2007 TOYOTA CAMRY HYBRID Green light

’07Camry hybrid_U (L/O 0610)
33
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
ENTRY FUNCTION AND START
FUNCTION
Simply by carrying the key, you can
lock and unlock the doors and start the
hybrid system.
Entry function—You can lock and unlock
the doors and open the trunk without in-
serting the key in the keyholes. For fur-
ther information, see “Side doors” on page
38 and “Trunk lid” on page 47 in this
Section.
Start function— You can shift the power
supply mode and start the hybrid system
when the electronic key is in the vehicle.
For further information, see “‘POWER’
switch” on page 160 in Section 1 −7 and
“How to start the hybrid system” on page
301 in Section 3.
If the smart key system does not oper-
ate properly because of a system mal-
function, consult your Toyota dealer.
Make sure to bring all of the keys. They
may be necessary to repair the system. STEERING LOCK FUNCTION
When the driver ’s door is opened after
turning off the hybrid system, the steering
wheel will lock.
The steering lock is automatically un-
locked when the “POWER” switch is
pressed. If the indicator light on the
“POWER” switch flashes green, this indi-
cates that the steering wheel remains
locked. If the amber indicator light flashes,
this indicates that the steering lock is mal-
functioning. For details, see “How to start
the hybrid system” on page 301 in Section
3.

’07Camry hybrid_U (L/O 0610)
35
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
When the electronic key is near a
high−voltage or noise −emitting device.
When you are carrying an electronic
key together with a key for another
smart key system equipped vehicle or
another instrument emitting radio
waves.
Depending on the position of the key
or vehicle body shape, the key may
not work well even within the actuation
area.
When the key surface is covered by a
sticker, etc. that may cut off electro-
magnetic wave.
Even if the smart key system does not
operate properly, you can still enter and
start the hybrid system. For further infor-
mation, see “Side doors” on page 38 and
“Trunk lid” on page 47 in this Section, and
see “How to start the hybrid system” on
page 301 in Section 3.
STARTING THE HYBRID SYSTEM WHEN
THE ELECTRONIC KEY BATTERY IS
DISCHARGED
If the key indicator does not flash and
the hybrid system cannot be started by
using the start function, the battery
may be discharged. Replace the key
battery as soon as possible. (See
“—Replacing battery” on page 30 in
this Section.)
However the hybrid system can be turned
on in the following procedures.
1. While the brake pedal is depressed, touch the Toyota logo side of the
electronic key to the “POWER” switch. 2. Start the hybrid system within 5
seconds after the green indicator light
on the “POWER” switch comes on and
a buzzer sounds.
BATTERY POWER SAVING
Both the vehicle and key transmitters are
always sending signals to each other. To
prevent battery drain, the smart key sys-
tem is automatically deactivated in the fol-
lowing conditions:
If the electronic key is left outside of
the vehicle and within the effective
range of the entry function actuation
area for more than 10 minutes.
If the door lock or unlock operation is
not performed more than 2 weeks.
The key and the vehicle are communicat-
ing even while the vehicle is not being
driven. Do not leave the key near the
vehicle (within 2 m [7 ft.]).
The vehicle battery may drain if the
vehicle is not used for a long period of
time. To prevent battery drain, disconnect
the battery negative ( −) terminal or disable
the smart key system. (For details about
disable the smart key system, see
“DISABLING THE SMART KEY SYSTEM”
in this Section.)

