2007 TOYOTA CAMRY HYBRID fuses

’07Camry hybrid_U (L/O 0610)
238
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
Cancel operation—
Do either one of the following:
Push the onhook switch at anytime
during the operation.
Push the talk switch and say “Can-
cel” after the beep at anytime dur-
ing the operation except while a call
is connected.
When receiving a phone call, a ring tone
is audible and the system changes into
the telephone mode.
When receiving a phone call, the display
is as follows. The display differs depend-
ing on whether or not the vehicle is in
motion.
When the vehicle is stopped:
Number, name or “Incoming” is displayed.
When the vehicle is in motion:
“Incoming” is displayed.
Do either one of the following:
Pushing the off−hook switch allows you
to talk on the phone.
Pushing the on −hook switch refuses
the call.
To adjust the ring volume, push “+” or “ −”
on the steering volume controls. Volume
adjustment cannot be done using the au-
dio system.
Repeatedly pushing “ −” on the steering
volume controls mutes the ring.
When receiving an international phone
call, the name of the party may not be
displayed correctly depending on the cellu-
lar phone. To transfer a call to the phone:
The received call can be transferred from
the hands
−free system to the cellular
phone that is connected to Bluetooth . For
details, refer to the user’s guide for the
cellular phone.
—Receiving a p hone call

’07Camry hybrid_U (L/O 0610)
348
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
Spare fusesIf you perform maintenance by yourself,
be sure to follow the correct procedure
given in this Section.
You should be aware that improper or in-
complete servicing may result in operating
problems.
Performing do−it−yourself maintenance
during the warranty period may affect your
warranty coverage. Read the separate
Toyota Warranty statement for details and
suggestions.
This Section gives instructions only for
those items that are relatively easy for an
owner to perform. As explained in Section
6, there are still a number of items that
must be done by a qualified technician
with special tools.
For information on tools and parts for do −
it −yourself maintenance, see “Parts and
tools” on page 351 in this Section.
Utmost care should be taken when work-
ing on your vehicle to prevent accidental
injury. Here are a few precautions that
you should be especially careful to ob-
serve:
Fuse locations Doityourself service
precautions

’07Camry hybrid_U (L/O 0610)
352
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
CHECKING THE COOLANT LEVEL
Parts (if level is low):
“Toyota Super Long Life Coolant” or
similar high quality ethylene glycol
based non−silicate, non −amine, non− ni-
trite, and non −borate coolant with long −
life hybrid organic acid technology.
“Toyota Super Long Life Coolant” is a
mixture of 50% coolant and 50% deion-
ized water (for the U.S.A.) or 55%
coolant and 45% deionized water (for
Canada).
Tools:
Funnel (only for adding coolant)
CHECKING 12 VOLT BATTERY CON-
DITION
Tools:
Warm water
Baking soda
Grease
Conventional wrench (for terminal
clamp bolts) CHECKING AND REPLACING FUSES
Parts (if replacement is necessary):
Genuine Toyota fuse or equivalent with
same amperage rating as original
ADDING WASHER FLUID
Parts:
Water
Washer fluid containing antifreeze (for
winter use)
Tools:
Funnel
REPLACING LIGHT BULBS
Parts:
Bulb with same number and wattage
rating as original (See charts in “Re-
placing light bulbs” on page 373 in
Section 7 −3.)

’07Camry hybrid_U (L/O 0610)
368
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
DOITYOURSELF MAINTENANCE
Electrical components
Checking 12 volt battery condition369
. . . . . . . . . . . . . . . . . . . . . . . . . . . .
12 volt battery recharging precautions 370
. . . . . . . . . . . . . . . . . . . . . . . .
Checking and replacing fuses 371
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Checking the fusible link 372
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
.
Adding washer fluid 373
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
. . . . .
Replacing light bulbs 373
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
. . . .
SECTION 7 3

’07Camry hybrid_U (L/O 0610)
371
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
GoodBlown
Ty p e A
Good Blown
Ty p e B
Good Blown
Ty p e C
If the headlights or other electrical
components do not work, check the
fuses. If any of the fuses are blown,
they must be replaced.
See “Fuse locations” on page 348 in Sec-
tion 7 −1 for locations of the fuses.
Turn the hybrid system and inoperative
component off. Pull the suspected fuse
straight out and check it.
Determine which fuse may be causing the
problem. The lid of the fuse box shows
the name of the circuit for each fuse. See
page 386 in Section 8 for the functions
controlled by each circuit.
Type B fuses—When any of the fuses are
blown, contact your Toyota dealer.
Checking and replacing fuses

