2008.5 Citroen C3 PICASSO lights

FAMILIARISATION
SEE CLEARLY
Lighting

Ring A

Ring B Raise or lower the lights stalk passing
the point of resistance; the correspon-
ding direction indicators will fl ash for as
long as the stalk remains in this posi-
tion.
Direction indicators

Switching on "AUTO"

 Press the stalk down and release it.

Ring B: rear wiper


 61

 66
Lights off.
Automatic switching on of the
lights.
Side lights.
Dipped/main beam headlamps.
Rear fog lamp.
or
Front and rear fog lamps.
Park.
Intermittent wipe.
Wash-wipe.

Control A: windscreen wipers


 65
Wipers

Switching off "AUTO"

 Push the stalk up and return it to po-
sition "0" .


 67


 88

"Motorway" function
Push the lights stalk up or down, with-
out passing the point of resistance; the
corresponding direction indicators will
fl ash three times.
This function can be used at any speed,
but it is particularly useful when chan-
ging lane on high-speed roads.

FAMILIARISATION
MONITOR THOROUGHLY
Translucent digital indicator Controls bar

A. With the ignition on, the level of fuel
remaining is displayed on the digital
indicator.

B. With the ignition on, the oil level
indicator should display "OIL OK"
for a few seconds.
If the levels are not correct, top up the
levels which are low. Lighting of the indicator light indicates
the status of the corresponding function.

A. Deactivation of the ESP/ASR
system.
 90

B. Deactivation of the audible and/or
visual parking assistance.
 105

C. Central locking.
 57
With the ignition on, the orange and red
warning lights come on.
With the engine running, these warning
lights should switch off almost immedia-
tely, with the exception of warning light
C
(passenger's front air bag activated)
which switches off after approximately
one minute.
If warning lights remain on, refer to the
page concerned.
Warning lights


 18
 19

i
18
INSTRUMENTS and CONTROLS
PETROL - DIESEL INSTRUMENT PANEL
Panel grouping together the digital indicator, the multifunction display and the
vehicle operation indicator lights.

1. Rev counter.
Indicates the speed of rotation of the engine (x 1000 rpm).

2. Rev counter zone indicating that you
must change up a gear.

3. Speed limiter
or
Cruise control.
(km/h or mph)

4. Electric child lock indicator light.
Indicates, for a few seconds, the activation of the electric child lock
(deactivation of the rear windows
and doors).
Translucent digital indicator
This display groups together the warn-
ing and information messages.
Multifunction display
Indicator lights display zone
This zone groups together the vehicle
operation indicator lights.
Display zero reset button
This permits resetting of the function
selected to zero (trip distance recorder
or maintenance indicator).
Instrument panel lighting button
This adjusts the brightness of the light-
ing of the instruments and controls.
For further information, refer to the
paragraph relating to the button or
function and its associated display.

5. Fuel level.
Indicates the quantity of fuel remain- ing in the tank.

6. Vehicle speed.
Indicates the current speed of the moving vehicle (km/h or mph).

7. Trip distance recorder.
(km or miles)

8. Maintenance indicator.
(km or miles) then,
Distance recorder.
(km or miles)

9. Engine oil level indicator.

!
19
INSTRUMENTS and CONTROLS
The warning lights may come on
continuously or fl ash.
Certain warning lights may come
on in two different modes. Only by
relating the type of lighting to the
operating status of the vehicle can
it be ascertained whether the situ-
ation is normal or whether a fault
has occurred.
Indicator and warning lights
Visual indicators informing the driver
that a system is in operation (operation
or deactivation indicator lights) or of the
occurrence of a fault (warning light).
Associated warnings
The switching on of certain warning
lights may be accompanied by an audi-
ble signal and a message on the multi-
function display.
Operation indicator lights
If one of the following indicator lights comes on, this co
nfi rms that the correspond-
ing system has come into operation.
Left-hand direction indicator.
Sidelamps.
Handbrake applied.
Main beam headlamps.
Dipped headlamps.
Front fog lamps.
Coolant temperature.
If lit, this indicates that the en-
gine is cool. Right-hand direction
indicator.
When the ignition is switched on
The warning lights come on for a few
seconds when the vehicle's ignition is
switched on.
When the engine is started, these warn-
ing lights should switch off.
If they remain on, before moving off,
consult the warning light concerned.
Diesel engine pre-heating
Wait until this goes off before
operating the starter.
Rear fog lamp.
Electric child lock
If lit, the child lock is activated.
This warning light is displayed a
few seconds after the function
is activated.

!
20
INSTRUMENTS and CONTROLS
Deactivation warning lights
If one of the following warning lights
comes on, this confi rms that the corre-
sponding system has been switched off
intentionally. Dynamic stability control
(ESP/ASR) deactivation
The ESP/ASR system is put
into service automatically when
the vehicle is started.
A specifi c button, located in the centre
of the dashboard, permits deactivation
of the system. This is confi rmed by con-
tinuous lighting of this warning lamp and
of the indicator lamp on the button.
From approximately 30 mph (50km/h),
the system is reactivated automatically.
Passenger’s air bag system
deactivation
The passenger’s air bag system
is put into service automatically
when the vehicle is started.
A specifi c control, located on
the driver’s side of the fascia, permits
deactivation of the system. This is con-
fi rmed by continuous lighting of this
warning light on the instrument panel or
on the seat belt and passenger’s front
air bag warning lights display.
Do not install a "rearwards facing"
child seat when the front passenger
airbag is activated, or the child risks
being killed or seriously injured. When the front passenger air-
bag is activated, this warning
light comes on on the instru-
ment panel or in the front pas-
senger seat belt and airbag
warning light display for about
a minute.

