2007 SKODA OCTAVIA TOUR door lock

24CONTROLS AND EQUIPMENT„Multi-touch memory retrieval“: With the
driver door opened or closed, continuous-
ly press the desired memory button D until
the seat and exterior mirrors have moved
into the stored position.
Note
If one of the memory buttons is once again
pressed during the automatic adjustment
of the seat and exterior mirrors, the retrie-
val process is interrupted. In this case,
again press the key which you pressed first
in order to continue the interrupted retrie-
val process. If, on the other hand, you press
one of the other two buttons, the seat and
mirrors will then move to the positions
stored with these buttons.
Retrieving with the remote control*
You can only retrieve the stored seat and
mirror settings if the ignition is switched
off and the driver door is closed:
Briefly press the opening button of the re-
mote control key - see page 9, and then
open the driver door.
The seat and the exterior mirrors now move
automatically into the stored positions.
Notes on use of the lock switch E
After the lock switch E is pressed (re-
leased), the memory system is permanently
switched off. You can now set the seat and
the exterior mirrors only manually. You can
switch on the memory system again by
once again pressing the lock switch E. If a
retrieval process was interrupted when this
switch was first pressed, the process is not
continued .

We recommend switching off the memo-
ry system with the lock switch E if the car is
to be driven for a short time by a person for
whom you do not wish to store the individual
seat and mirror settings.
Retrieving exterior mirror setting for re-
versing*
When reverse gear is engaged, switch over
operation of the exterior mirror settings to
position
R - refer to p. 17.

44CONTROLS AND EQUIPMENTFor all models:Position 1
To lock the steering wheel , withdraw key
and turn wheel until you hear the locking
pin engage.
Warning
Do not withdraw key from lock until
vehicle is stationary! The steering
lock might otherwise unintentionally
engaged.
Note
If you forget to switch off the side lights or
a turn signal light, an audible signal will
sound after you switch off the ignition or
withdraw the key and then open the driv-
er’s door.
Position 2
If the key is difficult to turn in the lock or
cannot be turned to this position at all, move
the steering wheel back and forward slightly
to release the locking pin. Warning
If the vehicle is allowed to roll, the
ignition key must be in position 2 in
the lock - ignition on. This position
is also indicated by the warning
lights coming on. Failure to turn the
ignition key into this position can
result in the steering locking uninten-
tionally.
Do not withdraw the ignition key un-
til after the vehicle has come to a stop
and has been properly secured to
prevent it moving by applying the
handbrake or engaging a gear.
Position 3
The starter is operated when the key is
turned into this position. The ignition key
must be turned back each time into posi-
tion „1“ before again attempting to start the
engine. The starter repeat lockout in the ig-
nition lock prevents the starter again being
operated when engine is already running.
When the key is in this position, the main/
low beam headlights and other major elec-
trical components which are on, are then
switched off.
The starter may only be operated (ignition
key position 3), if the engine is not run-
ning. If the starter is immediately operated
after switching off the engine, the starter
or the engine can be damaged.
Starting engineGeneral notesWarning
Never run the engine in non-venti-
lated or enclosed areas, the exhaust
gases of the engine contain besides
the odourless and colourless carbon
monoxide a poisonous gas - hazard!
Carbon monoxide can cause uncon-
sciousness and death.
Never leave your vehicle unattended
with the engine running.

Before starting, move gear lever into
Neutral (selector lever of automatic gear-
box into position „P“ or „N“ ) and apply
handbrake firmly.

On models with a manual gearbox, de-
press the clutch pedal when operating
starter so that the starter only has to crank
the engine.

As soon as engine starts, release igni-
tion key immediately - otherwise the starter
may suffer damage.

After starting a cold engine, it may sound
noisy for a moment or two because the oil
pressure has to build up in the hydraulic
tappets first.
Do not warm engine up by running it with vehicle stationary. Drive off
straight away.

