2008.5 Citroen C5 stop start

129
9
D R I V I N G
SITUATIONCONSEQUENCES
4
Display of messages " Parking brake faulty " ultyand " Anti roll-back fault " and of the following faultwarning lamps:
and/or fl ashing
- The automatic functions are deactivated.- The hill start assist is unavailable. To apply the electric parking brake:  Immobilise the vehicle and switch off the ignition  Pull the control lever for at least 5 seconds or until maximum application.  Switch on the ignition and check that the electric parking brake warning lamps are on. - Application may take longer than in normal operation. - If warning lamp (!) fl ashes or if the warning lamps do not come on when the ignition is switched on, this method does not work. Have it checked by a CITROËN dealer. on when the ignition is switched on, this method switched
To release the electric parking brake:  Switch on the ignition.  Push the control lever and hold it for approximately 3 seconds.
5
Display of message " Parking brake control faulty – automatic mode activated " and the following warning lamps:
and/or fl ashing
- Only the functions for automatic application on switching off the engine and automatic release on acceleration are available.
- Manual application/release of the electric parking brake anddynamic emergency braking are unavailable.
6
Display of message " Parking brake faulty " and of the following warning lamp:
fl ashing
- Application of the parking brake is not guaranteed.
- The parking brake is temporarily unavailable.
It this situation arises:
 Wait approximately 3 minutes.
 After 3 minutes, if the warning lamp is still fl ashing, try to reini-tialise the parking brake, either by pushing and releasing th e control A while pressing the brake pedal or by means of a long pull on control A .
7
Battery fault-Lighting of the battery warning lamp makes it essential to stopthe vehicle as soon as traffi c allows. Stop and immobilise your vehicle.
-Apply the electric parking brake before switching o ff the engine.

181
11
P R A C T I C A L I N F O R M A T I O N
Fuses under the bonnet

After a repair,
carefully refi t
the
cover.
Any repairs on the MAXI fuses
(that give additional protection),
located in the fuseboxes, must
be left to a CITROËN dealer.
Access to the fuses

 Undo each screw by a 1/4 turn. Table of fuses

Fuse N° Rating Function

F1 20 A Engine control unit

F2 15 A Horn

F3 10 A Screen wash pump

F4 10 A Headlamp wash pump

F5 15 A Starter

F6 10 A Air fl ow meter - Directional headlamps -
Diagnostic socket

F7 10 A Automatic selector lever lock - Power steering

F8 25 A Starter

F9 10 A Clutch switch - STOP switch

F10 30 A Starter

F11 40 A Air conditioning blower

F12 30 A Wipers

F13 40 A BSI supply (ignition on)

F14 30 A -

F15 10 A Right-hand main beam

F16 10 A Left-hand main beam

F17 15 A Right-hand dipped beam

F18 15 A Left-hand dipped beam

F19 15 A Starter

F20 10 A Starter

F21 5 A Starter

185
11
P R A C T I C A L I N F O R M A T I O N
ENERGY ECONOMY MODE
System which manages the duration
of use of certain functions to con-
serve a suffi cient level of charge in
the battery.
After the engine has stopped, you can
still use functions such as the audio
and telematics system, windscreen
wipers, dipped headlamps, courtesy
lights, etc. for a maximum combined
duration of thirty minutes.
Switching to economy mode
Once the thirty minutes are over, a
message appears on the multi-func-
tion screen indicating that the vehi-
cle has switched to economy mode
and the active functions are put on
standby.
If the telephone is being used at this
time:
- it will be maintained for 5 minutes with radio-CD hands-free kit,
-
it will be interrupted after 10 minutes with the MyWay audio-navigation
system,
- you can complete your call with the NaviDrive system.
This period may be signifi cantly re-
duced if the battery charge is low. Exiting economy mode
These functions are reactivated
automatically next time the vehicle
is driven.

