2007 SATURN SKY ECU

Front Seats..................................................... 8
Manual Seats................................................ 8
Driver Seat Height Adjuster........................... 9
Reclining Seatbacks.................................... 10
Seatback Latches........................................ 12
Safety Belts.................................................. 12
Safety Belts: They Are for Everyone........... 12
Questions and Answers About
Safety Belts............................................. 17
How to Wear Safety Belts Properly............. 18
Driver Position............................................. 18
Safety Belt Use During Pregnancy.............. 26
Passenger Position...................................... 27
Safety Belt Pretensioners............................ 27
Safety Belt Extender................................... 27
Child Restraints............................................ 28
Older Children............................................. 28
Infants and Young Children......................... 30
Child Restraint Systems.............................. 34Lower Anchors and Tethers for
Children (LATCH).................................... 38
Securing a Child Restraint in the
Passenger Seat Position.......................... 38
Airbag System.............................................. 43
Where Are the Airbags?.............................. 45
When Should an Airbag Inate?.................. 47
What Makes an Airbag Inate?................... 48
How Does an Airbag Restrain?................... 48
What Will You See After an
Airbag Inates?........................................ 48
Passenger Sensing System......................... 50
Servicing Your Airbag-Equipped Vehicle...... 54
Adding Equipment to Your
Airbag-Equipped Vehicle.......................... 55
Restraint System Check............................... 56
Checking the Restraint Systems.................. 56
Replacing Restraint System Parts
After a Crash........................................... 57
Section 1 Seats and Restraint Systems
7
ProCarManuals.com

4. Push the latch plate into the buckle until
it clicks.
Pull up on the latch plate to make sure it is
secure.
If the belt is not long enough, seeSafety Belt
Extender on page 27.
Make sure the release button on the buckle is
positioned so you would be able to unbuckle
the safety belt quickly if you ever had to.
5. To make the lap part tight, pull up on the
shoulder belt.
It may be necessary to pull stitching on the
safety belt through the latch plate to fully
tighten the lap belt on smaller occupants.
19
ProCarManuals.com

The best way to protect the fetus is to protect the
mother. When a safety belt is worn properly, it
is more likely that the fetus will not be hurt
in a crash. For pregnant women, as for anyone,
the key to making safety belts effective is wearing
them properly.
Passenger Position
To learn how to wear the passenger’s safety belt
properly, seeDriver Position on page 18.
The passenger’s safety belt works the same way
as the driver’s safety belt — except for one
thing. If you ever pull the shoulder portion of the
belt out all the way, you will engage the child
restraint locking feature. If this happens, just let
the belt go back all the way and start again.
Safety Belt Pretensioners
Your vehicle has safety belt pretensioners for the
driver and right front passenger. Although you
cannot see them, they are part of the safety belt
assembly. They help tighten the safety belts during
the early stages of a moderate to severe frontal
or near frontal crash if the threshold conditions for
pretensioner activation are met.Pretensioners work only once. If they activate in
a crash, you will need to get new ones, and
probably other new parts for your safety belt
system. SeeReplacing Restraint System Parts
After a Crash on page 57.
Safety Belt Extender
If the vehicle’s safety belt will fasten around you,
you should use it.
But if a safety belt is not long enough, your retailer
will order you an extender. When you go in to
order it, take the heaviest coat you will wear, so
the extender will be long enough for you. To
help avoid personal injury, do not let someone else
use it, and use it only for the seat it is made to
t. The extender has been designed for adults.
Never use it for securing child seats. To wear
it, just attach it to the regular safety belt. For more
information, see the instruction sheet that comes
with the extender.
27
ProCarManuals.com

Every time infants and young children ride in
vehicles, they should have the protection provided
by appropriate restraints. Young children should
not use the vehicle’s adult safety belts alone,
unless there is no other choice. Instead, they
need to use a child restraint.
{CAUTION:
People should never hold a baby in their
arms while riding in a vehicle. A baby
does not weigh much — until a crash.
During a crash a baby will become so
heavy it is not possible to hold it. For
example, in a crash at only 25 mph
(40 km/h), a 12 lb (5.5 kg) baby will
suddenly become a 240 lb (110 kg) force
on a person’s arms. A baby should be
secured in an appropriate restraint.
31
ProCarManuals.com

