Page 86 of 194
5
86
LIGHTS STALK
Lights off Automatic switching on
of lights.
Side lights Dipped/main beam
headlamps Dipped/Main beam change
Pull the stalk fully towards you.
Front fog lamps and rear
fog lamp
Rotate the ring
B or C forwards to
switch on and backwards to switch
off. The status is displayed by the in-
dicator light on the instrument panel.
V e h i c l e s fi t t e d w i t h a r e a r f o g
lamp (ring B)
Rear fog lamp
V e h i c l e s fi t t e d w i t h f r o n t f o g
lamps and a rear fog lamp (ring C) Front fog lamps (1st rotation
of the ring forwards)
These operate with the side lights
and dipped headlamps.
Lights on
With the ignition off, a buzzer sounds
when the driver's door is opened, if
you have left your lights on.
If the dipped headlamps remain
on, with the ignition off, they will
be switched off automatically after
thirty minutes maximum to prevent
discharging of the battery.
This can only operate with the dipped
and main beam headlamps.
Front and rear lights
Selection is by turning ring
A .
Page 87 of 194
5
87
Front fog lamps and rear
fog lamp (2nd rotation of
the ring forwards).
Note : to switch off the
rear fog lamp and the front fog
lamps, turn the ring backwards twice
in succession.
Notes:
When the main beam headlamps are
switched on, the front fog lamps are
switched off.
When the lights are switched off au-
tomatically, with the engine running,
the front fog lamps and the side lights
will remain on (turn the ring back-
wards to switch the fog lamps off).
D i r e c t i o n i n d i c a t o r s ( fl a s h e r s )
Left
: downwards.
Right
: upwards.
When the lights are switched
off automatically or when
the dipped headlamps are
switched off manually, with
the engine running, the fog
lamps and the side lights
will remain on.
In good or rainy weather, both day
and night, the front fog lamps and
the rear fog lamp are dazzling and
are prohibited.
Do not forget to switch them off when
they are no longer needed. F o l l o w m e h o m e l i g h t i n g
Leaving the dipped headlamps on
temporarily, after switching off the
ignition, facilitates the driver's exit
from the vehicle when the light is
poor.
S w i t c h i n g o n
W i t h t h e i g n i t i o n o f f , " fl a s h " t h e
headlamps.
A s e c o n d " h e a d l a m p fl a s h "
switches the function off.
S w i t c h i n g o f f
The follow me home lighting is
switched off automatically following
l o c k i n g o f t h e d o o r s , a f t e r a s p e c i fi e d
time.
Page 128 of 194
9
122
Rear lights
1. Brake/side lights
(P21 W/5 W).
2. Direction indicators (P21 W).
3. Reversing light (P21 W), right
side.
Fog lamp (P21 W), left side.
These 4 bulbs are changed by re-
moving the light:
R e m o v e t h e a c c e s s fl a p i n t h e
corresponding boot side trim to
access the light,
R e m o v e t h e t w o l i g h t fi x i n g n u t s
inside the boot,
Unclip the harness,
Remove the light pressing on the
retaining tabs,
Remove the seal,
Remove the bulb holder moving
aside the two tabs A ,
Turn the bulb a quarter of a turn,
Remove the bulb and change it.
Note: if necessary, use the wheel-
brace to remove the nuts.
W h e n r e fi t t i n g , p r o c e e d i n t h e r e -
verse order and take care to position
the bulb holder, the seal and the light
correctly. Third brake light
(4 W 5 W bulbs)
Using a 10 mm box spanner, un-
s c r e w t h e 2 fi x i n g n u t s A .
Release the lamp unit by push-
ing it outwards.
Disconnect the connector and
the rear wash-wipe pipe.
Turn the bulb holder a quarter of
a turn and remove it.
Remove the bulb and change it.
W h e n r e fi t t i n g , p r o c e e d i n t h e r e -
verse order and ensure that the lamp
unit seal and the rear wash-wipe pipe
have been put back in place correctly.
Do not tighten the nuts more than is
necessary at the risk of breaking the
light.
Number plate lights (W 5 W)
Insert a thin screwdriver into one
of the external holes of the lens.
Push it outwards to unclip it.
Remove the lens.
Remove the bulb and change it.