’07Camry hybrid_U (L/O 0610)
372
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
Type A fuses can be pulled out by the
pull−out tool. The location of the pull −out
tool is shown in the illustration.
If you are not sure whether the fuse has
blown, try replacing the suspected fuse
with one that you know is good.
If the fuse has blown, push a new fuse
into the clip.
Only install a fuse with the amperage rat-
ing designated on the fuse box lid.
If you do not have a spare fuse, in an
emergency you can pull out the “RADIO
NO.1” or “PWR OUTLET” fuse, which may
be dispensable for normal driving, and use
it if its amperage rating is the same.
If you cannot use one of the same amper-
age, use one that is lower, but as close
to the rating as possible. If the amperage
is lower than that specified, the fuse
might blow out again but this does not
indicate anything wrong. Be sure to get
the correct fuse as soon as possible and
return the substitute to its original clip.
It is a good idea to purchase a set of
spare fuses and keep them in your ve-
hicle for emergencies. If the new fuse immediately blows out,
there is a problem with the electrical sys-
tem. Have your Toyota dealer correct it as
soon as possible.
CAUTION
Never use a fuse with a higher am-
perage rating, or any other object, in
place of a fuse. This may cause ex-
tensive damage and possibly a fire.
If the headlights or other electrical
components do not work and the fuses
are O.K., check the fusible link fitted
on the “+” terminal of the 12 volt bat-
tery. If the link is melted, it must be
replaced.
If there is an overload in the circuits, the
fusible links are designed to melt before
the entire wiring harness is damaged.
The battery is located in the right
−hand
side of the trunk. See “—12 volt battery
location” on page 369 in this Section.
Checking the fusible link

’07Camry hybrid_U (L/O 0610)
379
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
SPECIFICATIONS
Specifications
Dimensions and weights380
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
Engine 380
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
. . . . . . . . . . . . . . . .
Fuel 381
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
. . . . . . . . . . . . . . . . . . .
Traction motor 381
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
. . . . . . . . . .
Hybrid battery 381
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
. . . . . . . . . .
Service specifications 382
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
. . .
Tires 385
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
. . . . . . . . . . . . . . . . . .
Fuses 386
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
. . . . . . . . . . . . . . . . .
SECTION 8

’07Camry hybrid_U (L/O 0610)
386
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
ENGINE COMPARTMENT1. AM2 7.5 A: “POWER” switch
2. ABS MAIN No.2 10 A: Electronically
controlled brake system
3. ABS MAIN No.1 10 A: Electronically
controlled brake system
4. ABS MAIN No.3 10 A: Electronically
controlled brake system
5. BATT FAN 10 A: Hybrid battery fan
6. ETCS 10 A: Electronic throttle control
system
7. HAZ 15 A: Turn signal lights
8. IG2 20 A: Multiport fuel injection sys-
tem/sequential multiport fuel injection
system, starting system, “GAUGE
NO.2”, “IGN” and “INJ” fuses
9. STR LOCK 20 A: Steering lock system
10. DOME 10 A: Gages and meters, vanity
lights, trunk light, “POWER” switch
light, door courtesy lights, interior light,
personal lights, clock, smart key
system
11. ECUB NO.1 10 A: Front passenger
occupant classification system, main
body ECU
12. RADIO NO.1 15 A: Audio system, nav-
igation system 13. DOOR NO.1 25 A:
Main body ECU,
power door lock
14. IGCT 30 A: Hybrid system ECU,
“PWR”, “IGCT No.2” and “INV W/P”
fuses
15. AMP 25 A: Audio system
16. EFI MAIN 30 A: Multiport fuel injection
system/s equential multiport fuel injec-
tion system, electronic throttle control
system and “EFI NO.3” fuses
17. EFI NO.3 10 A: Fuel tank system, mul-
tiport fuel injection system/sequential
multiport fuel injection system
18. IGCT NO.2 10 A: Hybrid system ECU,
motor generator ECU
19. INV W/P 15 A: Hybrid system ECU,
traction battery, DC/DC converter, mul-
tiport fuel injection system/sequential
multiport fuel injection system
20. SHORN 7.5 A: No circuit
21. A/F 20 A: No circuit
22. MPXB 10 A: Gauges and meters
23. EFI NO.1 10 A: Smart key system
24. HORN 10 A: Horns
25. HLP(RL) 15 A: Right−hand headlight
(low beam)
Fuses