2008 CHRYSLER SEBRING CONVERTIBLE tow

CAUTION!
²Do not operate the Power Top when the vehicle is in motion.
²Do not operate the Power Top with the hydraulic pump
valve open.
²Do not allow the top to remain in the suspended position.
After approximately 10 minutes in the suspended position,
the hydraulic pressure will release, which will allow the top
and the trunk lid to lower. Pressing the Power Top switch
will cancel this operation.
²Always use a normal ice scraper to remove snow or ice from
the rear window. Use of a sharp object or other tools could
scratch the fabric or panels when removing snow or ice.
²Always close the top when leaving your vehicle so as not to
leave the interior exposed to potentially damaging outdoor
conditions.
²Do not leave the top lowered for several weeks at a time.
Close it occasionally to prevent discoloration in the folds of
the fabric and to allow the creases to smooth out. This is
especially important if the top was stowed when not com-
pletely dry.
Failure to follow these cautions can cause damage to the convert-
ible top components, trunk contents, and the vehicle interior.
WARNING!
²Before operating the Power Top, make sure that no moving
parts of the convertible top can injure a person or animal.
²Never place any extremities (hands, feet, etc.) near the
convertible top components, the upper windshield area, the
shelf area behind the rear seats, or the convertible top
stowage area while raising or lowering the convertible top.
²When using the Power Top button on RKE transmitter, if
potential danger exists while lowering the top, release the
button immediately to interrupt the operation.
²When using the Power Top switch on the instrument panel,
if potential danger exists while lowering the top, press and
release the switch immediately to interrupt the operation.
²When using the Power Top switch on the instrument panel,
if potential danger exists while raising the top, release the
switch immediately to interrupt the operation.
²
Only drive the vehicle with the convertible top completely closed
and latched or fully lowered into its stowage compartment.
²Do not operate the Power Top when the vehicle is in motion.
Failure to follow these warnings can result in injuries that are
serious or fatal to you, your passengers, and others around you. 84 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Cargo Protector
The cargo protector is located in the trunk. Before low-
ering the convertible top, you must unfold the cargo
protector and seat the tabs at each end of the cargo
protector in the V slots in the trunk liner. Doing so closes
a switch that allows top operation. If the switch is not
closed, a warning message displays in the instrument
cluster to notify the driver.
Positioning the Cargo Protector for Top Operation
Pull the cargo protector toward you to begin unfolding
the panels. Grasp the handle in the center of the outer-
most (top) panel and raise the cargo protector. Then,
align and seat the tabs at each end of the cargo protector
in the V slots in the trunk liner as shown in the illustra-
tion.
Cargo Protector
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 85
3

UConnecttallows you to transfer calls between the
system and your cellular phone as you enter or exit your
vehicle and enables you to mute the system's microphone
for private conversation.
The UConnecttphonebook enables you to store up to 32
names, with four numbers per name. Each language has
a separate 32-name phonebook accessible only in that
language. This system is driven through your Bluetootht
Hands-Free profile cellular phone. UConnecttfeatures
Bluetoothttechnology - the global standard that enables
different electronic devices to connect to each other
without wires or a docking station, so UConnecttworks
no matter where you stow your cellular phone (be it your
purse, pocket, or briefcase), as long as your phone is
turned on and has been paired to the vehicle's
UConnecttsystem. The UConnecttsystem allows up to
seven cellular phones to be linked to the system. Only
one linked (or paired) cellular phone can be used with the
system at a time. The system is available in English,
Spanish, or French languages (as equipped).Phone Button
The rearview mirror contains the microphone
for the system (depending on the type of
mirror and radio equipped), and either the
radio or the mirror has the two control buttons
(Phone button and ªVoice Recognitionº button) that will
enable you to access the system.
Voice Recognition Button
Actual button location may vary with radio.
The individual buttons are described in the
ªOperationº section.
