2007 TOYOTA CAMRY HYBRID instrument cluster

’07Camry hybrid_U (L/O 0610)
165
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
Slip indicator light
When the “POWER” switch is set at ON
is turned on, the slip indicator light comes
on. It will go off when the “READY” light
comes on. If the slip indicator light does
not come on when the “POWER” switch is
set at ON, contact your Toyota dealer.While the VDIM is using its various func-
tions to stabilize vehicle motion, the slip
indicator in the instrument cluster flashes
and the buzzer sounds. Drive carefully
when you are in situations where the indi-
cator flashes. You may feel some vibra-
tions from the underbody and you may
feel some resistance when turning the
steering wheel when the VDIM is using its
various functions.
“ABS” warning light (U.S.A.)
“ABS” warning light (Canada)

’07Camry hybrid_U (L/O 0610)
304
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
NOTICE
If any message appears on the mul-
tiinformation display or service re-
minder indicator light comes on
(see page 140 and page 150 in Sec-
tion 16 for details) or the 12 volt
battery is disconnected, the hybrid
system may not be started. In that
case, push the “POWER” switch
again. If the “READY” light does
not come on, contact your Toyota
dealer.
 When you start the hybrid system
at a lower outside temperature, it
may take longer before the blinking
“READY” light changes to constant
on.
TIPS FOR USING SMART KEY SYSTEM
When using the smart key system, it is
possible to start or stop the hybrid system
as long as the key is on your person.
For this reason, it is possible that a pas-
senger may remove the key from the ve-
hicle without the driver being aware of the
fact. In such a case, it is not possible to
restart the hybrid system after having
turned it off. In addition, it is possible that
one may get out of the vehicle without
being aware that the “POWER” switch has
not been turned off completely.
When driving or getting in or out of the
vehicle, drivers should make sure that
they are carrying the key.
CAUTION
Do not touch the “POWER” switch
while driving.
If you have to make an emergency stop,
press and hold the “POWER” switch for
more than 3 seconds.
Master warning light and multiinforma-
tion display
SYSTEM FUNCTION REMINDERS
Follow the instructions described below if
any of the following warnings occur:
(A) A warning buzzer sounds once from
the instrument cluster when the
“POWER” switch is pushed.
This indicates that the driver has gotten
into the vehicle without the key. The mes-
sage “KEY IS NOT DETECTED” will also
appear on the multi −information display
and the master warning light will come on.
Operate the “POWER” switch only after
taking care that the key is in the vehicle.
Driving and parking using
smart key system

’07Camry hybrid_U (L/O 0610)
305
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
If the warning light is still lit when the key
is in the vehicle, the key battery is dis-
charged. Check that the indicator light on
the key comes on by pushing the lock
button on the key. When the indicator light
does not come on, change the key battery
so that smart key system works properly.
(B) A warning buzzer sounds once fromthe instrument cluster, accompanied
by three warning sounds from the
vehicle when the driver gets out of
the vehicle and closes the door.
This indicates that the driver is attempting
to leave the vehicle carrying the key with
“POWER” switch turned off although the
transmission selector lever has been set
in the “P” position. The message “KEY IS
NOT DETECTED” will also appear on the
multi −information display and the master
warning light will come on.
Get out of the vehicle only after turning
off the hybrid system by pressing the
“POWER” switch and checking that the
indicator light on the “POWER” switch has
gone off. If the driver returns to the ve-
hicle without carrying the key and begins
driving, a warning buzzer will sound once
more. (C) A warning buzzer sounds from the
vehicle for two seconds after locking
the door with the door handle
switch.
This indicates that the driver is attempting
to lock the doors while carrying the key,
neglecting to follow the instructions for
case (B) above.
Lock the doors only after turning off the
hybrid system by pressing the “POWER”
switch and checking that the indicator light
on the “POWER” switch has gone off.
A warning buzzer that sounds even though
the engine has been turned off indicates
that driver is attempting to lock the ve-
hicle with the keys still in the vehicle.
Leave the vehicle only after making sure
that you are carrying the key. (D) A warning buzzer sounds continu-
ously from the instrument cluster
when opening the driver ’s door.
This indicates that the transmission selec-
tor lever is in a position other than “P”
and that the “POWER” switch is not
turned off. The message “SHIFT TO P
RANGE” will also appear on the multi −in-
formation display.
Get out of the vehicle only after setting
the transmission selector lever in the “P”
position, turning off the hybrid system by
pressing the “POWER” switch and
checking that the indicator light on the
“POWER” switch has gone off.