 In order to resume the use of
these functions immediately,
start the engine and let it run for
a few minutes.
The time available will then be dou-
ble the duration for which the engine
was left running. However, this time
will always be between fi ve and thirty
minutes.
A fl at battery prevents the
engine from starting (refer
to the corresponding para-
graph).

219
QUESTION SOLUTION RESPONSE
The stored stations do not function (no sound, 87.5 Mhz is displayed...).
An incorrect waveband is selected. Press the BAND AST button to return to the waveband (AM, FM1, FM2, FMAST) on whichthe stations are stored.
The traffi c announcement (TA) is displayed. I do not receive any traffi c information.
Tune to a radio station which broadcasts traffi c information. The radio station is not part of the regional traffi c information network.
The quality of reception of the radio station listened to gradually deteriorates or the stored stations do not function (no sound, 87.5 Mhz is displayed...).
The vehicle is too far from the transmitter used b y the station listened to or there is no transmitter in the geographical area th rough which the vehicle is travelling.
The environment (hills, buildings, tunnels, baseme nt car parks...) block reception, including in RDS mode.
The aerial is absent or has been damaged (for exam ple when going through a car wash or into an underground car park).
Activate the RDS function to enable the system to check whether there is a more powerful transmitter in the geographical area.
This phenomenon is normal and does not indicate a failure of the audio equipment.
Have the aerial checked by a CITROËN dealer.
Sound cut-outs of 1 to 2 seconds in radio mode.
During this brief sound cut-out, the RDS searches for any frequency permitting better reception of the station. Deactivate the RDS function if the phenomenon is too frequent and always on the same route.
With the engine off, the audio equipment switches off after a few minutes of use.
When the engine is switched off, the audio equipme nt operating time depends on the battery charge. The switch-off is normal: the audio equipment switches to economy mode and switches off to prevent discharging of the vehicle's battery.
Start the vehicle's engine to increase the battery charge.
The message "the audio system is overheated" appears on the display.
Switch the audio system off for a few minutes to allow the system to cool. In order to protect the installation if the surrounding temperature is too high, the audio equipment switches to an automatic thermal protection mode leading to a reduction of the volume or stopping of the playing of the CD.

10
NAV
5
6
7
1
2
3
4
8
ADDING A STOPOVER
Enter a new address, for example.
Once the new address has been entered, select START GUIDANCE and press OK to confi rm.
Position the stopover on the list and press OK to confi rm.
Press the NAV button.
Press the NAV button again or select the NAVIGATION MENU function and press OK to confi rm.
Select the ADD A STOPOVER function (5 stopovers maximum) and press OK to confi rm.
Select the STOPOVERS function and press OK to confi rm.
NAVIGATION MENU
STOPOVERS
ADD A STOPOVER
NEW DESTINATION INPUT
To change the stopovers, repeat operations 1 to 3 and s and select OPTIMISE ROUTE (select a stopover, delete it or mov e move it on the list using the ring to change the order, confi rm its new position and fi nish using the ring to change the order, confi rm its new position and fi nish with RECALCULATE.
Stopovers can be added to or deleted from the route once the destination has been selected.
Repeat operations 1 to 7 as many times as necessar y then select RECALCULATE and press OK to confi rm.
START GUIDANCE

