2007 VOLVO XC70 lock

2007 Volvo XC70
Emergency towing
The towing eyelet is located in the tool bag, under the floor of the car\
go area, with the spare tire. This
eyelet must be screwed into the positions provided on the right sides of\
either the front or rear bumper
(see illustrations).
To attach the towing eyelet:
A. Use a coin to pry open the lower edge of the.
B. Screw the towing eyelet (C) in place, first by hand and then using \
the tire iron until it is securely in
place.
After the vehicle has been towed, the eyelet should be removed and retur\
ned to the tool bag. Press the
cover back into position.
Precautions when the vehicle is in tow
l The steering wheel must be unlocked. Turn the ignition key to position I\
or II.
l The gear selector must be in position N.
l Maximum speed: 50 mph (80 km/h). Do not exceed the maximum allowable t\
owing speed.
file:///K|/ownersdocs/2007/2007_XC70/07xc70_06.htm (28 of 41)12/30/200\
6 5:51:38 PM

2007 Volvo XC70
Always follow the trailer manufacturer's recommendations for wheel chock\
ing.
l When starting on a hill, put the gear selector in (D)rive before releasing the parking brake.
l If you use the manual (Geartronic) shift positions while towing a trai\
ler, make sure the gear you select
does not put too much strain on the engine (using too high a gear).
l The drawbar assembly/trailer hitch may be rated for trailers heavier tha\
n the vehicle is designed to
tow. Please adhere to Volvo's recommended trailer weights.
Leveling
If your vehicle is equipped with automatic leveling, the rear suspension\
always retains the correct ride
height regardless of the load. When the vehicle is stationary, the rear \
suspension lowers, which is
normal.
pg. 147 Starting and driving
Detachable trailer hitch
A. Ball holder
B. Locking bolt
C. Safety wire attachment
D. Hitch assembly
E. Cotter pin
Installing the ball holder
- If necessary, remove the cotter pin from the locking bolt and slide th\
e locking bolt out of the hitch
file:///K|/ownersdocs/2007/2007_XC70/07xc70_06.htm (33 of 41)12/30/200\
6 5:51:38 PM

2007 Volvo XC70
assembly.
- Slide the ball holder into the hitch assembly.
- Align the hole in the ball holder with the one in the hitch assembly. \
- Slide the locking bolt through the hitch assembly/ball holder.
- Insert the cotter pin in the hole at the end of the locking bolt.
Removing the ball holder
- Remove the cotter pin from the locking bolt and slide the locking bolt\
out of the ball holder/hitch
assembly.
- Pull the ball holder out of the hitch assembly.
A cover for the hitch assembly can be purchased from your Volvo retailer\
.
pg. 148 Starting and driving
Load carriers (accessory)
Load carriers
Load carriers are available as Volvo accessories. Observe the following \
points when in use:
l To avoid damaging your vehicle and to achieve maximum safety when drivin\
g, we recommend using
the load carriers that Volvo has developed especially for your vehicle. \
l Volvo-approved removable roof racks are designed to carry the maximum al\
lowable roof load for this
vehicle: 220 lbs (100 kg). For Non-Volvo roof racks, check the manufac\
turer's weight limits for the rack.
l Never exceed the rack manufacturer's weigh limits and never exceed the m\
aximum rated roof load of
220 lbs (100 kg).
l Avoid single-point loads. Distribute loads evenly.
l Place heavier cargo at the bottom of the load.
l Secure the cargo correctly with appropriate tie-down equipment.
file:///K|/ownersdocs/2007/2007_XC70/07xc70_06.htm (34 of 41)12/30/200\
6 5:51:38 PM

