2008 CHRYSLER PT CRUISER rear view mirror

[x] Cancel search: rear view mirror

Page 135 of 488

CHRYSLER PT CRUISER 2008 1.G Owners Manual 6. Raise the handle into the stowed position.
7. Close the convertible top motor bypass screw by
turning the screw clockwise until it stops. Tighten the
screw securely.
NOTE:Failure to tighten the byp

Page 136 of 488

CHRYSLER PT CRUISER 2008 1.G Owners Manual Annoying headlight glare can be reduced by moving the
small control under the mirror to the night position
(toward rear of vehicle). The mirror should be adjusted
while set in the day position (toward

Page 139 of 488

CHRYSLER PT CRUISER 2008 1.G Owners Manual NOTE:The UConnectŸ system use requires a cellular
phone equipped with the Bluetooth9Hands-Free Profile,9
version 0.96 or higher. See www.chrysler.com/uconnect
for supported phones.
UConnectŸ allows

Page 184 of 488

CHRYSLER PT CRUISER 2008 1.G Owners Manual Use the hood prop rod clipped to the drivers side of the
engine compartment to secure the hood in the open
position. Place the hood prop at the location stamped into
the inner hood surface.
To preven

Page 185 of 488

CHRYSLER PT CRUISER 2008 1.G Owners Manual NOTE:The lights will remain on until the switch is
pressed a second time, so be sure they have been turned
off before leaving the vehicle. They will not turn off
automatically.
Map/Reading Lights (Con

Page 415 of 488

CHRYSLER PT CRUISER 2008 1.G Owners Manual ²For grease stains, apply MopartMulti-Purpose
Cleaner to a clean, damp cloth and remove stain. Use
a fresh, damp towel to remove soap residue.
²Do not use any solvents or protectants on Yes Essen-
t

Page 424 of 488

CHRYSLER PT CRUISER 2008 1.G Owners Manual REPLACEMENT BULBS
LIGHT BULBS Ð Inside Bulb No.
Center Console Floor Lamp................. T37
Climate Controls......................6233137
Console Gear Selector...................PC194
Dome Light (

Page 477 of 488

CHRYSLER PT CRUISER 2008 1.G Owners Manual Headlights
Bulb Replacement...................... 425
Cleaning............................ 415
High Beam........................189,234
High Beam/Low Beam Select Switch........ 189
Passing............
Page:   1-8 9-16 next >