’07Camry hybrid_U (L/O 0610)
122
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
HighLow beams—For high beams, turn
the headlights on and push the lever away
from you (position 1). Pull the lever to-
ward you (position 2) for low beams.
The headlight high beam indicator light
(blue light) on the instrument panel will
tell you that the high beams are on.
Flashing the high beam headlights
(position 3)—Pull the lever all the way
back. The high beam headlights turn off
when you release the lever.
You can flash the high beam headlights
even when the headlights are off.TURN SIGNALS
To signal a turn, push the headlight/
turn signal lever up or down to position
1.
The “POWER” switch must be set at ON.
The lever automatically returns after you
make a turn, but you may have to return
it by hand after you change lanes.
To signal a lane change, move the lever
up or down to the pressure point (position
2) and hold it.
If the turn signal indicator lights (green
lights) on the instrument panel flash faster
than normal, a front or rear turn signal
bulb is burned out. See “Replacing light
bulbs” on page 373 in Section 7 −3.HEADLIGHTS
To turn on the following lights: Twist
the headlight/turn signal lever knob.
Position 1—Parking, tail, license plate,
side marker and instrument panel lights
The tail light indicator (green light) on the
instrument panel will tell you that the tail
lights are on.
Position 2—Headlights and all of the
above
Position 3 (“AUTO”)—Headlights and all of
the lights in the position 1
They automatically turn on or off depend-
ing on the darkness of the surroundings.
Headlights and turn signals
(for Canada)

’07Camry hybrid_U (L/O 0610)
125
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
TURN SIGNALS
To signal a turn, push the headlight/
turn signal lever up or down to position
1.
The “POWER” switch must be set at ON.
The lever automatically returns after you
make a turn, but you may have to return
it by hand after you change lanes.
To signal a lane change, move the lever
up or down to the pressure point (position
2) and hold it.
If the turn signal indicator lights (green
lights) on the instrument panel flash faster
than normal, a front or rear turn signal
bulb is burned out. See “Replacing light
bulbs” on page 373 in Section 7−3.To turn on the emergency flashers,
push the switch.
All the turn signal lights will flash. To turn
them off, push the switch once again.
Turn on the emergency flashers to warn
other drivers if your vehicle must be
stopped where it might be a traffic hazard.
Always pull as far off the road as pos-
sible.
The turn signal light switch will not work
when the emergency flashers are operat-
ing.
NOTICE
To prevent the 12 volt battery from
being discharged, do not leave the
switch on longer than necessary when
the hybrid system is turned off.
Emergency flashers

’07Camry hybrid_U (L/O 0610)
147
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
(o)
This message is to warn the driver that
the electronic key battery is low.
Change the key battery as soon as pos-
sible to ensure that the smart key sys-
tem operates properly.
The message appears with the master
warning light and a warning tone sounds.
(p)
This message warns the driver that the
steering lock function malfunctions. At
this time, the amber indicator light on
the “POWER” switch flashes.
The hybrid system will not be turned on
in this case. Contact your Toyota dealer
as soon as possible.
The message appears with the master
warning light and a warning tone sounds.(q)
This message appears when the steer-
ing lock is stuck. The message appears
for 15 seconds. At this time, the green
indicator light on the “POWER” switch
flashes.
To free the steering lock, rotate the steer-
ing wheel slightly left or right while press-
ing the “POWER” switch.
The message appears with the master
warning light and a warning tone sounds.
(r)This message is to remind the driver to
change the engine oil. The message is
a prior notice.
Toyota recommends that the engine oil
be changed as soon as possible.
If the driving range after the previous oil
change reaches 7200 km (4500 miles), the
message appears for about 15 seconds
with the master warning light and a warn-
ing tone sounds.
The engine oil maintenance data must be
reset after the engine oil change. See
following “Resetting the engine oil mainte-
nance data”.

’07Camry hybrid_U (L/O 0610)
160
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
When the key is in the vehicle, press-
ing the “POWER” switch (hybrid system
startup switch) allows you to start and
stop the hybrid system or choose at
the ACC, ON, or “POWER” switch off.
When the brake pedal is not depressed,
pressing the “POWER” switch changes the
mode as follows. Press the switch slowly
and firmly.First time—ACC (accessory) mode (
illu-
minates amber)
Accessories such as the radio operate.
Second time—ON mode (illuminates am-
ber)
All accessories on.
Third time—Power off (indicator light
off)
Pressing the “POWER” switch again re-
turns the mode switch to ACC.If a buzzer sounds and the master warn-
ing light comes on for 5 seconds when
pressing the “POWER” switch, this indi-
cates that the key is not in the vehicle.
The message “KEY IS NOT DETECTED”
will also appear on the multi −information
display.
If the brake pedal is depressed, the in-
dicator light will turn green, regardless
of which mode is selected. When the
indicator light is green, pressing the
“POWER” switch once turns the hybrid
system on. (For starting tips, see “How
to start the hybrid system” on page 301
in Section 3.)
“POWER” switch