2007 Volvo XC70
page 189 for the location of the washer fluid reservoir). This is important sin\
ce dirt is often splashed on
the windshield during winter driving, requiring the frequent use of the \
washers and wipers. Volvo
Washer Solvent should be diluted as follows:
- Down to 14° F (-10° C): 1 part washer solvent and 4 parts water
- Down to 5° F (-15° C): 1 part washer solvent and 3 parts water
- Down to 0° F (-18° C): 1 part washer solvent and 2 parts water
- Down to -18° F (-28° C): 1 part washer solvent and 1 part water
l Use Volvo Teflon Lock Spray in the locks.
NOTE: Avoid the use of de-icing sprays as they can cause damage to the locks.\
W - Winter/Wet driving mode - enhanced vehicle traction (automatic tran\
smission)
l Mode W will only function if the gear selector is in the (D)rive position.
l Press the button at the base of the gear selector to engage/disengage th\
is driving mode.
l An LED in the button will light up to indicate that W is engaged and thi\
s will also be displayed in the
instrument panel (see
page 46).
l This mode may be selected for starting/ moving off on slippery roads.
1. Synthetic oil is not used when the oil is changed at the normal maint\
enance service intervals.
pg. 152 Starting and driving
Before a long distance trip
It is always worthwhile to have your vehicle checked at a Volvo retailer\
before driving long distances.
Your retailer will also be able to supply you with bulbs, fuses, spark p\
lugs and wiper blades for your use
in the event that problems occur.
As a minimum, the following items should be checked before any long trip\
:
l Check that engine runs smoothly and that fuel consumption is normal.
l Check for fuel, oil, and fluid leakage.
l Check transmission oil level1.
l Check condition of drive belts.
l Check state of the battery's charge.
l Examine tires carefully (the spare tire as well), and replace those th\
at are worn. Check tire pressures.
l The brakes, front wheel alignment, and steering gear should be checked b\
y your Volvo retailer only.
l Check all lights, including high beams.
l Reflective warning triangles are legal requirement in some countries.
l Have a word with your Volvo retailer if you intend to drive in countries\
where it may be difficult to
obtain the correct fuel.
l Consider your destination. If you will be driving through an area where \
snow or ice are likely to
occur, consider snow tires.
file:///K|/ownersdocs/2007/2007_XC70/07xc70_06.htm (38 of 41)12/30/200\
6 5:51:38 PM

2007 Volvo XC70
pg. 170 Wheels and tires
Snow chains, snow tires, studded tires
Snow chains
Snow chains can be used on your Volvo with the following restrictions:
l Snow chains should be installed on front wheels only. Use only Volvo app\
roved snow chains.
l If accessory, aftermarket or "custom" tires and wheels are installed and\
are of a size different than the
original tires and wheels, chains in some cases CANNOT be used. Sufficie\
nt clearances between chains
and brakes, suspension and body components must be maintained.
l Some strap-on type chains will interfere with brake components and there\
fore CANNOT be used.
l All Wheel Drive models: Snow chains should only be installed on the fron\
t wheels. Only chains
adapted for AWD models should be used.
Consult your Volvo retailer for additional snow chain information.
CAUTION!
- Check local regulations regarding the use of snow chains before instal\
ling. Always follow the chain
manufacturer's installation instructions carefully. Install chains as ti\
ghtly as possible and retighten
periodically.
- Never exceed the chain manufacturer's specified maximum speed limit. (\
Under no circumstances
should you exceed 31 mph (50 km/h)).
- Avoid bumps, holes or sharp turns when driving with snow chains.
- The handling of the vehicle can be adversely affected when driving wit\
h chains. Avoid fast or sharp
turns as well as locked wheel braking.
Snow tires, studded tires
1
Tires for winter use:
l Owners who live in or regularly commute through areas with sustained per\
iods of snow or icy driving
conditions are strongly advised to fit suitable winter tires to help ret\
ain the highest degree of traction.
l It is important to install winter tires on all four wheels to help retai\
n traction during cornering,
braking, and accelerating. Failure to do so could reduce traction to an \
unsafe level or adversely affect
handling.
l Do not mix tires of different design as this could also negatively affec\
t overall tire road grip.
l Winter tires wear more quickly on dry roads in warm weather. They should\
be removed when the
winter driving season has ended.
l Studded tires should be run-in 300-600 miles (500-1000 km) during whic\
h the vehicle should be
driven as smoothly as possible to give the studs the opportunity to seat\
properly in the tires. The tires
should have the same rotational direction throughout their entire lifeti\
me.
file:///K|/ownersdocs/2007/2007_XC70/07xc70_07.htm (17 of 24)12/30/200\
6 5:51:40 PM

