2007 SKODA OCTAVIA TOUR heating

5
CONTROLS AND EQUIPMENT
Page
1 Exterior mirrors adjustable from inside* 172 Air vents73, 76, 833Lever for the multi-functional switch:
67, 68
Turn signal lights, main beam, parking light,
low beam, headlight flasher and cruise control*
4 Instrument cluster:
48, 56
Instruments and warning lights
5 Lever for windscreen wiper/ washer
50, 71with switch for multifunction display
6 Switch for heated rear window 637 Switch for ESP/TCS*638 Switch for hazard warning light system 639 Thumbwheel for seat heater*65
10 Remote fuel filler flap release from driver’s
65
seat*
11 Passenger airbag 10312 Storage compartment in the front doors -
13 Button for central locking and electrical
8, 15
power windows
14 Remote bonnet release 135
15 Switch for parking light, low beam, rear fog 62
light
and instrument lighting
66
Page
16
Storage compartment below the steering wheel
-
17 Horn, driver airbag* 10318 Lever for adjusting height of steering column19 Ignition lock 4320 Ashtrays90
21 Gearshift lever (manual gearbox), or
38, 39
Selector lever (automatic gearbox)
22 Handbrake 3623 Control for heating and air conditioning* 72, 75, 7924 Storage compartment -25 Radio
1)
-
26 Storage compartment on the front
87
passenger side

The arrangement of the controls and the styling of the dash
panel depend on the model version.

Equipment marked with * is fitted as standard only to certain
model versions or is available only for certain models as optional
equipment.

On right-hand drive vehicles the arrangement of the controls
and switches and the location of some items may vary. The sym-
bols on the controls and switches are the same as for left-hand
drive vehicles.
1)Cars with factory-fitted radio are supplied with a radio instruction lea\
flet.
43

17
CONTROLS AND EQUIPMENT
Electrically adjustable exterior mir-
rors*are set by a rotary knob in the trim panel of
the driver’s door. The mirror is set to the
desired position by moving the rotary knob
in the desired direction with the ignition
switched on.
Position
Heating exterior mirror (applies only to mo-
dels with power windows)
Position L
- left-hand and right-hand mirrors at thesame time (applies to models with con-
venience system)
- left-hand mirror (applies to models wit- hout convenience system) Position R
Adjusting the right-hand mirror
If the electrical adjustment of the mirrors
fails, the mirrors can be adjusted by hand
by pressing on the edge of the surface of
the mirror.
Exterior mirror heating(applies only to models not fitted with power
windows)
When the ignition is switched on, the exte-
rior mirrors are heated provided the rear
window heater is also operating.
Note for using convex or aspherical ex-
terior mirrors:
Convex
exterior mirrors (curved outwards)
enlarge the field of view but they make ob-
jects look smaller.
These mirrors are only of limited use in
estimating how far away a following ve-
hicle is.
Aspherical exterior mirrors have a mirror
surface with different curvature. This wide-
angle mirror increases the field of view even
more so than conventional convex mirrors.
These mirrors are also only of limited
use in estimating how far away a follow-
ing vehicle is.
Warning
Use whenever possible the interior
rear mirror, for estimating the dis-
tance to the following vehicles.

32CONTROLS AND EQUIPMENTLuggage compartment cover
(Estate)
Pull the luggage compartment cover in
the direction of the arrow into the recesses
on the sides of the luggage compartment.

The cover can be removed for transpor-
ting bulky items. Press on the side of the
transverse bars in direction of arrow 1. Take
out the cover in the direction of arrow 2.
Warning
No objects should be carried on the
luggage compartment cover. The
occupants of the car are at risk in the
event of a sudden application of the
brakes or an accident.
In addition, the heating elements of the rear
window could be damaged by objects rub-
bing against them.
Raised luggage area*
(Estate)The raised luggage area makes it easier
to put in and remove large items. This can
be removed by adopting the following pro-
cedure:

Release the luggage area by turning the
locking pins A about 90° to the left.

Raise the luggage area in direction of
arrow and take out.

Release the supporting bars B by turn-
ing the plug-in rings C about 90° to the right
and take out.

43
CONTROLS AND EQUIPMENT
Adjustable steering columnThe steering column can be adjusted for
angle and length.

First of all, properly adjust the driver’s seat.

Swivel lever below steering column down
as far as the stop.

Adjust the angle and length of the steer-
ing wheel to suit your body proportions.

