2007 YAMAHA FX HO break in

Table of contents
General and important labels ........... 1
Identification numbers .................... 1
Primary Identification (PRI-ID)
number ........................................... 1
Hull Identification Number (HIN) ........ 1
Engine serial number ........................ 1
Model information ........................... 2
Builder’s plate .................................... 2
Important labels .............................. 3
Warning labels ................................... 4
Other labels ....................................... 8
Safety information ........................... 10
Limitations on who may operate
the watercraft ............................ 10
Cruising limitations ....................... 11
Operation requirements ............... 12
Recommended equipment ........... 14
Hazard information ....................... 15
Watercraft characteristics ............. 15
Water-skiing ................................. 17
Safe boating rules ........................ 19
Enjoy your watercraft
responsibly ................................ 19
Features and functions ................... 20
Location of main components ...... 20
Operation of controls and
other functions ........................... 24
Seats ............................................... 24
Hood ................................................ 25
Fuel tank filler cap ........................... 26
Remote control transmitter .............. 26
Engine stop switch .......................... 27
Engine shut-off switch ..................... 27
Start switch ...................................... 27
Throttle lever ................................... 28
Cooling water pilot outlets ............... 28
Steering system ............................... 28
Tilt lever ........................................... 29
Shift lever ......................................... 29
Quick Shift Trim System (QSTS)
selector ........................................ 30Handgrip .......................................... 32
Reboarding step ............................... 32
Bow eye ........................................... 32
Stern eyes ....................................... 33
Pull-up cleats
(for FX Cruiser High Output) ........ 33
Yamaha Engine Management
System (YEMS) ........................... 33
Yamaha Security System ................ 33
Multifunction information center ...... 34
Storage compartments .................... 45
Operation ......................................... 49
Fuel and oil .................................. 49
Gasoline .......................................... 49
Engine oil ......................................... 50
Filling the fuel tank .......................... 50
Pre-operation checks ................... 51
Pre-operation check list ................... 51
Pre-operation check points .............. 53
Operation ..................................... 61
Engine break-in ............................... 61
Launching the watercraft ................. 61
Starting the engine .......................... 61
Stopping the engine ........................ 63
Leaving the watercraft ..................... 63
Operating your watercraft ............ 64
Getting to know your watercraft ....... 64
Learning to operate your
watercraft ..................................... 64
Riding with passengers ................... 65
Starting the watercraft ..................... 65
Boarding and starting in
deep water ................................... 66
Capsized watercraft ......................... 69
Turning the watercraft ..................... 70
Stopping the watercraft ................... 72
Beaching the watercraft ................... 72
Docking the watercraft ..................... 72
Reverse on waterways ..................... 72
Rough water operation .................... 73
UF1X71E0.book Page 1 Tuesday, September 26, 2006 9:52 AM

Operation
61
EJU32740
Operation
WARNING
EWJ00510
Before operating your watercraft, become
familiar with all of the controls. Consult a
Yamaha dealer about any control or func-
tion that you do not fully understand. Fail-
ure to understand how the controls work
could cause an accident or prevent you
from avoiding an accident.
CAUTION:
ECJ00460
Make sure that the stern drain plugs are
tightened securely before launching the
watercraft.
EJU36140Engine break-in
The engine break-in period is essential to al-
low the various components of the engine to
wear and polish themselves to the correct op-
erating clearances. This ensures proper per-
formance and promotes longer component
life.
CAUTION:
ECJ00440
Be sure to check the engine oil level be-
fore operating the watercraft for the first
time. (See page 53 for engine oil checking
procedures.)
(1) Launch the watercraft and start the en-
gine. (See page 61 for engine starting
procedures.)
(2) For the first 5 minutes, run the engine at
trolling speed only. For the 30 minutes of
operation after that, keep the engine
speed below 5000 r/min. For the 1 hour of
operation after that, keep the engine
speed below 8000 r/min.
(3) Proceed with normal operation.
CAUTION:
ECJ00430
Failure to follow the engine break-in pro-
cedure could result in reduced engine life
or even severe engine damage.
EJU32801Launching the watercraft
When launching the watercraft, make sure
that there are no obstacles behind you.
Use the remote control transmitter to select
the unlock mode. (See page 33 for Yamaha
Security System lock and unlock mode selec-
tion procedures.)
After the watercraft is in the water, start the
engine. Shift into reverse and move the water-
craft back slowly. If there are waves, some-
one should make sure that the watercraft is
not pushed into the trailer before backing
away.
EJU36340Starting the engine
WARNING
EWJ00560
Never start the engine or let it run for any
length of time in an enclosed area. Ex-
haust fumes contain carbon monoxide, a
colorless, odorless gas that may cause
loss of consciousness and death within a
short time. Always operate the watercraft
in an open area.
UF1X71E0.book Page 61 Tuesday, September 26, 2006 9:52 AM

