2008.5 Citroen C5 DAG roof

65
4
A C C E S S
Normal locking using the key

 Turn the key to the right in the
driver's door lock to lock the ve-
hicle completely.
Locking is confi rmed by fi xed lighting
of the direction indicators for approxi-
mately two seconds and by switching
off of the courtesy light.
According to version, the exterior
mirrors fold at the same time. If one of the doors, the rear screen
or the boot is still open, the central
locking does not take place.
When the vehicle is locked, if it is
unlocked inadvertently, it will relock
automatically after thirty seconds
unless a door is opened.
When stationary with the engine
off, locking is confi rmed by fl ashing
of the interior locking control indi-
cator light.
The folding and unfolding of the
exterior mirrors using the remote
control can be deactivated by a
CITROËN dealer.
Deadlocking using the
remote control
 Press the closed pad-
lock to lock the vehicle
completely or press the
closed padlock for more
than two seconds to
close the windows and
sunroof automatically in
addition to locking.

 Press the closed padlock again
within fi ve seconds to deadlock
the vehicle.
Locking the vehicle
Normal locking using the remote
control

 Press the closed pad-
lock to lock the vehicle
completely.

 Press the closed padlock for
more than two seconds to close
the windows and sunroof auto-
matically in addition to locking. Deadlocking using the key

 Turn the key to the right in the
driver's door lock to lock the ve-
hicle completely and hold it in
this position for more than two
seconds to close the windows
automatically in addition to locking.

 Turn the key to the right again
within fi ve seconds to deadlock
the vehicle.
Deadlocking is confi rmed by fi xed
lighting of the direction indicators for
approximately two seconds.
According to version, the exterior
mirrors fold at the same time.
Deadlocking renders the exterior and
interior door controls inoperative.
It also deactivates the manual central
control button.
When stationary with the engine
off, locking is confi rmed by fl ashing
of the indicator lamp on the interior
locking control.
If one of the doors or the boot is open
or has not been closed correctly, the
central locking will not work.
Therefore, never leave anyone in-
side the vehicle when it is dead-
locked.

79
4
A C C E S S
PANORAMIC SUN ROOF (SALOON)
This sun roof provides optimum light
and visibility in the passenger com-
partment.
Sun roof closed
- Press B to fi rst notch: tilting.
- Press B to second notch: auto-
matic complete tilting.
- Press A to fi rst notch: sliding
towards rear.
- Press A to second notch: auto-
matic total sliding towards rear. Sun roof open
- Press
B to fi rst notch: closure.
- Press B to second notch: auto-
matic total closure.
Always remove the ignition key
when leaving the vehicle, even if
for a short time.
In the event of anything being
caught by the sun roof closing, you
must reverse the roof movement.
To do that, reverse the position of
the control concerned.
When the driver is operating the sun
roof, he or she must always make
sure that the passengers are not
preventing it from closing properly.
The driver must ensure that pas-
sengers use the sun roof control
correctly.
Pay special attention to where children
are when operating the sun roof.
The fi tting of a sun roof as an acces-
sory is prohibited.
Operation
Tilted sun roof
- Press
A to fi rst notch: closure.
- Press A to second notch: auto-
matic total closure.
Your sun roof is fi tted with a manually-
operated blind.
Anti-pinch
An anti-pinch device stops the sun
roof from closing, whether sliding or
tilting. If it meets an obstacle, it re-
opens. Reinitialisation
After a battery disconnection or if
there has been a malfunction, you
have to re-initialise the anti-pinch
function.

 move control B until the roof is in
the complete tilting position,

 keep control B pressed down for
a minimum of 1 second.

During these operations, the anti-
pinch function does not operate.

80
4
A C C E S S
GLASS PANORAMIC ROOF (TOURER)
This device comprises a tinted glass
panoramic surface 1 to improve
brightness and vision in the passenger
compartment.
It is fi tted with an electrical blind 2
to help maintain a comfortable tem-
perature and reduce noise. Opening

 Press control A .
Pressing to the 1st notch allows you
to open the blind step by step.
Pressing to the 2nd notch allows
you to fully open the blind.
The blind stops in the closest pre-
defi ned position (11 positions) as
soon as you release the control.
Closing

 Press control B .
Press to the fi rst notch to close the
blind step by step.
Press to the second notch to close
the blind completely.
The blind stops at the nearest pre-
set position (11 positions) as soon as
you release the control. After a battery disconnection, or if
there has been a malfunction, you
have to re-initialise the anti-pinch
function:

 press control B to the 2 nd
notch
(fully closed),

 wait until the blind is fully
closed,


press control B for at least 3 seconds.
If the blind opens randomly during a
closing operation, and straight after
the blind stops:

 Press control B until the blind
closes fully.

