2008 AUDI S6 technical specifications

Fuel supply and filling your fuel tank
Blend of gasoline and ethanol (grain alcohol or ethyl alcohol}
• Anti-knock index must be 87 AKI or higher.
• Blend must not contain more than 10% ethanol.
Blend of gasoline and MTBE
• Anti-knock index must be 87 AKI or higher.
• Blend must contain not more than 15% MTBE.
Seasonally adjusted gasoline
Many gasoline grades are blended to perform especially well for
winter or summer driving. During seasonal change -over, we suggest
that you fill up at busy gas stations where the seasonal adjustment
is more likely to be made in time.
0 Note
• Methanol fuels which do not meet these requirements may
cause corrosion and damage to plastic and rubber components in
the fuel system.
• Do not use fuels that fail to meet the specified criteria in this
chapter.
• If you are unable to determine whether or not a particular fuel
blend meets the specifications, ask your service station or its fuel
supplier.
• Do not use fuel for which the contents cannot be identified.
• Fuel system damage and performance problems resulting from
the use of fuels different from those specified are not the responsi ­
bility of Audi and are not covered under the New Vehicle or the
Emission Control System Warranties.
• If you experience a loss of fuel economy or driveability and
performance problems due to the use of one of these fuel blends,
we recommend that you switch to unblended fuel. •
Gasoline additives
A major concern among many auto manufacturers is carbon
deposit build-up caused by the type of gasoline you use.
Although gasoline grades differ from one manufacturer to another,
they have certain things in common. All gasoline grades contain
substances that can cause deposits to collect on vital engine parts,
such as fuel injectors and intake valves. Although most gasoline
brands include additives to keep engine and fuel systems clean,
they are not equally effective.
Audi recommends using TOP TIER Detergent Gasoline. For more
information on TOP TIER Detergent Gasoline, please go to the offi­
cial website (www.toptiergas.com).
After an extended period of using inadequate fuels, carbon deposit
build-ups can rob your engine of peak performance.
(D Note
Damage or malfunction due to poor fuel quality is not covered by
the Audi New Vehicle Limited Warranty. •
Fuel tank
Fuel filler neck
The fuel filler neck is located on the right rear side panel behind the
fuel filler flap.
If the power locking system should fail, you can still open the flap
manually - for detailed instructions see=>
page 295.
You can find the fuel tank capacity of your vehicle in Technical Data
=> page 363. .,_

Checking and filling Ill
--------------~-
•
-Now remove the clamps for the charging equipment.
- Close the red cover on the positive pole.
- Close the hood
~ page 297.
A discharged battery can freeze at temperatures of only O °C. Allow
a frozen battery to thaw completely before attempting to charge it
~ & .However, we recommend not using a thawed battery again
because the battery casing can be cracked due to ice formation and
can leak battery acid.
Battery charging (Maximum charging rate of 30
amps/14.8 Volt)
When charging at /ow voltages (e.g. with a trickle charger), the
battery cables do not have to be disconnected first. The battery caps
should
not be opened when charging a battery.
I t is not necessary to remove the battery from the luggage compart­
ment.
Fast charging the battery (charging rate above 14.8
Volts)
For technical reasons do not use a battery charger that uses voltage
greater than 14.8 Volts to charge your vehicle's battery.
& WARNING
Charging a battery can be dangerous.
• Always follow the operating instructions provided by the
battery charger manufacturer when charging your battery.
• Never charge a frozen battery. It may explode because of gas
trapped in the ice. Allow a frozen battery to thaw out first.
• Do not reuse batteries which were frozen. The battery housing
may have cracked and weakened when the battery froze .
• Charge the battery in a well ventilated area. Keep away from
open flame or electrical spark. Do not smoke. Hydrogen gas gener­
ated by the battery is explosive.
&_ WARNING (continued)
• To reduce the danger of explosion, never connect or disconnect
charger cables while the charger is operating.
• Battery acid that may spill during charging should be washed
off with a solution of warm water and baking soda to neutralize
the acid.
0 Note
Never use a fast charger as a booster to start the engine. This will
seriously damage sensitive electronic components, such as control
units, relays, radio, etc., as well as the battery charger. •
Battery replacement
The new battery must have the same specifications and
dimensions as the original equipment battery.
Intelligent energy management in your vehicle is responsible for
distributing the electrical energy throughout your vehicle
~ page 265. The intelligent energy management system will keep
the engine battery charged better then vehicles without this system.
To make sure the additional electrical energy is available once again
after you have changed the battery, we recommend that you install
batteries of the same type and manufacture only (the same as those
installed at the time your vehicle was delivered). Specifications are
listed on the battery housing. Your authorized Audi dealer will then
code the battery management control unit.
If it is not possible to use a battery of this type, the new battery must
have the same capacity, voltage (12 volts), amperage, construction
and plug sealing .
When installing the battery, make sure the ignition and all electrical
consumers are turned off.
~
Vehicle care I t •

