2008 CHRYSLER ASPEN ECU

should then be determined separately to be sure that the
load is properly distributed over front and rear axle.
Weighing the vehicle may show that the GAWR of either
the front or rear axles has been exceeded but the total
load is within the specified GVWR. If so, weight must be
shifted from front to rear or rear to front as appropriate
until the specified weight limitations are met.
Store heavier items down low and be sure that the weight
is distributed equally. Stow all loose items securely before
driving.
Improper weight distribution can have an adverse effect
on the way your vehicle steers and handles and the way
the brakes operate.WARNING!
Do not load your vehicle any heavier than the GVWR
or the maximum front and rear GAWR. If you do,
parts on your vehicle can break, or it can change the
way your vehicle handles. This could cause you to
lose control. Also, overloading can shorten the life of
your vehicle.
A loaded vehicle is shown in the following example. Note
that neither GVWR nor GAWR capabilities are exceeded.
Overloading can cause potential safety hazards and
shorten service life.
NOTE: The weights shown in this chart are not the
weights for your vehicle. Also, the amount of load
added to both the front and rear axles can be computed
344 STARTING AND OPERATING

WARNING!
Improper towing can lead to an injury accident.
Follow these guidelines to make your trailer towing
as safe as possible:
Make certain that the load is secured in the trailer
and will not shift during travel. When trailering
cargo that is not fully secured, dynamic load shifts
can occur that may be difficult for the driver to
control. You could lose control of your vehicle and
have an accident.
²When hauling cargo or towing a trailer, do not over-
load your vehicle or trailer. Overloading can cause a
loss of control, poor performance or damage to brakes,
axle, engine, transmission, steering, suspension, chas-
sis structure or tires.
²Safety chains must always be used between your
vehicle and trailer. Always connect the chains to the
frame or hook retainers of the vehicle hitch. Cross the
chains under the trailer tongue and allow enough
slack for turning corners.
²Vehicles with trailers should not be parked on a grade.
When parking, apply the parking brake on the tow
vehicle. Put the tow vehicle automatic transmission in
PARK. With a manual transmission, shift the transmis-
sion into REVERSE. And with 4-wheel drive vehicles,
make sure the transfer case is not in NEUTRAL.
Always, block or9chock9the trailer wheels.
²GCWR must not be exceeded.
²Total weight must be distributed between the tow
vehicle and the trailer so that the following four
ratings are not exceeded:
1. GVWR
STARTING AND OPERATING 353
5

Jack Location
The scissor jack and tire changing tools are stowed under
the second row seat.
The jack is secured in place with a winged stud and a
fixed stud. It is very important to secure the jack tightly
in place by engaging the slot in the base to the fixed stud
under the middle seat. The winged stud inserts through
the eyelet in the end of the jack's worm screw.
Jack Location
368 WHAT TO DO IN EMERGENCIES

WARNING!
Carefully follow these tire changing warnings to help
prevent personal injury or damage to your vehicle:
²Always park on a firm, level surface as far from the
edge of the roadway as possible before raising the
vehicle.
²Block the wheel diagonally opposite the wheel to
be raised.
²Apply the parking brake firmly before jacking.
²Never start the engine with the vehicle on a jack.
²Do not let anyone sit in the vehicle when it is on a
jack.
²Do not get under the vehicle when it is on a jack.
²Only use the jack in the positions indicated.
²If working on or near a roadway, be extremely
careful of motor traffic.
²To assure that spare tires, flat or inflated, are
securely stowed, spares must be stowed with the
valve stem facing the ground.
To Stow The Flat Or Spare
Turn the wheel so that the valve stem is down. Slide the
wheel retainer through the center of the wheel and
position it properly across the wheel opening.
For convenience in checking the spare tire inflation, stow
with the valve stem toward the rear of the vehicle.
Rotate the winch mechanism until the wheel is drawn
into place against the underside of the vehicle. Continue
to rotate until you feel the winch mechanism slip or click
two times. It cannot be overtightened. Push against the
tire several times to be sure it is firmly in place.
WHAT TO DO IN EMERGENCIES 375
6