’07Camry hybrid_U (L/O 0610)
303
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
If the green indicator light on the
“POWER” switch flashes, and the mes-
sage “S/T IS NOT UNLOCKED” ap-
pears on the multi−information display
and the master warning light comes on,
the steering wheel is locked.
To free the steering lock, turn the
steering wheel slightly while pressing
the “POWER” switch.
If the amber indicator light on the
“POWER” switch flashes, and the mes-
sage “CHECK S/T LOCK” appears on
the multi −information display and the
master warning light comes on, there is
a problem in the steering lock function.
Contact your Toyota dealer, and have
your vehicle and all keys inspected.
If the amber indicator light on the
“POWER” switch flashes, and no mes-
sage appears on the multi −information
display, there is a problem in the push
button start function.
Contact your Toyota dealer, and have
your vehicle and all keys inspected.
In addition to the above, there are
instances in which the smart key sys-
tem does not operate properly because
of the circumstances of use. For de-
tails, see “Smart key system” on page
32 in Section 1 −2.
In cases other than those described
above, it is possible that a problem has
occurred in an area other than the start
system. See “If your vehicle will not start”
on page 313 in Section 4. If the 12 volt battery is disconnected or
run down...
The “READY” light will not come on and
the hybrid system will not start after you
reconnect, replace or recharge the battery.
In this case, perform the following proce-
dure to restart the hybrid system:
1. Turn the hybrid system off.
2. Open and close the driver ’s door.
3. Press the “POWER” switch briefly and firmly.
If the hybrid system still will not start,
contact your Toyota dealer.CAUTION
Never start the hybrid system from
outside the vehicle, or an accident
may occur. Be sure to sit in the driv-
er seat, then start the system.

’07Camry hybrid_U (L/O 0610)
307
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
(J) The “POWER” switch flashes greenonce every second.
This indicates that the steering lock is
stuck. The message “S/T IS NOT
UNLOCKED” will also appear on the
multi −information display.
To free it, rotate the steering wheel slight-
ly while pressing the “POWER” switch.
(K) The “POWER” switch flashes amber once every 2 seconds.
When the message “CHECK S/T LOCK”
appears on the multi −information display—
This indicates a problem with the steering
lock function. Have your vehicle checked
at your Toyota dealer.
When no message appears on the multi −
information display—
This indicates a problem with the push
button start function. Have your vehicle
checked at your Toyota dealer. THEFT PREVENTION FUNCTION
When the hybrid system is turned off,
the engine immobilizer system is auto-
matically set. (See “Engine immobilizer
system” on page 24 in Section 1
−2.)
When the driver ’s door is opened after
turning off the hybrid system, the steer-
ing wheel will lock.
When the 12 volt battery is discharged,
the steering lock function may not op-
erate properly.
Always slow down in gusty crosswinds.
This will allow you much better control.
Drive slowly onto curbs and, if pos-
sible, at a right angle. Avoid driving
onto high, sharp− edged objects and
other road hazards. Failure to do so
can lead to severe tire damage such
as a tire burst.
Drive slowly when passing over bumps
or travelling on a bumpy road. Other-
wise, the impact could cause severe
damage to the tires and/or wheels.
When parking on a hill, turn the front
wheels until they touch the curb so
that the vehicle will not roll. Apply the
parking brake, and place the transmis-
sion in “P”. If necessary, block the
wheels.
Tips for driving in various
conditions