’07Camry hybrid_U (L/O 0610)
306
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
(E) A warning buzzer sounds continu-ously from the instrument cluster
and from the vehicle when closing
the door after getting out of the ve-
hicle.
This indicates that the driver is attempting
to leave the vehicle carrying the key, ne-
glecting to follow the instructions for case
(D) above. The messages, “SHIFT TO P
RANGE” and “KEY IS NOT DETECTED”,
will also appear alternately on the multi −
information display and the master warn-
ing light will come on.
Get out of the vehicle only after setting
the transmission selector lever in the “P”
position, turning off the hybrid system by
pressing the “POWER” switch and
checking that the indicator light on the
“POWER” switch has gone off. (F) A warning buzzer sounds once from
the instrument cluster and three
times from the vehicle when a pas-
senger is getting out of the vehicle.
This indicates that the passenger is
attempting to leave the vehicle carrying
the key, without turning the hybrid system
off. The message “KEY IS NOT
DETECTED” will also appear on the
multi −information display and the master
warning light will come on.
When passengers get out of the vehicle,
care should be taken to leave the key
with the driver. If the driver begins driving
after a passenger gets out of the vehicle
carrying the key, a warning buzzer will
sound once more.
(G) A warning buzzer sounds from the vehicle for two seconds when lock-
ing the vehicle from the outside with
the door handle switch.
This indicates that the driver is attempting
to lock the door with the key still in the
vehicle.
Leave the vehicle only after making sure
that you are carrying the key. (H) A warning buzzer sounds once from
the instrument cluster when the
“POWER” switch is turned off.
This indicates that the key battery is low.
(This warning buzzer sounds only when
the hybrid system has been on or the
“POWER” switch has been set at ON for
20 minutes or more.) The message “LOW
KEY BATTERY” will also appear on the
multi −information display.
Change the key battery ahead of time in
order to ensure that the smart key system
works properly.
(I) A warning buzzer sounds repeatedly from the instrument cluster when
opening the driver ’s door with the
“POWER” switch turned off.
This indicates that the steering wheel is
not locked. Turn the engine off and then
open the door in order to lock the steering
wheel.

’07Camry hybrid_U (L/O 0610)
313
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
Before making these checks, make sure
you have sufficient fuel and that you have
followed the correct starting procedure giv-
en in “How to start the hybrid system” on
page 301 in Section 3. If your vehicle is
equipped with the engine immobilizer sys-
tem, also check whether the other keys
will start the hybrid system. If they work,
your key may be broken. Have the key
checked at your Toyota dealer. If none of
your keys work, there may be a malfunc-
tion in the immobilizer system. Call your
Toyota dealer. (See “Keys” on page 22 in
Section 1−2.) If the instrument cluster displays with
normal brightness levels with the
“POWER” switch set at ON...
You may try emergency start. See “(b)
Emergency start” for further instructions.
If the instrument cluster dims or the
instrument cluster display turns off
with the “POWER” switch set at ON...
1. Check that the 12 volt battery terminals are tight and clean.
2. If the 12 volt battery terminals are O.K., the 12 volt battery is discharged.
You may try jump starting. See “(c)
Jump starting” that follows for further
instructions.
NOTICE
Hybrid vehicles cannot be push
started.
When the hybrid system cannot be
started, the following procedure can be
used if the hybrid system and “POWER”
switch function normally.
1. Put the transmission in “P”.
2. Set the mode to ACC by pushing the “POWER” switch once.
3. Push and hold the “POWER” switch for about 15 seconds while depressing the
brake pedal firmly.
Even if the hybrid system can be started
using the above procedure, the system
may be malfunctioning. Have the vehicle
checked by your Toyota dealer.
If the hybrid system cannot be started
using the above procedure, immediately
contact your Toyota dealer.
CAUTION
Do not place any objects close to the
“POWER” switch. If the object pushes
on the switch, the hybrid system may
be started unexpectedly.
If your vehicle will not start—
(a) Simple checks ( b ) Emerg en cy st art