During these operations, the anti-
pinch function does not operate.
In the event of anything being
caught when the blind is moving,
you must reverse the movement of
the blind. To do so, reverse the po-
sition of the control.
When the driver is operating the
blind, he or she must always make
sure that the passengers are not
preventing it from closing properly.
The driver must ensure that his pas-
sengers are using the blind correctly.
Pay special attention to children
when operating the blind.
Anti-pinch
If the blind meets an obstacle whilst
closing, it stops and opens partially
again.
You must re-initialise the anti-pinch
function within 5 seconds of the
blind stopping:

 press control B until the blind is
fully closed (closing in steps of a
few centimetres).
SEQUENTIAL ELECTRICAL BLIND

92
V I S I B I L I T Y
5
In permanent lighting mode, different
lighting times are available:
- with the ignition off, approxi-mately ten minutes,
- in energy economy mode, approxi- mately thirty seconds,
-
with the engine running, unlimited.
Map reading lights

 With the ignition on, press the
corresponding switch. Panoramic glass roof rear
reading lights (Tourer)
With the key in position or with the
ignition on:

 Press the corresponding switch.
The reading light concerned comes
on for ten minutes.
The rear reading lights come on:
- when the key is removed from the ignition,
- when the vehicle is unlocked.
They switch off gradually:
- when the vehicle is locked,
- when the ignition is switched on.

93
V I S I B I L I T Y
5
AMBIENT LIGHTING
Your vehicle is equipped with warm
and welcoming ambient lighting.
A soft orange light is emitted.
Operation
When starting the engine, with the
vehicle lights on, lights located along
the dashboard are activated. Central console
The lights are located on the roof
console, near the front interior lamp.
They light up the central console.
DOOR LIGHTING
Door opening controls
lighting
Dashboard
Operation
These lights are activated with the
automatic switching on of the lights,
when the exterior light is poor. They
are deactivated when the instrument
panel goes out.
The intensity of the lighting varies
along with that of the instrument
panel.

 Press buttons A to increase or
reduce the intensity of the lighting. They are located on the front and
rear interior door opening controls.
The rear door opening controls light-
ing is deactivated if child safety is
activated.

93
V I S I B I L I T Y
5
AMBIENT LIGHTING
Your vehicle is equipped with warm
and welcoming ambient lighting.
A soft orange light is emitted.
Operation
When starting the engine, with the
vehicle lights on, lights located along
the dashboard are activated. Central console
The lights are located on the roof
console, near the front interior lamp.
They light up the central console.
DOOR LIGHTING
Door opening controls
lighting
Dashboard
Operation
These lights are activated with the
automatic switching on of the lights,
when the exterior light is poor. They
are deactivated when the instrument
panel goes out.
The intensity of the lighting varies
along with that of the instrument
panel.

 Press buttons A to increase or
reduce the intensity of the lighting. They are located on the front and
rear interior door opening controls.
The rear door opening controls light-
ing is deactivated if child safety is
activated.

100
6
L A Y O U T
LUGGAGE COVER (TOURER)
To roll up

 Press the handle (PRESS) gently.
The luggage cover rolls up auto-
matically.
The moving part A can be folded
along the rear bench seat backrest.
To remove

 Compress the control 1 and lift
the luggage cover on the right
then on the left to remove it.
To install


Position the left-hand end of the lug-
gage cover roller in its location B
behind the rear bench seat.


 Compress the roller control 1
and put the roller in place in its
location C on the right.

 Release the control to secure
the luggage cover.

 Unroll it to its fastening on the
boot pillar. High load retaining net
(Tourer)
Hooked onto the special upper and
lower fi xings, this permits use of the
entire loading volume up to the roof:
- behind the rear seats (row 2),
- behind the front seats (row 1)
when the rear seats are folded.
When positioning the net, check that
the strap loops are visible from the
boot; this will make slackening or
tightening easier.

188
11
P R A C T I C A L I N F O R M A T I O N
ROOF BARS
The design of your vehicle, for your
safety and to avoid damage to the
roof and tailgate, requires the use
of roof bars that are tested and ap-
proved by CITROËN.
Regardless of the type of loading
equipment to be transported on the
roof (bicycle carrier, ski carrier...),
it is imperative that you add trans-
verse roof bars. Recommendations

 Distribute your load evenly,
avoiding overloading on one
side.

 Arrange the heaviest part of the
load as close as possible to the
roof.

 Anchor the load securely and
draw attention to it if any part of
it is overhanging.

 Drive gently, as the vehicle will
be more liable to the effects of
side winds (vehicle stability may
be altered).

 Remove the roof bars as soon
as they are no longer needed. Maximum load that can be
distributed on the roof bars
(for a loading height not
exceeding 40 cm; except bicycle
carrier): 80 kg.
If the height exceeds 40 cm, adapt
your speed to the profi le of the road
to avoid damaging the roof bars
and the fi xings on the roof.
Please refer to national legislation
in order to comply with the regula-
tions concerning the transportation
of objects which are longer than
the vehicle.