Page 177 of 433
CONT INUED
On RDX model
Audio System
Operating the CD Changer
Features
173
Normal mode MP3/WMA modeSCAN (D-SCAN) INDICATOR RPT (D-RPT) INDICATOR
WMA MODE
INDICATOR
MP3 MODE
INDICATOR
RDM (F-RDM)
INDICATOR
RPT (F-RPT)
INDICATOR
RDM
INDICATOR
DISC NUMBER
DISC INDICATORTRACK NUMBER FOLDER NUMBER
SCAN (F-SCAN)
INDICATOR
VOLUME LEVEL
U.S. model is shown.
\f—\f—\f
y
y
()
\fy\f
y
2008 RDX
Page 178 of 433
Audio System
174
LOAD BUTTONDISC SLOT EJECT BUTTON
DISC LOAD INDICATOR
CD/AUX BUTTON
RPT BUTTON SCAN BUTTON
U.S. model is shown.
DISP/MODE BUTTON
TUNE/FOLDER BAR
A.SEL/RDM BUTTON
PWR/VOL KNOBPRESET BARS
SEEK/SKIP BAR
\f—\f—\f
y
y
()
\fy\f
y
2008 RDX
Page 179 of 433
Your audio system has an in-dash
CD changer that holds up to six CDs,
providing several hours of
continuous entertainment. You
operate this CD changer with the
same controls used f or the radio.
To load CDs or operate the CD
changer, the ignition switch must be
in the ACCESSORY (I) or ON (II)
position.For best results when using CD-R or
CD-RW discs, use only high quality
discs labeled f or audio use. When
recording a CD-R or CD-RW, the
recordingmustbeclosedinorder
f or the disc to be played by the CD
player.
You cannot load and play 3-inch
(8-cm)discsinthissystem.
Video CDs and DVDs will not work
in this unit.
The disc changer can play these disc
formats:
The disc packages or jackets should
have one of these marks. The changer can also play MP3 or
WMA format (see page ).
CD (CD-DA)
CD-R/RW 177
CONT INUED
Audio System
Features
175
Do not use CDs with adhesive labels.
The label can curl up and cause the CD
to jam in the unit.
\f—\f—\f
y
y
()
\fy\f
\fy
2008 RDX
Page 180 of 433

To load a single disc:Press and release the LOAD
button on the changer unit. You
will see ‘‘BUSY’’ on the center
display, and the disc load indicator
turns red and starts blinking.
Insert a disc into the disc slot
when the disc load indicator turns
green and ‘‘LOAD’’ appears on the
center display at the same time.
Insert the disc only about half way;
the drive will pull it in the rest of
the way. You will see the disc
indicator blinking on the center
display.
To load multiple discs in one
operation:
When the disc load indicator turns
green and ‘‘LOAD’’ appears on the
center display again, insert the
next CD in the slot.
Do not try to insert a disc until
‘‘LOAD’’ appears. You could
damage the audio unit.
Repeat steps 1 through 3 until all
six positions are loaded. If you are
not loading all six positions, press
the LOAD button again after the
last CD has loaded. ‘‘DISC READ’’
appears on the center display, then
the system begins playing the last
CD loaded.
If you stop loading discs bef ore all
six positions are f illed, the system
will wait f or 10 seconds, stop the load
operation, and begin playing the last
disc loaded.
Press and hold the LOAD button
on the changer unit until you hear
a beep. You will see ‘‘BUSY’’ on
the center display, and disc load
indicator turns red and starts
blinking.
Insert the disc into the disc slot
when the disc load indicator turns
green and ‘‘LOAD’’ appears on the
center display at the same time.
Insert it only half way; the drive
will pull it in the rest of the way.
You will see ‘‘BUSY’’ on the center
display, and the disc load indicator
turns red again and blinks as the
CD is loaded.
Do not try to insert a disc until
‘‘LOAD’’ appears. You could
damage the audio unit.
1.
2.
3.
1.
2. 4.
Audio System
L oading CDs in the Changer
176
\f—\f—\f
y
y
()
\fy\f
y
2008 RDX
Page 181 of 433

µ
CONT INUED
The CD changer can play CD-Rs and
CD-RWs compressed in MP3 and
WMA format. When playing a disc in
MP3 or WMA, you will see ‘‘MP3’’ or
‘‘WMA’’ on the center display. A disc
can support more than 99 f olders,
and each folder can hold up to 255
playable f iles.
When there are more than 99 f olders
in a disc, the center display only
shows two digits.
If the disc has a complex structure, it
will take a while to read the disc
before the system begins to play it.
Youwillsee‘‘DISCREAD’’onthe
center display, then the system
begins to play the CD.
You can load a disc(s) in any mode
(AM,FM,XMradio,orAUX)if you
do not select an empty position.
If you press the LOAD button while
a disc is playing, the system will stop
playing that disc and start the
loading sequence. It will then play
the disc just loaded.
You can load a CD into an empty
position while a CD is playing. Select
the empty position (the disc
indicator is not shown on the center
display) by pressing the appropriate
side of the preset bars. The current
CD stops playing and starts the
loading sequence. The CD just
loaded will play. Select the CD changer by pressing
the CD/AUX button. You will see
‘‘CD’’ on the center display. The
system will begin playing the last
selected CD in the CD changer. You
will see the disc and track numbers
displayed.
When the system reaches the end of
the disc, the system will advance to
the next disc and begin to play. To
select a dif f erent disc, press an
appropriate side of the preset bar (1
6). If you select an empty position
in the CD changer, the system will
try to load the CD in the empty slot.
3.
Audio System
Playing an MP3/WMA Disc
To Play a CD
Features
177
\f—\f—\f
y
y
()
\fy\f
y
2008 RDX
Page 182 of 433