______________________________________________ A_ l_,_ p _h_ a_ b_e _t_i c_ a _ l _in _ d_e _ x __ lllll
T ank flap
Un locking the fuel fi ller flap by hand 295
Technical modifications .... .... ...... 368
Temperature Climate controls .. .... .... ... .... . 114
Setting for the driver's and front passen- ger's side .. ... ... ..... .... ... .. 114
Tether strap ... .... .... .. ... ........ 254
Securing the upper tether strap 255
The first 1,000 miles (1,500 km) and afterwards .... .. .. .. ... ...... .. 267
Tie-downs . ... .... .... .... ....... .. 201
Tilt sensors . .... .... ...... .... .... .. 62
Tips for the environment Saving fuel . ..... ... .... ... ..... . 102
Using the air conditioner only when necessary .. ..... ... .... ... .... . 119
tiptronic® .. ... ... .. .... .... ....... . 153
Automatic Shift Lock (ASU . ...... .. 155
Driving ............. ....... ..... 153
Dynamic shift program ............ 156
Fail-safe mode ... ... ... .. ...... .. 158
Kick-down ... .... .... .... ... .... . 156
Manual shift program ........ .... . 157
Se lector lever ... .... .... ... .... .. 154
Tire pressure ..... .. .... .... ....... . 319
Tire pressure monitoring system ... .... 43
Changing wheels .... .... ..... .... . 46
L earning process . .... .... ... .... .. 45
Loss of air pr essure ........ ... .. 20, 44
Mal functions ...... ...... .... ..... 46
Sensors . .......... .............. 327
Storing tire pressures .... .... .... .. 45
Controls and equip­
ment Safety first
Tires and wheels ..
...... .... . .... 327 Towing
Valves ..... .. ...... ........ ..... 327 Front eyelet .. .. .. ... ... .. .... .... 354
Tire service life .... . .. .. ...... .... .. 323 Rear eyelet
... .... ... ... ..... ... . 355
Tires .... ..... .. ... ... .. .... .... ... 313 Tow truck procedures
..... ... .... . 354
Replacing .... .... .... ..... .. .... 327 Trailer towing .
.... .... ... .... ..... .. 272
Service life . .... . .. .. .... .... .... 323 Operating instructions .
...... ... .. 273
speed rating letter code .... ... .... 326 Technical r
equirem ents ... .... 272 , 273
Tire manufacturing date .... .... ... 326 Trailer towing tips .
... ... . .. .. .... 274
Tire specifications ... ..... ... ... .. 326 Transmission
Tread depth .... . .. .. ...... .. .... 323
tiptronic® ...... .... .. .. .... ..... 153
Uniform tire quality grading ... ..... 328
Transport Canada . .. ... .... .. ... ... . 365
Winter tires ... .... .... .... .... ... 329
Tread Wear Indicator (TWll ... .... .... . 323
Tires and vehicle load limits ... ...... . 321
Trip computer
Tires and wheels Fuel consumption ... .. .. . ... ...... 40
Checking tire pressure .......... .. 319
Mileage . ..... .... .... ...... .... .. 40
Cold tire inflation pressure .. .... ... 317
Single-trip memory .. .... . .... .. .. . 41
Dimensions ... ... ..... ... .... .... 325
Total-trip memory .... .... .... ... .. 41
Genera l notes ... ...... ..... .... .. 313
Trip odometer .. ... .. .... .... ... .. .. . 15
Glossary of tire and loading termino logy
What does it mean when dEF appears in
314 the trip odometer display? ......... 15
New tires and wheels .. .... .... ... 325
Trunk
Replacing .... .... .... ...... ... .. 325
See Rear lid ... .... .... ... .... .... . 58
Snow chains .. .... ... .... .... .... 330
Tire pressure monitoring system .. .. 327
Tires and vehicle load limits . .. . .... 321
Wheel bolts .. ....... ... .. ... ..... 331 Trunk escape handle
...... .. . .... ... . 336
Turn signals . .... .... .... ...... .... .. 74
Warning/indicator lights ...... .... .. 20
Winter tires .. ... ... .. ... .... .... . 329
Tires/Wheels
u
Low aspect ratio tires . ...... .. .... 332
Undercoating ...... .... ....... .. ... . 284
Tire pressure monitoring system .. 20 , 43
Unfastening safety be lts ...... .... .. . . 209
Tools ... .... .... ... ..... ... .... .... 337
Unidirectiona l tires ... .... ...... .... . 313
Torn or frayed safety be lts ... .. . ..... . 205
Uniform tire quality grading .. .... ... . 328
Touch-up pa int . .... ... .... .... ..... 282
Vehicle operation Vehicle care Do-it-yourself service Technical data