2007 TOYOTA CAMRY clock

’07Camry_U (L/O 0608)
349
2007MY CAMRY from Oct. ’06 Prod. (OM33748U)
6. After making sure that no one
is in the vehicle, raise it high
enough so that the spare tire
can be installed.
Remember you will need more ground
clearance when putting on the spare
tire than when removing the flat tire.
To raise the vehicle, insert the jack
handle into the jack (it is a loose fit)
and turn it clockwise. As the jack
touches the vehicle and begins to lift,
double−check that it is properly posi-
tioned.
CAUTION
Never get under the vehicle when
the vehicle is supported by the
jack alone.
7. Remove the wheel nuts and
change tires.
Lift the flat tire straight off and put it
aside.
Roll the spare wheel into position and
align the holes in the wheel with the
bolts. Then lift up the wheel and get
at least the top bolt started through
its hole. Wiggle the tire and press it
back over the other bolts.
—Raising your vehicle —Changing wheels

’07Camry_U (L/O 0608)
351
2007MY CAMRY from Oct. ’06 Prod. (OM33748U)
9. Lower the vehicle completely
and tighten the wheel nuts.
Turn the jack handle counterclock-
wise to lower the vehicle.
Use only the wheel nut wrench to
tighten the nuts. Do not use other
tools or any additional leverage other
than your hands, such as a hammer,
pipe or your foot. Make sure the
wrench is securely engaged over the
nut.
Tighten each nut a little at a time in
the order shown. Repeat the process
until all the nuts are tight.
CAUTION
When lowering the vehicle,
make sure all portions of your
body and all other persons
around will not be injured as
the vehicle is lowered to the
ground.
Have the wheel nuts tightened
with torque wrench to 103 N·m
(10.5 kgf·m, 76 ft·lbf), as soon
as possible after changing
wheels. Otherwise, the nuts
may loosen and the wheels
may fall off, which could cause
a serious accident.
Do not attach a heavily dam-
aged plastic wheel ornament.
It may fly off the wheel and
cause accidents while the ve-
hicle is moving.
10.Reinstall the wheel ornament.
1. Put the wheel ornament into posi-
tion.
Align the cutout of the wheel orna-
ment with the valve stem as shown.
2. Press hard firmly on one side of
wheel ornament and then firmly
tap the other side around the edge
of wheel ornament with the heel
of your hand to snap into place.
—Lowering your vehicle—Reinstalling wheel ornament
(steel wheels only)

’07Camry_U (L/O 0608)
384
2007MY CAMRY from Oct. ’06 Prod. (OM33748U)
If the level is low, add SAE J1703 or
FMVSS No.116 DOT 3 brake fluid to the
brake reservoir.
Remove and replace the reservoir cap by
hand. Fill the brake fluid to the dotted
line. This brings the fluid to the correct
level when you put the cap back on.
Use only newly opened brake fluid. Once
opened, brake fluid absorbs moisture from
the air, and excess moisture can cause a
dangerous loss of braking.
CAUTION
Take care when filling the reservoir
because brake fluid can harm your
hands or eyes. If fluid gets on your
hands or in your eyes, flush the af-
fected area with clean water immedi-
ately. If you still feel uncomfortable
with your hands or eyes, go to the
doctor.
NOTICE
If you spill some of the fluid, be sure
to wipe it off to prevent it from dam-
aging the parts or paintwork.
If hot O.K.
If hot
addClose OpenIf cold
O.K.
If cold
add
Check the fluid level through the reser-
voir. If necessary, add automatic trans-
mission fluid DEXRONII or III.
If the vehicle has been driven around 80
km/h (50 mph) for 20 minutes (a little
more in frigid temperatures), the fluid is
hot (60C—80C or 140F—175F). You
may also check the level when the fluid
is cold (about room temperature,
10C—30C or 50F—85F) if the engine
has not been run for about five hours.Clean all dirt from the outside of the res-
ervoir tank and look at the fluid level. If
the fluid is cold, the level should be in the
“COLD” range. Similarly, if it is hot, the
fluid level should be in the “HOT” range.
If the level is at the low side of either
range, add automatic transmission fluid
DEXRONII or III to bring the level within
the range.
To remove the reservoir cap, turn it coun-
terclockwise and lift up. To reinstall it,
turn it clockwise. After replacing the reser-
voir cap, visually check the steering box
case, vane pump and hose connections
for leaks or damage.
CAUTION
The reservoir tank may be hot so be
careful not to burn yourself.
NOTICE
Avoid overfilling, or the power steer-
ing could be damaged.
Checking power steering fluid

’07Camry_U (L/O 0608)
402
2007MY CAMRY from Oct. ’06 Prod. (OM33748U)
Removing clip
Installing clip
Low beam (outside)
High beam
(inside)
1. Open the hood. Turn the bulb base
counterclockwise to the front of the
vehicle as shown.
The above illustration shows the left−hand
headlight.2. Unplug the connector while depress-
ing the lock release.
If the connector is tight, wiggle it.