29
SETUP
TU
PQRS
0
*
11
22
Before using the system for the fi rst time, you are advised to listen to, say and repeat the instructions for use.
Press the SETUP button and select the LANGUAGES AND VOICE FUNCTIONS function. Turn the ring and select VOICE RECO. PARAMETERS. Activate the voice recognition. Select INSTRUCTIONS FOR USE.
VOICE COMMANDS -
VOICE RECO. INITIATION
The phrases to be spoken according to the environm ent of the level 1 selection are indicated in level 2. Speak and NaviDrive 3D acts.
Long press: activates the voice recognition.
LEVEL 1 LEVEL 2 ACTION
VOICE COMMAND USE OF THE COMMAND
GENERAL Help address book Help voice controlHelp mediaHelp navigationHelp telephoneHelp radioCancelCorrection
Access to the address book help Access to the voice reco help Access to the media management help Access to the guidance, navigation help Access to the telephone help Access to the radio help To cancel a voice command which is in progress Request to correct the last voice recognition carried out Clear
RADIO Select stationStation
Read out station list Enter frequencySelect wave band AM FM TA onTA off
Select a radio station Select a radio station using its RDS description from the RADIO list Listen to the list of stations available Listen to the frequency of the current radio station Choose the frequency waveband (AM or FM) Change the frequency waveband to AM Change the frequency waveband to FM Activate the Traffi c Info (TA) Deactivate the Traffi c Info
NAVIGATION Destination inputVoice advice offVoice advice onSave address Start guidance
Abort guidanceNavigate entry POI Search
Command to enter a new destination address Deactivate the spoken guidance instructions Activate the spoken guidance instructions Save an address in the address book Start guidance (once the address has been entered) Stop guidance Start guidance to a fi le in the address book Start guidance to a point of interest

32
1
2
3
3
3
2
RADIO
1
2
3
3
2
2
3
NAV
1
2
4
4
4
4
4
4
4
4
4
4
4
3
3
3
3
2
2
3
3
3
2
2
2
2
2
3
4
2
4
4
4
4
3
3
3
3
4
4
4
2
3
3
3
3
3
3
4
GUIDANCE OPTIONS
guidance criteria
near destination
short route
STOPOVERS
add stopover
enter new address
guide me home
from address book
from last destinations
optimise route
replace stopover
delete stopover
recalculate
fast route
short route
optimised route
AUDIO SETTINGS
refer to the "AUDIO SETTINGS" menu
BALANCE/FADER
SEARCH FOR POINTS OF INTEREST
nearby
near destination
in a town
in a country
along the route
"RADIO" MENU
AM/FM WAVEBAND
FM waveband
AM waveband
SELECT FREQUENCY
"NAVIGATION" MENU
STOP/RESUME GUIDANCE
"AUDIO SETTINGS" MENU
BASS/TREBLE
MUSICAL AMBIENCE
none
classical
jazz
rock/pop
techno
vocal
CUT OUT REAR SPEAKERS
LOUDNESS
AUTO VOLUME CORRECTION
INITIALISE AUDIO SETTINGS
ENTER DESTINATION
enter new address
country
town
road
number
start guidance
post code
add to address book
junction
town centre
GPS coordinates
entering on map
guide me home
from last destinations
from address book

37
QUESTION SOLUTION RESPONSE
The TRAFFIC INFO box is ticked. However, certain traffi c jams along the route are not indicated in real time.
On starting, it is several minutes before the system begins to receive the traffi c information. Wait until the traffi c information is being received correctly (displaying of the traffi c information symbols on the map).
In certain countries, only major routes (motorways , ...) are listed for the traffi c information.
The time taken to calculate a route sometimes seems longer than usual.
This phenomenon is normal. The system is dependent on the traffi c information available.
The performance of the system may slow down tempor arily if a CD/DVD is being copied onto the Jukebox at the same time as a route is being calculated.
Wait until the CD/DVD has been copied or stop the copying before starting the guidance function.
Does the emergency call function work without a SIM card?
No, European regulations impose the presence of a SIM card in order to make an emergency call. Insert a valid SIM card in the slot.
The altitude is not displayed. On starting, the initialisation of the GPS may take up to 3 minutes to receive more than 4 satellites correctly. Wait until the system has started up completely. Check that there is a GPS coverage of at least 4 satellites (long press on the SETUP button, then select GPS COVERAGE).
Depending on the geographical environment (tunnel, ...) or the weather, the conditions of reception of the GPS signal may vary. This phenomenon is normal. The system is dependent on the conditions of reception of the GPS signal.
The route calculation is not successful. The exclusion criteria may confl ict with the current location (exclusion of toll roads on a toll motorway). Check the exclusion criteria on the NAV menu (GUIDANCE OPTION-EXCLUSION CRITERIA).