Push the lever back up again - toward
the steering column.
Warning
The steering column must not be ad-
justed when driving.
For safety reasons, the lever must al-
ways be pressed firmly up again so
that the steering wheel cannot move
while the vehicle is in motion.
Ignition lockPetrol engines1 - Ignition off, engine off
2 - Ignition on
3 - Starting engineDiesel engines1 - Fuel supply cut off, engine off
2 - Preglow (ignition off)
Do not switch on any large current consum-
ers when heating the glow plugs to prevent
draining the battery unnecessarily.
3 - Starting engine
Emergency programIf a fault develops in the gearbox electron-
ics, emergency programs are activated de-
pending on the type of fault.

The gearbox does continue to shift au-
tomatically but more severe shift jolts can
be felt in this case. You should drive the
car to the nearest Škoda Dealer.

The gearbox no longer shifts automati-
cally.
In this case, the gearbox can still be shifted
manually but only 3rd gear is available in the
selector lever positions „D“ , „3“ and „2“.
1st gear and Reverse gear are available as
usual when the selector lever is moved into
positions „1“ and „R“.
However, the torque converter has to per-
form more work, particularly because 2nd
gear is no longer available. In such cases,
it is possible that the gear oil may become
too warm.
It is therefore necessary to drive the car
immediately to a Škoda Dealer.

45
CONTROLS AND EQUIPMENT

Avoid high revs and running the engine
at full load until the engine has reached its
normal operating temperature.

Do not allow the engine to idle for a
lengthy period. If the engine is running
when the car is stationary, there is not al-
ways an adequate flow of air through the
radiator. In certain circumstances, this can
result in the engine overheating and also
in engine damage.

On vehicles with a catalytic converter
the engine must not be started by tow-
ing the vehicle more than 50 m. Other-
wise, unburnt fuel can pass into the
catalytic converter and cause damage.

Before trying to start engine by tow-
ing, use the battery from another vehi-
cle for jump-starting if possible - see
page 177.
Petrol enginesThese engines are equipped with a petrol
injection system that automatically supplies
the correct fuel/air mixture at all ambient
temperatures.
The information for starting these engines
therefore applies irrespective of the outside
temperature and is the same whether the
engine is cold or at normal operating
temperature :

Do not operate throttle before and
when starting the engine.

If the engine does not start immediately,
do not operate the starter for more than 10
seconds and wait about 30 seconds before
repeating the attempt to start the engine.

If the engine is very hot, it may be nec-
essary to depress the throttle slightly after
the engine starts.

If the engine still does not start, the fuse
for the electric fuel pump may have blown -
see page 167.
Contact your Škoda Dealer in this case.
Diesel enginesGlow plug system
After switching on the Drive position (igni-
tion on), the glow warning light comes on.
Start the engine immediately after the warn-
ing light goes out.
Starting a cold engine
Ambient temperature above +5 °C:
The engine can be started immediately
without preglow. Do not operate throttle
when starting engine.
Ambient temperature below +5 °C:

Turn the key in ignition lock to position
„2“ (see page 43) - the glow warning light
comes on. It goes out after the ignition tem-
perature is reached (see page 57).
While the glow plugs are working, do not
switch on any other major electrical
components as this would place an un-
necessary load on the battery.

When the warning lamp goes out, start
the engine immediately.

63
CONTROLS AND EQUIPMENT
Fog lights*The fog lights are switched on by pull-
ing the switch into position A.
The fog lights come on if the side lights,
low or main beam are switched on.Rear fog lightThe rear fog light is switched on by pull-
ing the switch into position B.
The rear fog light comes on if the low or
main beam is selected or if the front fog
lights are switched on (depends on the
national version). The rear fog light should
only be switched on if visibility is poor, be-
cause of the risk of dazzling a driver be-
hind.
Notes

The rear fog light is incorporated in the
rear light of the driver’s side.