!
!
21
INSTRUMENTS and CONTROLS
When the engine is running or the vehi-
cle is moving, the lighting of one of the
following warning lights indicates the
occurrence of a fault requiring interven-
tion on the part of the driver.
Central alert.
Lighting is associated with
the displaying of another
warning light:
- braking,
- power steering,
- engine oil pressure,
- coolant temperature,
stop the vehicle as soon as it is safe to
do so. Service.
If this comes on, it indicates
the occurrence of a problem
in one of the systems which
does not have a specifi c
warning light.
In order to identify it, consult the mes-
sage on the multifunction display.
Check:
- the engine oil level,
- the screenwash fl uid level,
- the remote control battery,
- the condition of the bulbs.
For any other situations, contact a
CITROËN dealer.
The illumination of this warning light
may also indicate that the (Diesel) par-
ticle fi lter is starting to get clogged up,
due to specifi c extended urban driving
conditions: low speed, congestion, etc.
In order to regenerate the fi lter, you are
advised to drive, once traffi c conditions
allow, at a speed of 40 mph (60 km/h)
or above for at least 5 minutes (until the
warning light goes out). Braking.
If this comes on, it indicates the
occurrence of a fault in one of
the braking systems:
- signifi cant drop in the level in the cir- cuit,
- electronic brake force distribution (EBFD) faulty (simultaneous lighting
of the ABS warning light),
stop the vehicle as soon as it is safe to
do so.
When the vehicle is moving, check that
the handbrake is fully released.
Any fault resulting in the displaying
of a warning light must be the sub-
ject of further diagnostics by read-
ing the associated message on the
multifunction display.
Should you encounter any prob-
lems, do not hesitate to contact a
CITROËN dealer.
Warning lights
Anti-lock braking system
(ABS).
If this comes on, it indicates the
occurrence of a fault in the anti-
lock braking system.
However, this does not prevent opera-
tion of the vehicle's assisted braking.
Dynamic stability control
(ESP/ASR).
The ESP/ASR system is put
into service automatically when
the vehicle is started.
Unless the system has been deactivated,
if this warning light and the indicator light
on the button come on continuously, this
indicates the occurrence of a fault in the
ESP/ASR system.
If the warning light remains on,
contact your CITROËN dealer.

26
INSTRUMENTS and CONTROLS
Total distance recorder
System which measures the total dis-
tance travelled by the vehicle during its
life. Lighting rheostat
System for manual adjustment of the
brightness of the instruments and con-
trols in relation to the exterior bright-
ness.
The total and trip distances are dis-
played for thirty seconds when the igni-
tion is switched off, when the driver’s
door is opened and when the vehicle is
locked or unlocked.
Trip distance recorder
System which measures a distance
travelled during a day or other period
until it is reset to zero by the driver.

 With the ignition on, press the button
until zeros appear. Activation
When the lights are on:

 press the button to change the bright-
ness of the instruments and controls,

 when the lighting reaches the level
of brightness required, release the
button.
Deactivation
When the lights are off, or in day mode
on vehicles fi tted with daytime lights,
pressing the button does not have any
effect.

i
!
!
42
COMFORT
Manual operation
If you wish, you can make a different
choice from that offered by the system
by changing a setting. The other func-
tions will still be controlled automati-
cally.

 Pressing the "AUTO" button returns
the system to completely automatic
operation.

 Press this button to switch
off the air conditioning. 6. Air distribution adjustment

 Press one or more but-
tons to direct the air fl ow
towards:
7. Air fl ow adjustment
 Turn this control to the left
to decrease the air fl ow or
to the right to increase the
air fl ow.
8. Air intake/Air recirculation Switching the system off

 Turn the air fl ow control to the left until
all of the indicator lights switch off.
This action switches off all of the func-
tions of the system.
Temperature related comfort is no longer
guaranteed but a slight fl ow of air, due
to the movement of the vehicle, can still
be felt.

 Turn the air fl ow dial to the right or
press the "AUTO" button to reacti-
vate the system with the values set
before it was switched off.

 Press this button for recir-
culation of the interior air.
The indicator light on the
button comes on.
5. Air conditioning On/Off
Avoid driving for prolonged periods
with the system off.
Avoid prolonged recirculation of
interior air (risk of condensation and
deterioration of the air quality).
- the windscreen and side windows
(de-icing or demisting),
- the windscreen, the side windows and the vents,
- the windscreen, the side windows, the vents and the footwells,

- the vents and the footwells,
- the vents,
- the footwells,
- the windscreen, the side windows and the footwells.
The air fl ow indicator lights, between
the two fans, come on progressively in
relation to the value requested.
 As soon as possible, press this but-
ton again to permit the intake of out-
side air and prevent condensation.
The indicator light on the button
switches off.
For maximum cooling or heating
of the passenger compartment, it
is possible to exceed the minimum
value 14 or the maximum value 28.

 Turn control 2 or 3 to the left
until "LO" is displayed or to the
right until "HI" is displayed. 9. Mono zone/Dual zone

 Press this button to equa-
lise the comfort value on
the passenger side with that
on the driver’s side (mono
zone). The indicator light on
the button comes on.
Air recirculation enables the passenger
compartment to be isolated from exte-
rior odours and smoke.
Switching the system off could result in
discomfort (humidity, condensation).

 Press this button again to return to
automatic operation of the air con-
ditioning. The indicator light on the

"A/C" button comes on.