The UConnecttsystem can be used with any Hands-Free
Profile certified Bluetoothtcellular phone. See
UConnecttwebsite for supported phones. If your cellu-
lar phone supports a different profile (e.g., Headset
Profile) you may not be able to use any UConnectt
features. Refer to your cellular service provider or the
phone manufacturer for details.
100 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Your phone must be turned on and paired to the
UConnecttsystem to allow use of this vehicle feature in
emergency situations, when the cell phone has network
coverage and stays paired to the UConnecttsystem.
Towing Assistance
If you need towing assistance:
²Press the PHONE button to begin.
²After the9Ready9prompt and the following beep, say
9Towing Assistance.9
NOTE:The Towing Assistance number dialed is based
on the country where the vehicle is purchased (1-800-528-
2069 for the United States of America, 1-877-213-4525 for
Canada, 55-14-3454 for Mexico City and 1-800-712-3040
for outside Mexico City in Mexico).
Please refer to the 24-Hour ªTowing Assistanceº cover-
age details in the Warranty information booklet and on
the 24±Hour Towing Assistance Card.
Paging
To learn how to page, refer to9Working with Automated
Systems.9Paging works properly except for pagers of
certain companies, which time out a little too soon to
work properly with the UConnecttsystem.
Voice Mail Calling
To learn how to access your voice mail, refer to9Working
with Automated Systems.9
Working with Automated Systems
This method is used in instances where one generally has
to press numbers on the cellular phone keypad while
navigating through an automated telephone system.
You can use your UConnecttsystem to access a voice
mail system or an automated service, such as a paging
service or automated customer service line. Some ser-
vices require immediate response selection. In some
instances that may be too quick for use of the UConnectt
system.
112 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Voice Commands
Primary Alternate(s)
language
list names
list phones
mobile
mute
mute off
new entry
no
pager
pair a phone
phone pairing pairing
phonebook phone book
previous
record again
redialVoice Commands
Primary Alternate(s)
return to main menu return or main menu
select phone select
send
set up phone settings or phone
set up
towing assistance
transfer call
UConnecttTutorial
try again
voice training
work
yes
124 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Use the hood prop rod to secure the hood in the open
position. Place the upper end of the prop rod in the hole
on the underside of the hood.
Before closing the hood, make sure to stow the prop rod
in its proper location. To prevent possible damage, do notslam the hood to close it. Use a firm downward push at
the center of the hood to ensure that both latches engage.
WARNING!
If the hood is not fully latched, it could fly up when
the vehicle is moving and block your forward vision.
You could have a collision. Be sure all hood latches
are fully latched before driving.
LIGHTS
Exterior & Interior Lighting Control
The Multi-Function Control Lever on the left side
of the steering column controls the operation of
the headlights, parking lights, turn signal lights,
instrument panel lights, instrument panel light dimming,
interior lights, and fog lights (if equipped).
Hood Prop Rod Hole Location
138 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Turn Signals
Move the Multi-Function Lever upward or downward
and the corresponding turn signal indicator on the in-
strument panel will flash to show proper operation of the
front and rear turn signal lights.You can signal a lane change by moving the lever
partially upward or downward without moving beyond
the detent.
Check for a defective outside light bulb if either light
remains on and does not flash or has a very fast flash rate.
If an indicator fails to light when the lever is moved, it
would suggest that the fuse or indicator is defective.
Highbeam/Lowbeam Select Switch
Push the Multi-Function Control Lever away from you to
switch the headlights to HIGH beam. Pull the Lever
toward you, to switch the headlights back to LOW beam.
Turn Signal Control
142 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Flash to Pass
You can signal another vehicle with your headlights by
lightly pulling the Multi-Function Control Lever toward
you. This will cause the headlights to turn on at high
beam and remain on until the lever is released.
NOTE:If the Multi-Function Control Lever is held in
the Flash to Pass position for more than 15 seconds, the
high beams will shut off. If this occurs, wait 30 seconds
before activating the Flash to Pass function again.
Highbeam Functions
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 143
3