’07Camry_U (L/O 0608)
412
2007MY CAMRY from Oct. ’06 Prod. (OM33748U)
ENGINE COMPARTMENT
1. RR FOG 10 A: No circuit
2. FR DEF 15 A (2.4 L 4cylinder [2AZ
FE] engine): No circuit
3. AM2 7.5 A: Starting system
4. ALTS 7.5 A: Charging system
5. MAYDAY/TEL 7.5 A: No circuit
6. EACM 10 A (3.5 L V6 [2GRFE] en-
gine): No circuit
7. ETCS 10 A: Electronic throttle control
system
8. HAZ 15 A: Turn signal lights
9. IG2 20 A: Multiport fuel injection sys-
tem/sequential multiport fuel injection
system, starting system, “GAUGE
NO.2” and “IGN” fuses
10. STR LOCK 20 A: Steering lock system
11. DOME 10 A: Gages and meters, vanity
lights, trunk light, ignition switch light,
door courtesy lights, interior light, per-
sonal lights, clock, smart key system
12. ECUB NO.1 10 A: Wireless remote
control system, front passenger occu-
pant classification system, main body
ECU, vehicle stability control system
13. RADIO NO.1 15 A: Audio system, nav-
igation system14. DOOR NO.1 25 A: Main body ECU
15. AMP 25 A: Audio system
16. EFI MAIN 30 A: Multiport fuel injection
system/sequential multiport fuel injec-
tion system, electronic throttle control
system, “EFI NO.2” and “EFI NO.3”
fuses
17. EFI NO.3 10 A: Multiport fuel injection
system/sequential multiport fuel injec-
tion system
18. EFI NO.2 15 A: Multiport fuel injection
system/sequential multiport fuel injec-
tion system
19. SHORN 7.5 A: Horn
20. A/F 20 A: Multiport fuel injection sys-
tem/sequential multiport fuel injection
system
21. MPXB 10 A: Gages and meters
22. EFI NO.1 10 A: Theft deterrent sys-
tem, smart key system, multiport fuel
injection system/sequential multiport
fuel injection system, electronic throttle
control system
23. HORN 10 A: Horns
24. HLP(RL) 15 A: Right−hand headlight
(low beam)
25. HLP(LL) 15 A: Left−hand headlight
(low beam)
Fuses

’07Camry_U (L/O 0608)
414
2007MY CAMRY from Oct. ’06 Prod. (OM33748U)
7. STOP 10 A: Stop lights, high mounted
stoplight, shift lock control system,
multiport fuel injection system/sequen-
tial multiport fuel injection system, main
body ECU, anti−lock brake system, ve-
hicle stability control system, traction
control system, brake assist system,
electronic throttle control system
8. TI&TE 30 A: No circuit
9. AM1 7.5 A: Starting system, multiport
fuel injection system/sequential multi-
port fuel injection system
10. A/C 7.5 A: Air conditioning system
11. PWR 25 A: Power windows
12. DOOR NO.2 25 A: Main body ECU
13. S/ROOF 30 A: Electric moon roof
14. TAIL 15 A: Front side marker lights,
tail lights, rear side marker lights, li-
cense plate lights, front turn signal/
parking lights
15. PANEL 7.5 A: Navigation system, seat
heaters, emergency flashers, air condi-
tioning system, audio system, clock,
glove box light, instrument panel lights,
steering switches
16. ECU IG NO.1 10 A: Main body ECU,
electric moon roof, tire pressure warn-
ing system, electric cooling fans, auto
anti−glare inside rear view mirror17. ECU IG NO.2 7.5 A: Anti−lock brake
system, vehicle stability control system,
traction control system, brake assist
system, shift lock control system, auto-
matic transmission, cruise control sys-
tem
18. A/C NO.2 10 A: Air conditioning sys-
tem, rear window defogger
19. WASH 10 A: Windshield wipers and
washer
20. SHTR 20 A: Seat heaters
21. GAUGE NO.1 10 A: Emergency flash-
ers, back−up lights, charging system
22. WIP 25 A: Windshield wipers and
washer
23. HLP LVL 7.5 A: No circuit
24. INJ 15 A: Multiport fuel injection sys-
tem/sequential multiport fuel injection
system, starting system
25. IGN 10 A: Multiport fuel injection sys-
tem/sequential multiport fuel injection
system, theft deterrent system, SRS
airbag system, steering lock system,
front passenger occupant classification
system, smart key system, electronic
throttle control system
26. GAUGE NO.2 7.5 A: Gages and me-
ters, multi−information display, clock27. ECUACC 7.5 A: Clock, main body
ECU, shift lock control system, outside
rear view mirror, smart key system
28. CIG 20 A: Power outlet
29. PWR OUTLET 20 A: Power outlet
30. RADIO NO.2 7.5 A: Audio system,
navigation system
31. MIR HTR 10 A: Outside rear view mir-
ror defoggers
32. POWER 30 A: Power windows
33. P/SEAT 30 A: Power seats