The electrical system of the towing de-
vice fitted for certain countries is designed
to automatically switch off the rear fog light
of the car when towing a trailer fitted with a
rear fog light.
1 - Hazard warning system
2 - Rear window heater/Exte-
rior mirror heater
3 - ESP/TCS*
(The switch applies to the
ESP or TCS, depending on the sys-
tem fitted. See pages 64 and 65 for
further information on ESP and TCS.
4 - Thumbwheel for front seat heater*
5 - Remote fuel filler flap re- leased from driver’s seat*
1 - Hazard warning systemIf the hazard warning system is switched
on, all the turn signal lights of the car flash
at the same time. The warning light for the
turn signals and the warning light in the
switch also flash. The system operates
even if the ignition is switched off.2 - Rear window heaterThe heating operates only if the ignition is
switched on. When the heater is operating,
the warning light in the switch comes on.
After the rear window heater is switched on,
the heaters of the exterior mirrors are also
switched on on models fitted with power
windows.
The rear window heater switches off au-
tomatically after 20 minutes.
If you press the switch once again, the
rear window heater is switched on perma-
nently - the automatic deactivation is thus
deactivated.
As soon as the rear window is clear, switch off the heater. The reduced
current consumption improves your fuel consumption - see also page 118.
2

65
CONTROLS AND EQUIPMENT
3 - Traction control system* TCSVehicles fitted with the anti-lock brake sys-
tem (ABS) can additionally be equipped
with a traction control system (TCS).
On front-wheel drive vehicles, the TCS pre-
vents the driven wheels from slipping when
the car is accelerated, by reducing the en-
gine output. The system operates in com-
bination with the ABS over the entire vehi-
cle speed range. If a fault develops in the
ABS, the TCS is also affected.
The TCS switches on automatically when
the engine is started. If desired, the sys-
tem can be switched off and on by press-
ing the pushbutton.
If the system is switched off, the TCS warn-
ing lamp comes on - refer to page 60.
The TCS should always be switched on in
normal driving conditions. It is only benefi-
cial to switch off the system in certain ex-
ceptional cases if wheel slip is desired.For example:
- when driving with snow chains
- when starting off in deep snow or on a
loose surface
- when rocking the car free if it has got stuck.
The system should be switched on again
after this.
Note
The same tyres must be fitted to all four
wheels if the TCS system is to operate
properly. Differing rolling circumferences of
the tyres can result in an undesirable re-
duction in engine output.
Repairs on the vehicle (e.g. on engine,
braking system, chassis or another combi-
nation of wheels and tyres) can influence
the function of the ASR.
Warning
Always adapt your style of driving to
the condition of the road and the traf-
fic situation. The increased safety
offered by the TCS system must not
induce you to take risks with your
safety.
The traction control system greatly facili-
tates starting-off, accelerating and climb-
ing hills, or at all makes this possible, even
when driving on poor road conditions.
4 - Knurled wheel for seat heating*The cushion and backrest of the front seats
can be heated electrically when the igni-
tion is on.
The heater can be switched on with the
appropriate knurled wheel and regulated as
desired.
To switch heating off, turn knurled wheel to
the basic position „0“.
Note
Do not switch on the seat heater until after
starting the engine. This considerably re-
duces the drain on the battery capacity.5 - Releasing fuel filler flap from driver’s seat*The fuel filler flap opens when the switch is
pressed. For further information - see page
127.

72CONTROLS AND EQUIPMENTAfter the ignition is switched off, you have
to re-activate the rain sensor. To do this,
move the lever into position 0 and then back
again into position 1.
Warning
Do not use the windscreen washer
system at low temperatures, without
heating the windscreen beforehand.
Otherwise the window cleaner could
freeze on the windscreen and restrict
the view to the front.Headlight washer system*When the side lights, low beam or main
beam are switched on, the headlight lenses
are also washed every time the windscreen
is washed.
There is a time delay of about 3 second af-
ter operating the lever (position 5) before
the headlights are washed.
Stubborn dirt (such as insect residues)
should be removed from the headlight
lenses at regular intervals, for example
when refuelling.
In winter, also clean off any snow on the
washer nozzles or use de-icing spray to re-
move the ice to ensure proper operation.
Rear window
Intermittent wipe
Stalk in position 6.
The wiper operates every 6 seconds.

Automatic wash/wipe*
Push down stalk away from steering wheel
into position 7. The washer system and the
wiper operate so long as the stalk remains
in this position.
Release stalk. The washer system no lon-
ger operates and the wiper performs a fur-
ther 1 to 3 sweeps (depending on the length
of the washing operation).
The stalk remains in position 6 after be-
ing released.

Switching off intermittent wipe
Stalk in position 0.
Heating and ventilationControlsRotary control A - temperature selection
clockwise - increases heat output
anti-clockwise - decreases heat output
Rotary switch B - blower and shutting-
off air supply
The quantity of air which flows through the
heater is regulated with rotary switch B.
The air supply can be regulated in four
stages.
The blower is switched off in position 0. To
switch off the fresh air supply press button
D , see below. The air supply should only
be switched off for a short time as the win-
dows may mist up.