The specif ications of the compatible
MP3 f ile are:
Sampling f requency: 32/44.1/48 kHz
(MPEG1), 24, 22.05, 16 kHz
(MPEG2)
Bit rate: 32/40/48/56/64/80/96/
112/128/160/192/224/256/320 kbps
(MPEG1), 8/16/24/32/40/48/56/
64/80/96/112/128/160 kbps
(MPEG2)
Compatible with variable bit rate and
multi-session.
Maximum layers
(including ROOT): 8 layers
The specif ications of the compatible
WMA f ile are:
Sampling f requency: 32/44.1/48 kHz
Bit rate: 48/64/80/96/128/160/192
kbps
Compatible with variable bit rate and
multi-session.
Maximum layers (including ROOT):
8 layersEach time you press the DISP/
MODE button while playing a CD
(CD-DA), the center display changes
f rom album name, to track name, to
artist name, and then to normal
display. If the disc was not recorded
with CD-TEXT, ‘‘NO INFO’’ will be
shownonthecenterdisplay.
If the title is too long, it will not show
all at once. Press and hold the DISP/
MODE button, and the rest of the
title will show on the center display.
You will also see the album and track
name (CD-TEXT), or the f older and
f ile name (MP3/WMA) under these
conditions:
When you insert a disc, and the
system begins to play.
Each time a new track, file, or
folder plays.
When playing a disc compressed in
MP3/WMA format, the display
changes f rom f older name, to f ile
name, to artist tag, to album tag, to
track tag, and then to normal display
each time you press the DISP/
MODE button. If the disc was not
recorded with this inf ormation, ‘‘NO
INFO’’willbeshownonthecenter
display.Name Display Funct ion
Audio System
178
\f—\f—\f
y
\fy
()
\fy\f
y
2008 RDX
Page 183 of 433

µµ
µ
While a disc is playing you can use
the SEEK/SKIP bar to select
passages and change tracks (f iles in
MP3/WMA mode).
In MP3/WMA mode, use the
TUNE/FOLDER bar to select
f olders in the disc, and use the
SEEK/SKIP bar to change f iles.
Each time you
press and release the side of
the SEEK/SKIP bar, the system
skips forward to the beginning of the
next track (f ile in MP3/WMA mode).
Press and release the side of
the bar to skip backward to the
beginning of the current track/f ile.
Press it again to skip to the
beginning of the previous track/f ile. To
select a dif f erent f older, press and
releasethe sideof theTUNE/
FOLDERbartomovetothe
beginning of the next f older. Press
and release the side of the bar
to move to the beginning of the
current f older. Press it again to skip
to the beginning of the previous
f older.
This f eature, when
activated, continuously replays the
current track (f ile in MP3/WMA
mode). To activate it, press and
release the RPT button. You will see
‘‘RPT’’ on the center display. To turn
of f this f eature, press the RPT
button for more than 2 seconds.
To move rapidly within a track/f ile,
press and hold the or side
of the SEEK/SKIP bar.In MP3/WMA mode
CONT INUED
T o Change or Select T racks/FilesSEEK /SK IP
FOLDER SELECTION
REPEAT
Audio System
Features
179
\f—\f—\f
y
y
()
\fy\f
y
2008 RDX
Page 184 of 433

µ
µ µ
µ
In MP3/WMA mode In MP3/WMA mode
This feature,
when activated, replays all the f iles
on the current f older in the order
they are compressed in MP3/WMA.
To activate f older repeat mode, press
the RPT button twice. You will see
‘‘F-RPT’’ on the center display. Press
andholdtheRPTbuttonformore
than 2 seconds to turn off this
feature.
Press the RPT
button twice to continuously replay
the current CD. In MP3/WMA mode,
press the RPT button three times.
You will see ‘‘D-RPT’’ on the center
display. Press and hold the RPT
button for more than 2 seconds to
turn off this feature. The scan f unction samples
all the tracks (f iles in a f older in
MP3/WMA mode) of the current
disc in the order they are recorded
on the CD. To activate this feature,
press and release the SCAN button.
You will see ‘‘SCAN’’ and the track/
f ile number f lashing on the center
display. The system will then play
the track/f ile f or approximately 10
seconds. To hear the rest of the
track/file, press and hold the SCAN
button for more than 2 seconds. If
you do nothing, the system will then
play the f ollowing tracks/f iles f or 10
seconds each. When the system
f inishes scanning all the tracks/f iles
in the current disc, the system
returns to the track/f ile it f irst
started scanning with, scan is
canceled and the system begins to
play that track/file normally. The folder scan
f unction samples the f irst f ile of each
f older of the current disc in the
order they are compressed in MP3/
WMA. To activate this feature, press
the SCAN button twice. The first file
of each f older plays f or about 10
seconds. You will see ‘‘F-SCAN’’ and
the f older number f lashing on the
center display. To hear the rest of
the f ile in the f older currently
scanning, press and hold the SCAN
button for more than 2 seconds.
When the system f inishes scanning
all the f olders of the current disc, the
system returns to the f older it
started scanning with, f older scan is
canceled and the system begins to
play that folder normally.
Each time you press and release the
RPT button, the mode changes from
repeat to f older repeat, disc repeat
then to normal playing.
FOLDER REPEAT
DISC REPEAT SCAN
FOLDER SCAN
Audio System
180
\f—\f—\f
y
y
()
\fy\f
y
2008 RDX