2008 CHRYSLER SEBRING SEDAN service reset

The two trip odometers show individual trip mileage. To
switch from odometer to trip odometers, press and
release the Trip Odometer button. To reset a trip odom-
eter, display the desired trip odometer to be reset then
push and hold the button until the display resets (ap-
proximately two seconds). Refer to “Trip Odometer But-
ton” for additional information.
Vehicle Warning Messages
When the appropriate conditions exist, “DOOR AJAR,”
“TRUNK AJAR,” or “gASCAP” will display in the odom-
eter.
NOTE:If the instrument cluster is equipped with the
optional Electronic Vehicle Information Center (EVIC),
then all warnings including “DOOR AJAR” and
“TRUNK AJAR” will only display in the EVIC. (Refer to
“Electronic Vehicle Information Center (EVIC)” in this
section for specific messages).gASCAP
If the vehicle diagnostic system detects a leak or change
in the evaporative system, or the fuel filler cap is loose,
improperly installed, or damaged, the words “gASCAP”
will display in the odometer. If this occurs, tighten the
fuel filler cap properly and press the odometer reset
button to turn off the “gASCAP” message. (Refer to
“Onboard Diagnostic System — OBDII” in Section 7 of
this manual for more information). If the problem con-
tinues, the message will appear the next time the vehicle
is started. See your authorized dealer service center as
soon as possible.
Change Oil
Your vehicle is equipped with an engine oil change
indicator system. The “Change Oil” message will flash in
the instrument cluster odometer for approximately 12
seconds after a single chime has sounded to indicate the
next scheduled oil change interval. The engine oil change
UNDERSTANDING YOUR INSTRUMENT PANEL 175
4

Dual Trip Odometer — If Equipped
Press and release this button to change the display from
odometer to “Trip A.” Press and release it a second time
to change the display to “Trip B.” Press and release it a
third time to change the display back to the odometer.
To reset the trip odometer, first display the trip mileage
that you want to reset, “Trip A” or “Trip B.” Then push
and hold the button (approximately two seconds) until
the display resets to zero. The odometer must be in Trip
Mode to reset the trip odometer.
17. Electronic Throttle Control Indicator Light
This red illuminated light informs you of a
problem with the Electronic Throttle Control
system. If a problem is detected, the light will
come on while the engine is running. If the
light remains lit with the engine running your vehicle
will usually be drivable and not need towing, however
see your dealer for service as soon as possible.If the light is flashing when the engine is running you
may experience power loss, an elevated/rough idle, and
increased brake pedal effort, and your vehicle may
require towing. Immediate service is required.
The light will come on when the ignition switch is first
turned ON and remain on briefly as a bulb check. This is
normal. If the light does not come on during starting,
have the system checked by an authorized dealer.
18. Electronic Stability Program (ESP) Indicator
Light/Traction Control System (TCS) Indicator Light —
If Equipped
If this indicator light flashes during accelera-
tion, apply as little throttle as possible. While
driving, ease up on the accelerator. Adapt your
speed and driving to the prevailing road con-
ditions, and do not switch off the ESP, or TCS — if
equipped.
UNDERSTANDING YOUR INSTRUMENT PANEL 177
4

these conditions, using the[5]range will improve perfor-
mance and extend transaxle life by reducing excessive
shifting and heat build-up.
RESET MODE — Electronic Transaxle
The transaxle is monitored electronically for abnormal
conditions. If a condition is detected that could cause
damage, the transaxle automatically shifts into second
gear. The transaxle remains in second gear (third gear
with a six-speed automatic) despite the forward gear
selected. PARK, REVERSE, AND NEUTRAL will con-
tinue to operate. This RESET feature allows the vehicle to
be driven to a dealer for service without damaging the
transaxle.
In the event that the problem has been momentary, the
transaxle can be reset to regain all forward gears.
1. Stop the vehicle.
2. Shift the gear selector lever into PARK.3. Turn the ignition key to the LOCK position then restart
the engine.
4. Shift the gear selector lever into the desired gear range
and resume driving.
NOTE:Even if the transaxle can be reset, it is recom-
mended that you visit a dealer at your earliest possible
convenience. Your authorized dealer has diagnostic
equipment to determine if the problem could recur.
If the transaxle cannot be reset, authorized dealer service
is required.
AUTOSTICK— IF EQUIPPED
AutoStickis a driver-interactive transaxle that offers six
manual ratio changes to provide you with more control.
AutoStickallows you to maximize engine braking,
eliminate undesirable upshifts and downshifts, and im-
prove overall vehicle performance. This system can also
provide you with more control during passing, city
STARTING AND OPERATING 275
5

