5-32 SERVICE AND APPEARANCE CARE
78J00-03E
allow the TPMS to continue to function
properly.
When a low tire pressure condition is
detected, the TPMS will illuminate the low
tire pressure warning symbol on the instru-
ment panel cluster, and at the same time a
message to check the pressure in a spe-
cific tire will appear on the Driver Informa-
tion Center (DIC) display. The low tire
pressure warning symbol on the instru-
ment panel cluster and the check tire pres-
sure message will appear at each ignition
cycle until the tires are inflated to the cor-
rect inflation pressure. Using the DIC, tire
pressure levels can be viewed by the
driver. For additional information and
details about the DIC operation and dis-
plays refer to “DIC Operation and Dis-
plays” and “DIC Warnings and Messages”
in “Driver Information Center (DIC)” in the
“Instrument Panel” section.
The low tire pressure warning light may
come on in cool weather when the vehicle
is first started, and then turn off as you
start to drive. This may be an early indica-
tor that the air pressure in the tire(s) are
getting low and need to be inflated to the
proper pressure.
A Tire and Loading Information Label,
attached to your vehicle, shows the size of
your vehicle’s original equipment tires and
the correct inflation pressure for your vehi-
cle's tires when they are cold. Refer to
“Loading Your Vehicle” in “Your Driving,the Road, and Your Vehicle” in the “Driving
Your Vehicle” section, for an example of
the Tire and Loading Information Label
and its location on your vehicle. Also refer
to “Inflation - Tire Pressure” in this section.
Your vehicle’s TPMS system can warn you
about a low tire pressure condition but it
does not replace normal tire maintenance.
Refer to “Tire Inspection and Rotation” and
“Tires” in this section.
The TPMS will not function properly if one
or more of the TPMS sensors are missing
or inoperable. If the system detects a miss-
ing or inoperable sensor, an error mes-
sage SERVICE TIRE MONITOR SYSTEM
will be shown on the DIC display. If you
have replaced a tire/wheel assembly with-
out transferring the TPMS sensors, the
error message will be displayed. Once you
re-install the TPMS sensors, the error
message should go off. See your SUZUKI
dealer for service if all TPMS sensors are
installed and the error message comes on
and stays on.
TPMS Sensor Matching Process
Each TPMS sensor has a unique identifi-
cation code. Any time you replace one ormore of the TPMS sensors or rotate the
vehicle’s tires, the identification codes will
need to be matched to the new tire/wheel
position. The sensors are matched, to the
tire/wheel positions, in the following order:
driver side front tire, passenger side front
tire, passenger side rear tire, and driver
side rear tire using a TPMS diagnostic tool.
See your SUZUKI dealer for service.
The TPMS sensors may also be matched
to each tire/wheel position by increasing or
decreasing the tire’s air pressure. When
increasing the tire’s pressure, do not
exceed the maximum inflation pressure
indicated on the tire’s sidewall.
You will have two minutes to match each
tire and wheel position. If it takes longer
than two minutes to match any tire and
wheel position, the matching process
stops and you will need to start over.
The TPMS matching process is outlined
below:
1) Set the parking brake.
2) Turn the ignition switch to RUN with the
engine off.
3) Using the DIC, press the vehicle infor-
mation button until the TIRE LOCA-
TIONS PRESS TO LEARN message
displays.
4) Press the set/reset button to allow the
system to learn the tire positions. The
horn will sound twice to indicate the
receiver is ready, and the TIRE
LEARNING ACTIVE message displays.
CAUTION
Do not use a tire sealant if your vehi-
cle has Tire Pressure Monitors. The
liquid sealant can damage the tire
pressure monitor sensors.
5-48 SERVICE AND APPEARANCE CARE
78J00-03E
Appearance CareCleaning the Inside of Your VehicleYour vehicle’s interior will continue to look
its best if it is cleaned often. Although not
always visible, dust and dirt can accumu-
late on your upholstery. Dirt can damage
carpet, fabric, leather, and plastic sur-
faces. Regular vacuuming is recom-
mended to remove particles from your
upholstery. It is important to keep your
upholstery from becoming and remaining
heavily soiled. Soils should be removed as
quickly as possible. Your vehicle’s interior
may experience extremes of heat that
could cause stains to set rapidly.
Lighter colored interiors may require more
frequent cleaning. Use care because
newspapers and garments that transfer
color to your home furnishings may also
transfer color to your vehicle’s interior.
When cleaning your vehicle’s interior, only
use cleaners specifically designed for the
surfaces being cleaned. Permanent dam-
age may result from using cleaners on sur-
faces for which they were not intended.
Use glass cleaner only on glass. Remove
any accidental over-spray from other sur-
faces immediately. To prevent over-spray,
apply cleaner directly to the cleaning cloth.Many cleaners contain solvents that may
become concentrated in your vehicle’s
breathing space. Before using cleaners,
read and adhere to all safety instructions
on the label. While cleaning your vehicle’s
interior, maintain adequate ventilation by
opening your vehicle’s doors and windows.
Dust may be removed from small buttons
and knobs using a small brush with soft
bristles.
Your SUZUKI dealer has a product for
cleaning your vehicle’s glass. Should it
become necessary, you can also obtain a
product from your SUZUKI dealer to
remove odors from your vehicle’s uphol-
stery.
Do not clean your vehicle using the follow-
ing cleaners or techniques:
Never use a knife or any other sharp
object to remove a soil from any interior
surface. Never use a stiff brush. It can cause
damage to your vehicle’s interior sur-
faces.
Never apply heavy pressure or rub
aggressively with a cleaning cloth. Use
of heavy pressure can damage your
interior and does not improve the effec-
tiveness of soil removal.
Use only mild, neutral-pH soaps. Avoid
laundry detergents or dishwashing
soaps with degreasers. Using too much
soap will leave a residue that leaves
streaks and attracts dirt. For liquid clean-
ers, about 20 drops per gallon (3.78 L) of
water is a good guide.
Do not heavily saturate your upholstery
while cleaning.
Damage to your vehicle’s interior may
result from the use of many organic sol-
vents such as naptha, alcohol, etc.
Fabric/CarpetUse a vacuum cleaner with a soft brush
attachment frequently to remove dust and
loose dirt. A canister vacuum with a beater
bar in the nozzle may only be used on floor
carpet and carpeted floor mats. For soils,
always try to remove them first with plain
water or club soda. Before cleaning, gently
remove as much of the soil as possible
using one of the following techniques:
For liquids: gently blot the remaining soil
with a paper towel. Allow the soil to
absorb into the paper towel until no more
can be removed.
CAUTION
If you use abrasive cleaners when
cleaning glass surfaces on your vehi-
cle, you could scratch the glass and/
or cause damage to the rear window
defogger. When cleaning the glass
on your vehicle, use only a soft cloth
and glass cleaner.