60CONTROLS AND EQUIPMENTOpening doors*If a door is open, this is indicated by this
warning light.
Vehicles with information display
As an additional warning signal, a peep
sounds if the car is driven at a speed of
more than 6km/hour and if the door or the
luggage compartment door is open.Washer fluid level*The warning light comes on if the washer
fluid level is too low. Top up washer fluid -
see page 151.
An audible warning signal also sounds (sin-
gle peep signal).Bulbs*This warning light comes on if the bulb of
the luminous element is faulty during:

Operation of brakes (brake light)

Malfunction of illumination (low beam (or
fog light)
An audible warning signal also sounds (sin-
gle peep signal)
Testing engine electronics*The warning light comes on when the igni-
tion is switched on.
If the warning light does not go out after
starting the engine, or comes on or flashes
when driving, this indicates a fault in the
engine electronics system or in systems
which influence exhaust emissions. A pro-
gramme stored in the engine control unit
makes it possible to continue driving with
certain restrictions - contact a Škoda dealer
for professional help.Electronic stability
program (ESP)*The warning light comes on for a few se-
conds when the ignition is switched on.
The ESP system also includes the traction
control system (TCS).
The light flashes when driving if the system
has activated a control cycle.
The warning light will come on and remain
on if the system is switched off or if a sy-
stem fault exists.
As the ESP system operates in combination
with the ABS, EDL and EBC, the ESP warn-
ing light also comes on if the ABS system fails.
Further details are given on pages 84 and
122 - 124.
Traction control system (TCS)*The warning light comes on for a few se-
conds when the ignition is switched on.
The light flashes when driving if the system
has activated a control cycle.
The warning light will come on and remain
on if the system is switched off or if a sy-
stem fault exists.
As the TCS system operates in combinati-
on with the ABS, EDL and EBC, the TCS
warning light also comes on if the ABS sy-
stem fails.
Further details are given on pages 65 and
122 - 124.Anti-lock brake system (ABS)*The warning light monitors the ABS, or ABS
and EDL* system.
The ABS warning light should come on for
a few seconds when the ignition is switched
on. If the ABS warning light does not go off
after a few seconds, if it does not come on
at all, or comes on when driving, the sys-
tem is not operating properly. The car is
braked in this case without operation of the
ABS; only the normal brake system then
operates. Contact a Škoda Dealer as
soon as possible and adapt your style
of driving to the fault which exists for
you cannot know the extent of the pro-
blem.

86CONTROLS AND EQUIPMENTConvenience systemWhen the car is locked, the roof can be
closed as follows:

Turn key into lock position (driver or pas-
senger door) and hold until the roof is
closed. The closing operation is immedi-
ately interrupted if the key is released.
Warning
Close the sliding/tilting roof with
care! Closing the roof inattentively
can result in injuries.
Do not leave the ignition key in the
ignition lock when getting out of the
car.
The rollback protection is not active
if the convenience system is used.
Refer to p. 16 for more detailed in-
formation.
Emergency operationIf the system is faulty, the sliding/tilting roof
can be closed manually:

Use a screwdriver to carefully remove
the plastic cover.

Take crank handle out of its fixture, in-
sert fully into the opening and close or open
sliding/tilting roof.

Insert crank handle into its fixture again
and fit on the plastic cover.
Sun visorsThe large sun visors can be taken out of
the side fixtures and swivelled toward the
doors. The small sun visor above the inte-
rior rear-view mirror* can only be folded
down.Sun visors with vanity lighting*The lighting of the vanity mirror comes on
automatically when the sun visor is folded
down.

87
CONTROLS AND EQUIPMENT
Storage compartment on the
front passenger sideTo open the lid, raise handle and pull lid
open.
An additional key is provided with the car
for a lockable stowage compartment*.Warning
For safety reasons, the lid of the sto-
wage compartment should always
remain closed when driving.
Interior lightsInterior light (A)Door contact switching mechanism (on
the front and rear door*)

Press the switch A to the right into posi-
tion
.