{CAUTION:
Newborn infants need complete support,
including support for the head and neck.
This is necessary because a newborn
infant’s neck is weak and its head weighs
so much compared with the rest of its
body. In a crash, an infant in a rear-facing
seat settles into the restraint, so the
crash forces can be distributed across
the strongest part of an infant’s body,
the back and shoulders. Infants always
should be secured in appropriate infant
restraints.
{CAUTION:
The body structure of a young child is
quite unlike that of an adult or older child,
for whom the safety belts are designed.
A young child’s hip bones are still so
small that the vehicle’s regular safety belt
may not remain low on the hip bones, as
it should. Instead, it may settle up around
the child’s abdomen. In a crash, the belt
would apply force on a body area that is
unprotected by any bony structure. This
alone could cause serious or fatal injuries.
Young children always should be secured
in appropriate child restraints.
33
ProCarManuals.com

Q:How Should I Use a Child Restraint?
A:A child restraint system is any device designed
for use in a motor vehicle to restrain, seat,
or position children. A built-in child restraint
system is a permanent part of the motor
vehicle. An add-on child restraint system is a
portable one, which is purchased by the
vehicle’s owner. To help reduce injuries, an
add-on child restraint must be secured in
the vehicle. With built-in or add-on child
restraints, the child has to be secured within
the child restraint.
When choosing an add-on child restraint, be
sure the child restraint is designed to be
used in a vehicle. If it is, it will have a label
saying that it meets federal motor vehicle
safety standards. Then follow the instructions
for the restraint. You may nd these
instructions on the restraint itself or in a
booklet, or both.
Securing an Add-on Child Restraint
in the Vehicle
{CAUTION:
A child can be seriously injured or killed
in a crash if the child restraint is not
properly secured in the vehicle. Make sure
the child restraint is properly installed in
the vehicle using the vehicle’s safety belt,
following the instructions that came with
that restraint, and also the instructions in
this manual.
To help reduce the chance of injury, the child
restraint must be secured in the vehicle. Child
restraint systems must be secured in vehicle seats
by lap belts or the lap belt portion of a lap-shoulder
belt. A child can be endangered in a crash if the
child restraint is not properly secured in the
vehicle.
36
ProCarManuals.com

When securing an add-on child restraint, refer
to the instructions that come with the restraint
which may be on the restraint itself or in a booklet,
or both, and to this manual. The child restraint
instructions are important, so if they are not
available, obtain a replacement copy from the
manufacturer.
Keep in mind that an unsecured child restraint can
move around in a collision or sudden stop and
injure people in the vehicle. Be sure to properly
secure any child restraint in your vehicle — even
when no child is in it.
Securing the Child Within the
Child Restraint
There are several systems for securing the child
within the child restraint. One system, the
three-point harness, has straps that come down
over each of the infant’s shoulders and buckle
together at the crotch. The ve-point harness
system has two shoulder straps, two hip straps,
and a crotch strap.A shield may take the place of hip straps. A
T-shaped shield has shoulder straps that are
attached to a at pad which rests low against the
child’s body. A shelf- or armrest-type shield
has straps that are attached to a wide, shelf-like
shield that swings up or to the side.
{CAUTION:
A child can be seriously injured or killed
in a crash if the child is not properly
secured in the child restraint. Make sure
the child is properly secured, following
the instructions that came with that
restraint.
Because there are different systems, it is important
to refer to the instructions that come with the
restraint. A child can be endangered in a crash
if the child is not properly secured in the child
restraint.
37
ProCarManuals.com

Lower Anchors and Tethers for
Children (LATCH)
Some child restraints have a LATCH system.
As part of the LATCH system, your child restraint
may have lower attachments and/or a top
tether. The LATCH system can help hold the
child restraint in place during driving or in a crash.
Some vehicles have lower and/or top tether
anchors designed to secure a child restraint with
lower attachments and/or a top tether.
Some child restraints with a top tether are
designed to be used whether the top tether is
anchored or not. Other child restraints require that
the top tether be anchored. A national or local
law may require that the top tether be anchored.
In Canada, the law requires that forward-facing
child restraints have a top tether, and that
the tether be attached.
Your vehicle does not have lower anchors or
top tether anchors to secure a child restraint
with the LATCH system. If a national or local
law requires that your top tether be anchored, do
not use a child restraint in this vehicle because
a top tether cannot be properly anchored.You must use the safety belts to secure your child
restraint in this vehicle, unless a national or
local law requires that the top tether be anchored.
Refer to your child restraint instructions and
instructions in this manual for securing a child
restraint using the vehicle’s safety belts.
Securing a Child Restraint in the
Passenger Seat Position
Your vehicle has a passenger’s airbag. In addition,
your vehicle has the passenger sensing system.
The passenger sensing system is designed to
turn off the passenger’s frontal airbag when
an infant in a rear-facing infant seat or a small
child in a forward-facing child restraint or booster
seat is detected. SeePassenger Sensing
System on page 50andPassenger Airbag Status
Indicator on page 131for more information on
this including important safety information.
38
ProCarManuals.com