent or if you accelerate too h a r d ) t h e s p e e d fl a s h e s . A d a p t y o u r speed as necessary.
The function will re-engage when your speed has returned below the desired maximum.
Deactivation of the maximum speed
Press button 3.
The information "OFF" will appear on the instrument panel screen.
This action does not cancel the memorised maximum speed, which remains displayed in zone A of the instrument panel.
Temporary override of the maximum speed
You can exceed the memorised maximum speed at any time by pressing the accelerator pedal hard down past the tight spot.
During the time the limit speed is being exceeded, the displayed s p e e d fl a s h e s .
You have only to release the accel-erator pedal to return below the maximum speed, thus keeping the function active.
