2007 YAMAHA YBR125 clock

Main switch cum steering
lockThe main switch controls the ignition
and lighting systems. Its operation is
described below.
ON:
Electrical circuits are switched on.
The engine can be started. The key
cannot be removed in this position.
OFF:
Engine will be shut off. All electrical
circuits are switched off. The key can
be removed in this position.
1. Push
2. Release
3. TurnLOCK:
The steering is locked in this position
and all electrical circuits are switched
off.
The key can be removed in this
position.
To lock the steering, turn the handle-
bars all the way to the left or right. With
the key at "OFF", push it into the main
switch and release it, turn it counter-
clockwise to "LOCK" and remove it. To
release the lock, turn the key to
"OFF".
INSTRUMENT AND CONTROL FUNCTIONS
WARNING
Never turn the key to "LOCK" when
the Motorcycle is moving.
3-1

This tank cap cannot be closed
unless the key is in the lock. The key
cannot be removed if the cap is not
locked properly.
Be sure the cap is properly
installed and locked in place
before riding the Motorcycle.WARNING
1. Filler tube
2. Fuel levelFuelMake sure there is sufficient fuel in the
tank. Fill the fuel tank to the bottom of
the filler tube as shown in the
illustration.
Do not overfill the fuel tank. Avoid
spilling fuel on the hot engine. Do
not fill the fuel tank above the
bottom of the filler tube to avoid
Spillage
1. OpenFuel tank capTO OPEN:
Insert the key and turn it 1/4 turn
clockwise. The lock will be released
and the cap can be opened.
TO CLOSE:
Push the tank cap into position with
the key inserted. To remove the key,
turn it counterclockwise to the
original position.
Ensure the arrow on fuel tank is
towards the Front of the bike when
inserting Fuel Tank Cap in Fuel
Tank.
INSTRUMENT AND CONTROL FUNCTIONS
NOTE :
3-5
WARNING
WARNING
1
2
1
1. Arrow
1¿

1. Indicator Screws (1 No.)Turn signal and taillight
bulb replacement1. Remove the screws and the
lense.
2. Push the bulb inward and turn it
counterclockwise.
3. Place a new bulb in the socket.
Push the bulb inward and turn it
clockwise until it engages into the
socket.
4. Install the lense and the
screws.1. Tail lamp Screws (2 Nos.)
Do not over-tighten the screws as
the lense may break.
Front wheel removalIt is advisable to have a
YAMAHA dealer service the
wheel.
Securely support the
Motorcycle so there is no
danger of it falling over.
PERIODIC MAINTENANCE AND MINOR REPAIR
6-28
WARNING
CAUTION :