Ensure nylon tubing in these areas has not melted or
collapsed.
Inspect all hose clamps and couplings to make sure they
are secure and no leaks are present.
NOTE:Fluids such as oil, power steering fluid, and
brake fluid are used during assembly plant operations to
ease the assembly of hoses to couplings. Therefore, oil
wetness at the hose-coupling area is not necessarily an
indication of leakage. Actual dripping of hot fluid when
systems are under pressure (during vehicle operation),
should be noted before hose is replaced based on leakage.
You are urged to use only the manufacturer's specified
hoses and clamps, or their equivalent in material and
specification, in any fuel system servicing. It is manda-
tory to replace all clamps that have been loosened or
removed during service. Care should be taken in install-
ing new clamps to ensure they are properly torqued.Positive Crankcase Ventilation (PCV) Valve
Proper operation of the crankcase ventilation system
requires that the PCV valve be free of sticking or plug-
ging because of deposits. Deposits can accumulate in the
PCV valve and passage with increasing mileage. Have
the PCV valve, hoses, and passages checked for proper
operation at the intervals specified. If the valve is
plugged or sticking, replace with a new valve ±Do not
attempt to clean the PCV valve!Check ventilating hose
for indication of damage or plugging with deposits.
Replace if necessary.
Brake System
Power Disc Brakes (Front and Rear)
Disc brakes do not require adjustment; however, several
hard stops during the break-in period are recommended
to seat the linings and wear off any foreign material.
408 MAINTAINING YOUR VEHICLE

Center High-Mounted Stoplight
1. Remove two screws securing stoplight housing assem-
bly to the liftgate.2. Turn socket 1/4 counterclockwise and free from hous-
ing.
3. Pull bulb straight from socket to remove.
434 MAINTAINING YOUR VEHICLE

ABS (Anti-Lock Brake System)............205,290
Adding Fuel........................... 336
Adjustable Pedals....................... 155
Air Cleaner, Engine (Engine Air Cleaner Filter) . . . 394
Air Conditioner Maintenance............249,398
Air Conditioning........................ 249
Air Conditioning, Operating Tips............ 261
Air Conditioning, Rear Zone................ 253
Air Conditioning Refrigerant.............398,399
Air Conditioning System................249,398
Air Filter........................384,385,394
Air Pressure, Tires....................313,321
Airbag.............................53,213
Airbag Light..........................61,76
Alarm, Panic............................ 24
Alarm (Security Alarm).................18,205
Alignment and Balance................... 320
Alterations/Modifications, Vehicle............. 8
Antenna, Satellite Radio................... 238Antifreeze (Engine Coolant)...........403,404,436
Disposal............................ 406
Anti-Lock Brake System (ABS)............290,294
Anti-Lock Warning Light.................. 205
Anti-Theft System.....................18,205
Appearance Care........................ 414
Arming Theft System (Security Alarm)......... 19
Assistance Towing....................... 101
Audio Systems (Radio).................217,220
Auto Unlock, Doors...................... 170
Automatic Dimming Mirror...............84,88
Automatic Door Locks..................31,170
Automatic Headlights.................... 147
Automatic Transaxle....................12,274
Automatic Transmission.............271,274,410
Adding Fluid......................... 411
Fluid and Filter Changes................. 412
Fluid Level Check...................... 410
Fluid Type........................... 438
458 INDEX

Child Restraint.......................64,66
Extender............................. 53
Front Seat............................ 42
Pretensioners.......................... 50
Reminder............................ 204
Seats................................. 120
Adjustment.......................... 120
Cleaning............................ 416
Fold and Tumble Rear................127,129
Heated............................. 124
Lumbar Support....................... 122
Memory............................. 137
Rear Folding.......................127,129
Reclining............................ 121
Security Alarm (Theft Alarm).............18,205
Selection of Coolant (Antifreeze)..........403,437
Selection of Oil......................... 391
Sentry Key (Immobilizer)................... 13
Sentry Key Programming................... 15Sentry Key Replacement................... 15
Service and Maintenance................389,440
Service Assistance....................... 449
Service Contract......................... 451
Service Manuals........................ 453
Setting the Clock................215,218,221,226
Settings, Personal........................ 170
Shifting
Automatic Transmission................. 274
Transfer Case......................... 280
Transfer Case, Shifting into Transfer Case
Neutral (N).......................... 361
Transfer Case, Shifting out of Transfer Case
Neutral (N).......................... 362
Shoulder Belt Upper Anchorage.............. 46
Shoulder Belts........................... 42
Signals, Turn.....................149,203,431
Snow Chains (Tire Chains)................. 321
Snow Plow............................ 359
472 INDEX