µµ
Î
Î
Î
Î
Î Î
Î
Î
Specif ications
344
Weights
Dimensions
Capacities
Air Conditioning
Seating Capacities Capacities
189.3 in (4,809 mm)
4.5 US qt (4.3
)
2.17 US gal (8.2
)
2.11 US gal (8.0)
1.69 US gal (6.4
)
1.72 US gal (6.5)
62.0 in (1,576 mm)
62.1 in (1,577 mm)
107.9 in (2,740 mm)
56.7 in (1,441 mm)
75.4 in (1,916 mm)
See the certification label attached
to the driver’s doorjamb.
Gross vehicle weight rating
Length
Width
Height
Wheelbase
Track 189.8 in (4,822 mm)
Fuel tank
Refrigerant type
Charge quantity
Lubricant type HFC-134a (R-134a)
17.6 19.4 oz (500 550 g) ND-OIL8
Total
Front
Rear 3
2
5 4.2 US qt (4.0
)
Engine
coolant
Engine oil
Automatic
transmission
fluid
Manual
transmission
fluid
Windshield
washer
reservoir 5.3 US qt (5.0)
3.1 US qt (2.9)
7.9 US qt (7.5)
8.1 US qt (7.7)
2.2 US qt (2.1)
2.6 US qt (2.5)
2.6 US qt (2.5
)
4.8 US qt (4.5)
Including the coolant in the reserve tank and that remaining in the
engine
Reserve tank capacity: 0.16 US gal (0.6
)
Excluding the oil remaining in the engine
Approx.
Front
Rear
Type S
Type S
:
1:
2:
3:Change
Manual
Automatic
Total Manual
Automatic
Change Including filter
Without filter
Total
Change
Total
Change
Total
U.S. Vehicle
Canada Vehicle
17.1 US gal (64.7)
1
2
3
\f—\f—
y
y
(%\fy\fy
2008 TL
The tires on your vehicle meet all
U.S. Federal Saf ety Requirements.
All tires are also graded f or
treadwear, traction, and temperature
perf ormance according to
Department of Transportation
(DOT) standards. The f ollowing
explains these gradings.
Quality grades can be f ound where
applicable on the tire sidewall
between tread shoulder and
maximum section width. For
example:
All passenger car tires must conf orm
to Federal Saf ety Requirements in
addition to these grades.The treadwear grade is a compara-
tive rating based on the wear rate of
the tire when tested under controlled
conditions on a specif ied government
test course. For example, a tire
graded 150 would wear one and one-
half (1 1/2) times as well on the
government course as a tire graded
100. The relative perf ormance of
tires depends upon the actual condi-
tions of their use, however, and may
depart signif icantly f rom the norm
due to variations in driving habits,
service practices and dif f erences in
road characteristics and climate.
The traction grades, f rom highest to
lowest, are AA, A, B, and C. Those
grades represent the tire’s ability to
stop on wet pavement as measured
under controlled conditions on
specif ied government test surf aces
of asphalt and concrete. A tire
marked C may have poor traction
perf ormance.
Warning: The traction grade
assignedtothistireisbasedon
straight-ahead braking traction tests,
and does not include acceleration,
cornering, hydroplaning, or peak
traction characteristics.
Unif orm T ire Quality Grading
T readwear 200
Traction AA
Temperature A T readwear T raction
DOT Tire Quality Grading (U.S. Vehicles)
346
\f—\f—
y
y
(%\fy\f
y
2008 TL
µ
µ
µ
µ
µ
µ µ
The tires that came on your vehicle
have a number of markings. Those
you should be aware of are described
below. Whenever tires are replaced, they
should be replaced with tires of the
same size. Below is an example of
tire size with an explanation of what
each component means.
Vehicletype(Pindicates
passenger vehicle).
Tire width in millimeters.
Aspect ratio (the tire’s section
height as a percentage of its
width).
Tire construction code (R
indicates radial).
Rim diameter in inches. Speed symbol (an
alphabetical code indicating
the maximum speed rating).
Load index (a numerical code
associated with the maximum
load the tire can carry).
P
R
17
235
45 93
W
Tire Labeling
Tire Size
348
Tire Size
(1)
(1)
Tire Identification Number (TIN)
(3) Maximum Tire Pressure
(4) Maximum Tire Load (2)
(3)
(4)
(2)
(1)
TIRE LABELING EXAMPLE
P235/45R17 93W
\f—\f—
y
y
(%\fy\fy
2008 TL