RESET button to turn off the message. If the problem
persists, the message will appear the next time the
vehicle is started. This might indicate a damaged cap. If
the problem is detected twice in a row, the system will
turn on the MIL. Resolving the problem will turn the MIL
light off.
EMISSIONS INSPECTION AND MAINTENANCE
PROGRAMS
In some localities, it may be a legal requirement to pass
an inspection of your vehicle’s emissions control system.
Failure to pass could prevent vehicle registration.
For states that require an Inspection and Mainte-
nance (I/M), this check verifies the Malfunction
Indicator Light (MIL) is functioning and is not on
when the engine is running, and that the OBD II system
is ready for testing.Normally, the OBD II system will be ready. The OBD II
system maynotbe ready if your vehicle was recently
serviced, recently had a dead battery, or a battery replace-
ment. If the OBD II system should be determined not
ready for the I/M test, your vehicle may fail the test.
Your vehicle has a simple ignition key-actuated test,
which you can use prior to going to the test station. To
check if your vehicle’s OBD II system is ready, you must
do the following:
1. Insert your ignition key into the ignition switch.
2. Turn the ignition to the ON position, but do not crank
or start the engine.
3. If you crank or start the engine, you will have to start
this test over.
4. As soon as you turn your key to the ON position, you
will see the MIL symbol come on as part of a normal bulb
check.
378 MAINTAINING YOUR VEHICLE

Guide .............................. 341
Recreational.......................349,369
Weight .............................. 341
Towing Assistance....................... 102
Traction.............................. 292
TrailerTowing .......................... 338
Cooling System Tips.................... 349
Hitches............................. 340
Minimum Requirements................. 343
Trailer and Tongue Weight................ 342
Wiring .............................. 346
TrailerTowingGuide ..................... 341
TrailerWeight .......................... 341
Transaxle............................. 270
Additives............................ 405
Automatic.................... 13,264,270,403
Autostick............................ 275
Filter ............................... 405
Maintenance.......................... 403Operation........................... 270
Overdrive........................... 274
Selection of Lubricant................... 432
Transmission
Range Indicator....................... 174
Transmitter Battery Service
(Remote Keyless Entry).................... 25
Transmitter, Garage Door Opener (HomeLink) . . 144
Transmitter Programming
(Remote Keyless Entry).................... 25
Transporting Pets........................ 77
Tread Wear Indicators.................... 309
Trip Odometer.......................... 174
Trip Odometer Reset Button................ 176
Trunk Lid (Deck Lid)...................... 38
Trunk Release, Emergency................ 39,40
Trunk Release Remote Control............... 38
Turn Signals......................135,179,424
INDEX 469
10

Maintenance, General..................... 380
Maintenance Procedures................... 380
Maintenance Schedule.................... 434
Malfunction Indicator Light (Check Engine) . . 182,378
Manual, Service......................... 447
Map/Reading Lights..................... 131
Master Cylinder (Brakes).................. 402
Methanol............................. 324
Mini-Trip Computer...................... 186
Mirrors ................................ 85
Automatic Dimming..................... 86
Electric Powered....................... 87
Outside.............................. 88
Rearview............................. 85
Vanity ............................... 89
Modifications/Alterations, Vehicle............. 7
Monitor, Tire Pressure System............... 314
Mopar Parts.........................379,446
MP3 Player.........................222,225MTBE/ETBE........................... 324
Navigation Radio........................ 225
Navigation System....................... 225
New Vehicle Break-In Period................ 78
Occupant Restraints..................... 59,62
Occupant Restraints (Sedan)......... 40,54,55,59,61
Octane Rating, Gasoline (Fuel).............. 323
Odometer............................. 174
Trip .............................174,176
Oil Change Indicator................175,185,434
Oil Change Indicator, Reset..............175,185
Oil, Engine.........................380,430
Capacity............................ 429
Change Interval...............175,185,382,434
Checking............................ 380
Dipstick............................. 380
Disposal............................ 384
482 INDEX

Selection of Lubricant................... 432
Transmission
Range Indicator....................... 174
Transmitter Battery Service
(Remote Keyless Entry).................... 25
Transmitter, Garage Door Opener (HomeLink) . . 144
Transmitter Programming
(Remote Keyless Entry).................... 25
Transporting Pets........................ 77
Tread Wear Indicators.................... 309
Trip Odometer.......................... 174
Trip Odometer Reset Button................ 176
Trunk Lid (Deck Lid)...................... 38
Trunk Release, Emergency................ 39,40
Trunk Release Remote Control............... 38
Turn Signals......................135,179,424
UCI Connector......................... 229
UConnect™ (Hands-Free Phone)........... 89,225Understanding Your Instrument Panel......... 169
Uniform Tire Quality Grades................ 449
Universal Consumer Interface (UCI) Connector . . . 229
Universal Serial Bus (USB) Port...........222,225
Universal Transmitter..................... 144
Unleaded Gasoline....................... 323
Untwisting Procedure, Seat Belt.............. 47
Upholstery Care........................ 408
USB Port...........................222,225
Vacuum/Vapor Harnesses................. 400
VanityMirrors ........................... 89
Variance, Compass....................... 189
Vehicle Certification Label................. 335
Vehicle Identification Number (VIN)............ 6
Vehicle Loading...................300,335,337
Vehicle Modifications/Alterations.............. 7
Vehicle Storage.......................255,417
Vehicle Theft Alarm (Security Alarm).......... 18
INDEX 489
10