2007 Volvo XC70
Spare tire, tool bag, jack - vehicles with subwoofer (option)
The spare tire, jack and tool bag are located under the floor of the car\
go space in a compartment in front
of the spare tire. To access the spare tire:
- Remove the rear hinged floor panel by raising it approx. 6 inches (15\
cm) and then pulling it rearward
out of the cargo area.
- Raise the other floor panel to upright position and lock it there.
- Remove the mat.
- Loosen the wheel and turn the clip 90°.
- Lift the subwoofer inward-upward with both hands and tilt it leftward.\

- Unstrap and lift out the jack and tool bag.
- Unscrew the securing bracket and remove the spare tire from the storag\
e well.
- When putting the tire and subwoofer back into place, perform these ste\
ps in reverse order. Make sure
the spare tire, jack, tool bag and subwoofer are properly secured.
WARNING!
Make sure that the spare tire, jack and tool bag are properly secured wi\
th the securing bracket and
strap to help keep these components in place in the event of a sudden st\
op.
pg. 174 Wheels and tires
Changing wheels
file:///K|/ownersdocs/2007/2007_XC70/07xc70_07.htm (20 of 24)12/30/200\
6 5:51:40 PM

2007 Volvo XC70
Changing wheels
The spare wheel is located under the rear hatch in the cargo area floor.\
The jack and crank are secured in
the wheel recess (see
pages 171 and 173).
There are two jack attachment points on each side of the vehicle (see i\
llustration on next page).
To change a wheel:
- Engage the parking brake.
- Put the gear selector in (P)ark (automatic transmission) or revers\
e (manual transmission).
- Remove the wheel cap (where applicable) using the lug wrench in the \
tool bag.
- With the vehicle still on the ground, use the lug wrench to loosen the\
wheel bolts 1/2 - 1 turn by
exerting downward pressure. Turn the bolts counterclockwise to loosen.
file:///K|/ownersdocs/2007/2007_XC70/07xc70_07.htm (21 of 24)12/30/200\
6 5:51:40 PM

2007 Volvo XC70
CAUTION!
- The vehicle must not be driven with wheels of different dimensions or \
with a spare tire other than
the one that came with the vehicle. The use of different size wheels can\
seriously damage your
vehicle's transmission.
- Correct tightening torque on wheel bolts must be observed. The wheel b\
olts should never be greased
or lubricated. The extended, chromed wheel bolts must not be used with s\
teel rims, as they make it
impossible to fit the hub caps.
- Locking wheel bolts can be used on both aluminum and steel wheels. If \
hub caps are used on steel
wheels, the locking wheel bolt should be mounted in the hole as far from\
the tire's inflation valve as
possible. It would otherwise not be possible to mount the hub cap on the\
wheel.
pg. 175 Wheels and tires
Changing wheels
- Position the jack correctly on the bar in the attachment (see illustr\
ation above) and crank while
simultaneously guiding the base of the jack to the ground. The base of t\
he jack must be flat on a level,
firm, non-slippery surface. Before raising the vehicle, check that the j\
ack is still correctly positioned in
the attachment.
- Raise the vehicle until the wheel to be changed is lifted off the grou\
nd.
- Unscrew the wheel bolts completely and carefully remove the wheel so a\
s not to damage the threads on
the studs.
file:///K|/ownersdocs/2007/2007_XC70/07xc70_07.htm (22 of 24)12/30/200\
6 5:51:40 PM