Maintenance and care
86
EJU34381Cleaning and adjusting the spark
plugs
The spark plug is an important engine compo-
nent and is easy to inspect. The condition of
the spark plug can indicate something about
the condition of the engine. For example, if
one spark plug has a distinctly different color,
the engine could require servicing. Do not at-
tempt to diagnose any problems yourself.
Have a Yamaha dealer service the watercraft.
Remove and inspect the spark plugs periodi-
cally; heat and deposits will cause the spark
plugs to slowly break down and erode. If elec-
trode erosion becomes excessive, or if carbon
and other deposits are excessive, replace the
spark plug with the specified plug.
To remove a spark plug:
(1) Remove the air filter case cover and air
filter element. (See page 84 for air filter
element removal and installation proce-
dures.)
(2) Remove the spark plug cap.
CAUTION:
ECJ00210
Do not use any tools to remove or install
the spark plug cap, otherwise the ignition
coil coupler could be damaged. The spark
plug cap may be difficult to remove be-
cause the rubber seal on the end of the
cap fits tightly. To remove the spark plug
cap, simply twist it back and forth while
pulling it up; to install it, twist it back and
forth while pushing it down.
(3) Remove the spark plug.
Measure the spark plug gap with a wire
thickness gauge. Replace the spark plugor adjust the gap to specification if neces-
sary.
To install a spark plug:
(1) Clean the gasket surface.
(2) Wipe any dirt from the threads of the
spark plug.
(3) Install the spark plug, and then tighten it
to the specified torque.
(4) Install the spark plug cap.
NOTE:

Wipe off any water on the spark plug or in-
side the spark plug cap before installing the
cap. Push the spark plug cap down until it is
securely installed.

If a torque wrench is not available when you
are installing a spark plug, a good estimate
of the correct torque is 1/4 turn to 1/2 turn
past finger tight using the spark plug
wrench included in the tool kit. Have the
spark plug adjusted to the correct torque
with a torque wrench as soon as possible.
Specified spark plug:
CR9EB
1Spark plug gap
Spark plug gap:
0.7–0.8 mm (0.028–0.031 in)
Spark plug tightening torque:
12.5 Nm (9.2 ft-lb) (1.27 kgf-m)
UF1X71E0.book Page 86 Tuesday, September 26, 2006 9:52 AM

Index
A
Air filter element, checking ....................... 84
Analog speedometer/tachometer ............. 35
Analog speedometer/tachometer and
indicator lights ....................................... 35
B
Battery ................................................ 55, 78
Battery, checking...................................... 88
Battery, jumping ....................................... 95
Beaching the watercraft ........................... 72
Beverage holder ....................................... 47
Bilge ......................................................... 54
Boarding alone ......................................... 67
Boarding and starting from a dock ........... 66
Boarding and starting in deep water ........ 66
Boarding and starting in shallow water .... 66
Boarding with passengers ........................ 67
Bow down................................................. 31
Bow eye ................................................... 32
Bow up ..................................................... 31
Builder’s plate............................................. 2
C
Capsized watercraft ................................. 69
Check engine warning indicator ............... 41
Cleaning the watercraft ............................ 78
Cooling water pilot outlet .......................... 60
Cooling water pilot outlets ........................ 28
Cruising limitations ................................... 11
D
Digital speedometer ................................. 38
Docking the watercraft ............................. 72
E
Emergency procedures ............................ 94
Engine break-in ........................................ 61
Engine compartment ................................ 53
Engine oil ................................................. 50
Engine oil and oil filter .............................. 83
Engine oil level ......................................... 53
Engine overheat warning indicator ........... 40
Engine serial number ................................. 1
Engine shut-off cord ................................. 59
Engine shut-off switch .............................. 27
Engine stop switch ................................... 27
Enjoy your watercraft responsibly ............ 19
Exhaust temperature warning indicator.... 41F
Filling the fuel tank ................................... 50
Fire extinguisher ....................................... 56
Flushing the cooling system ..................... 76
Front storage compartment ...................... 45
Fuel and oil............................................... 49
Fuel injection system ................................ 90
Fuel level .................................................. 53
Fuel level meter ........................................ 38
Fuel level warning indicator ...................... 39
Fuel system .............................................. 77
Fuel system, checking .............................. 83
Fuel tank .................................................. 83
Fuel tank filler cap .................................... 26
Fuses, replacing ....................................... 96
G
Gasohol .................................................... 49
Gasoline ................................................... 49
Getting to know your watercraft ............... 64
Glove compartment .................................. 46
H
Handgrip ................................................... 32
Hazard information ................................... 15
Hood ......................................................... 25
Hour meter/voltmeter ............................... 39
Hull and deck ........................................... 53
Hull Identification Number (HIN)................. 1
I
Identification numbers ................................ 1
Important labels .......................................... 3
J
Jet intake .................................................. 59
Jet intake and impeller, cleaning .............. 94
Jet thrust nozzle angle, checking ............. 85
Jumper cables, connecting ...................... 95
L
Labels, other .............................................. 8
Labels, warning .......................................... 4
Launching the watercraft .......................... 61
Learning to operate your watercraft ......... 64
Leaving the watercraft .............................. 63
Left multifunction display and
operation buttons .................................. 37
Limitations on who may operate
the watercraft ........................................ 10
UF1X71E0.book Page 1 Tuesday, September 26, 2006 9:52 AM