On the version without reading lights press
the switch A into the middle position
.
Switching the interior light on

Press the switch A to the left into posi-
tion
.
Switching the interior light on

Press the switch A into the middle posi-
tion O.

On the version without reading lights
press the switch A to the right, the symbol
O appears.
Beverage holder*The beverage holder moves out and opens
after it is pressed in the direction of the ar-
row.
It is intended for holding beverage cans or
cups with a capacity of 0.33 ltr or 0.5 ltr.

88CONTROLS AND EQUIPMENTNoteInterior lights with off time delay* remain on
for a few seconds after the doors are closed.On models fitted with central locking, the
interior light remains on for about 20 sec-
onds when the car is unlocked, a door is
opened or the ignition key is removed pro-
vided the switch is in the door contact po-
sition.
On an open door, the interior light is
switched off after 60 minutes, in order to
avoid discharging the battery.Reading light (B)*Press the switch B, in order to switch the
reading light on or off - see illustration on
page 87.
Interior light (rear)*The interior light is switched on and off by
pressing on the recess in the lens.

101
SAFETY
Unfastening three-point seat belt
The belt is released by applying pressure
with your finger to the red button in the lock.
The lock tongue jumps out of the lock when
this is done as a result of the spring pres-
sure.
Pass the tongue toward the door by hand
so that the retractor can roll the belt up
properly. A plastic knob in the belt holds the
tongue in a convenient position.Three-point seat belt with the Inter-
lock system*On certain models, a three-point seat belt
with the Interlock system is used in place
of the lap belt.
If the rear seat backrest is not properly loc-
ked, the inertia reel blocks the belt which
can then not unreel.
Child safety lock for rear centre
three-point seat beltThe rear centre three-point seat belt can
be blocked (so-called child safety lock) for
attaching a child seat.
Switching on child safety lock

Attach the child safety seat with the
three-point seat belt as stated in the instruc-
tions of the manufacturer.

Wind up the shoulder part of the belt fully.
A characteristic “clicking” is typical for the
unwinding

After the belt has been locked in the seat
belt buckle, allow it to wind up loosely. The
child safety lock is now active. It is now no
longer possible to unwind the belt. Pull on
the seat belt to check that the child safety
lock is active.
Switching off child safety lock
The seat belt is unlocked by pushing the
button and can then wind up. After being
wound up completely, the belt webbing can
be unreeled again freely.
Lap belt*The centre place on the rear seat is fitted
with a two-point lap belt.
The lock part of the two-point lap belt is
operated in the same way as on the three-
point inertia reel belts.
If the lap belt is not in use, it should be fit-
ted to the lock for safety reasons

104SAFETYA fault exists in the system if

the warning lamp does not come when
the ignition is switched on,

the warning lamp does not go out a few
seconds after switching on the ignition,

the warning lamp goes out and comes
on again after switching on the ignition,

the warning lamp comes on or flickers
during the journey.
Warning
A grey white, non-harmful gas, which
is released when the airbag is in-
flated. This is perfectly normal and
is not an indication of a fire in the
vehicle.
In the event of an accident in which
the airbags are deployed:

The interior lighting comes on (if
the switch for the interior light is in
the door contact position).

The hazard warning light is
switched on.

All the doors are unlocked. Function of front airbag
The airbag system is so designed that it will
be deployed during a serious frontal collision.The effective area of the system is shown
in the illustration.
If the system is deployed, the airbags fill
with propellant gas and inflate in front of
the driver and front passenger.
The airbag is inflated in a split second and
at a high speed in order to offer the addi-
tional protection in the event of an accident.
The forward movement of the front seat
occupants is cushioned as they plunge into
the fully inflated airbag (see right-hand il-
lustration), and the risk of injury to head and
upper body is reduced. Special openings in the airbag allow a con-
trolled exit of gas when subjected to the
pressure of the occupants to cushion the
head and upper body. After an accident, the
airbag rapidly deflates again so that forward
vision is again possible.
If a person is incorrectly seated, the con-
siderable forces active when the airbag is
deployed may result in an increased risk
of injury.