Page 3 of 207
FAMILIARISATION OPEN
Boot M o v a b l e b o o t fl o o r
T h i s m o v a b l e b o o t fl o o r w i t h t w o p o s i -
t i o n s a l l o w s y o u t o :
- m a x i m i s e t h e v o l u m e o f t h e b o o t ,
- p a r t i t i o n t h e b o o t ( s t o r i n g o f t h e r e a r
shelf...),
- o b t a i n a fl a t fl o o r f r o m t h e b o o t opening to the front seats, when the
rear bench seat is in the retracted
position.
1. U n l o c k i n g o f t h e v e h i c l e .
2. Opening of the boot.
60
80
A. Interior control.
B. E x t e r i o r c o n t r o l .
C. B o n n e t s t r u t .
109
Bonnet
Page 121 of 207
10
i
i
109
CHECKS
BONNET
P u s h t h e e x t e r i o r c o n t r o l B to the left
and raise the bonnet.
Unclip the strut C from its housing.
Fix the strut in the notch to hold the
bonnet open.
Closing
Take the strut out of the support
notch.
Clip the strut in its housing.
Lower the bonnet and release it at
the end of its travel.
P u l l o n t h e b o n n e t t o c h e c k t h a t i t i s
secured correctly.
Opening
Open the front left door.
P u l l t h e i n t e r i o r c o n t r o l A , located at
the bottom of the door frame. The location of the interior control
prevents opening of the bonnet
while the front left door is closed.
P r o t e c t s t h e c o m p o n e n t s o f t h e e n g i n e
and provides access for checking levels.
RUNNING OUT OF FUEL (DIESEL)
I f y o u r v e h i c l e i s fi t t e d w i t h a n H D I e n -
gine, the fuel circuit must be reprimed if
you run out of fuel.
This system consists of a repriming
pump, a transparent pipe and a degas
screw under the bonnet.
HDi 90 and HDi 110 FAP engines
F i l l t h e f u e l t a n k w i t h a t l e a s t fi v e l i -
tres of diesel.
Open the bonnet.
Unclip the cover to gain access to
the repriming pump.
Squeeze and release the repriming
pump until fuel appears in the trans-
parent pipe with the green connector.
Operate the starter until the engine
starts.
P u t t h e c o v e r b a c k i n p o s i t i o n a n d
clip it in place.
Close the bonnet.
If the engine does not start at the
fi r s t a t t e m p t , d o n o t t r y a g a i n .
Operate the repriming pump again,
then the starter.
Page 144 of 207
131
PRACTICAL INFORMATION
BATTERY
Procedure for charging your battery
w h e n i t i s fl a t o r f o r s t a r t i n g t h e e n g i n e
u s i n g a n o t h e r b a t t e r y .
Access to the battery Starting using another battery
Connect the red cable to the posi-
t i v e t e r m i n a l ( + ) o f t h e fl a t b a t t e r y A ,
then to the positive terminal (+) of
the slave battery B .
Connect one end of the green or
black cable to the negative terminal
(-) of the slave battery B .
Connect the other end of the green
or black cable to the negative termi-
n a l ( - ) o f t h e fl a t b a t t e r y A .
S t a r t t h e s l a v e v e h i c l e .
Operate the starter of the broken
down vehicle and let the engine
r u n .
Wait until the engine returns to idle
a n d d i s c o n n e c t t h e c a b l e s .
The battery is located under the bon-
n e t .
To gain access to it:
open the bonnet using the interior
lever, then the exterior lever,
secure the bonnet strut,
remove the plastic cover to gain ac-
cess to the two terminals,
unclip the fuse box to remove the
b a t t e r y , i f n e c e s s a r y .
