2008 Citroen C CROSSER ECO mode

A U D I O E Q U I P M E N T a n d T E L E M A T I C S
XI
207
Changing the language,
programming the voice
Changing the language of the voice
commands
By default, the recognition system is in
English. Programming the user’s voice
You can use the user’s voice programming
function to create a voice model for one
person per language.
The characteristics of your voice and
your pronunciation are recorded in this
model for improved voice recognition.
It is essential that the vehicle is parked
in a safe place, with the handbrake
applied.
Switch off your telephone during the
process to avoid any interruption.
1 - Press the SPEAK button. 5 - The system says the fi rst of 45
typical phrases.
If you do not start the programming
process within approximately 3 min-
utes after pressing the SPEAK but-
ton, the process is cancelled.
If you press the SPEAK button with-
in 5 seconds following the reading of
a voice command, the recording of
this command is repeated.
1 - Press the SPEAK button.
2 - Say “Setup”.
3 - Say “Language”.
5 - Say the language of your choice in English, example:
say “French” for French.
7 - Say “Yes” to start the change of language process or say
“No” to return to steps 4 to 7.
8 - The system repeats the language chosen and completes the change
of language process. 2 - Say “Word training”.
4 - When you are ready to start, press and hold the SPEAK
button. 6 - Repeat each phrase in the
table on the next page.
The system records your voice and
moves on to the recording of the next
command.
Continue the process until all of the
phrases have been recorded.
4 - The system says “Select a language: English, Spanish, French, German
or Italian”.
6 - The system then says “French selected. Is this correct?”
3 - An explanation message is given. 7 - After reading all the voice commands,
the system says “The word enrolment
is complete” and ends the process.