2007 SATURN AURA light

Parade Dimming
Parade dimming is a separate lighting mode that
comes on while the parking lamps are turned
on during the day. It prevents the display lights and
indicator lights from being dim, while the parking
lamps are used during the day.
Overhead Console Reading Lamps
The vehicle may have reading lamps on the
overhead console. These lamps come on when
the doors are opened if the lamp switch is
not in the OFF position. Press the side of each
lamp to turn them on and off, while the doors are
closed.
Overhead Ambient Lighting
These lamps will automatically turn on and off as
controlled by the light sensor located on top of
the instrument panel.
Trunk Lamp
The trunk lamp comes on when the trunk is open
and turns off when it is closed.
Battery Run-Down Protection
Your vehicle has a battery run-down feature
designed to protect the vehicle’s battery.
When any interior lamp (trunk, reading lamps, or
dome lamp) is left on when the ignition is
turned off, the battery run-down protection system
automatically shuts the lamp off after 20 minutes.
This prevents draining of the battery.
To reactivate the interior lamps, do one of the
following:
Open any door.
Press any Remote Keyless Entry (RKE)
transmitter button.
Press the power door lock switch.
Press the remote trunk release.
Turn the lamp that was left on to off and then
to on again.
152
ProCarManuals.com

Manual Operation
The air delivery mode or fan speed, can manually
be adjusted.
Fan Speed Knob
9(Off):Select this position to turn off the fan.
Outside air still enters the vehicle. The direction
can be changed by changing the mode position.
The temperature can also be adjusted using either
the up or down arrow temperature buttons.
9(Fan):Turn the knob with the fan symbol to
manually adjust the fan speed.
wxTemperature Control:Press thewand
xarrows to increase or decrease the temperature
inside the vehicle.
Air Delivery Mode Knob
H(Vent):Use this mode to direct air to the
instrument panel outlets.
)(Bi-Level):Use this mode to direct half of the
air to the instrument panel outlets, and the
remaining air to the oor outlets.
6(Floor):Use this mode to direct most of the
air to the oor outlets with some air directed to the
side window outlets.
The right knob can also be used to select defog or
defrost modes. Information on defogging and
defrosting can be found later in this section.
#(Normal Air Conditioning):Press this button
to turn the air conditioning compressor on and
off. A light above the button comes on while the air
conditioning is on.
When air conditioning is selected or is in AUTO
mode, the system runs the air conditioning
automatically to cool and dehumidify the air
entering the vehicle.
While in this mode, the hybrid system does not
shut the engine down at complete stops.
On hot days, open the windows long enough to let
hot inside air escape. This reduces the time it
takes for your vehicle to cool down. Then
keep your windows closed for the air conditioner
to work its best.
156
ProCarManuals.com

On cool, but sunny days while using manual
operation of the automatic system, use bi-level to
deliver warm air to the oor and cooler air to
the instrument panel outlets. To warm or cool the
air delivered, press the temperature buttons to
the desired setting.
In AUTO mode the system cools and dehumidies
the air inside the vehicle. Also while in AUTO
mode, the system maximizes its performance by
using recirculation as necessary.
Heating:On cold days when using manual
operation of the automatic system, use oor mode
to deliver air to the oor outlets. To warm or
cool the air delivered, push the temperature
buttons to the desired setting.
To use the automatic mode, turn the knob to
AUTO and adjust the temperature by pressing the
temperature buttons.
When the heater is in use, there might be slight
noise or vibration during Auto Stops. This is due to
the coolant circulation pump that continues to
circulate heat through the system during the
engine Auto Stop.
The heater works best if the windows are kept
closed.h(Recirculation):Press the button to turn on
the recirculation mode. The air inside the vehicle
recirculates through the climate control system and
the vehicle, not from outside your vehicle. This
mode is helpful when trying to limit odors
from entering the vehicle and for maximum air
conditioning performance in hot weather. When the
button is pressed, an indicator light above the
button comes on. The recirculation indicator light
blinks three times if recirculation is used in a
mode in which it cannot function. Only use this
mode when it is needed for comfort, since window
fogging rapidly occurs if the air conditioning
compressor is not engaged.
Press this button to cancel the auto recirculation
feature. Each time the vehicle is started, the
system reverts to the auto recirculation function.
If you select recirculation while in defrost, defog or
oor, the light on the button ashes three times
and then goes out to indicate that this is not
allowed. This is to prevent window fogging.
157
ProCarManuals.com

Defogging and Defrosting
Fog on the inside of windows is a result of high
humidity (moisture) condensing on the cool window
glass. This can be minimized if the climate
control system is used properly. There are two
modes to choose from to clear fog or frost from the
windshield. Use the defog mode to clear the
windows of fog or moisture and warm the
passengers. Use the defrost mode to remove fog
or frost from the windshield more quickly.
-(Defog):Turn the mode knob to this position
to select the defog setting, which delivers air to the
oor and windshield outlets. Use this setting to
clear the windows of fog or moisture.
0(Defrost):Turn the mode knob to this position
to defrost the windshield. The system automatically
controls the fan speed if defrost is selected from
the AUTO mode. If the outside temperature is 40°F
(4°C) or warmer, the air conditioning compressor
automatically runs to help dehumidify the air
and dry the windshield. The air conditioning
indicator light blinks three times if the compressor
is turned off while in this mode.
The engine will not perform Auto Stops when the
defrost mode is on.
Rear Window Defogger
The rear window defogger uses a warming grid to
remove fog from the rear window.
<(Rear):Press this button to turn the rear
window defogger on or off. An indicator light above
the button comes on to show that the rear
window defogger is activated.
If driving below 50 mph (80 km/h), the rear window
defogger turns off about 15 minutes after the
button is pressed. If additional warming time is
needed, press the button again.
If the vehicle’s speed is maintained above 50 mph
(80 km/h), the rear window defogger remains
on once the button is pressed.
If your vehicle has heated outside mirrors, the
surface of the outside mirrors also heat when the
rear window defogger is activated. SeeOutside
Power Mirrors on page 126.
Notice:Do not use a razor blade or sharp
object to clear the inside rear window. Do not
adhere anything to the defogger grid lines
in the rear glass. These actions may damage
the rear defogger. Repairs would not be
covered by your warranty.
159
ProCarManuals.com

Warning Lights, Gages, and
Indicators
This part describes the warning lights and gages
on your vehicle.
Warning lights and gages can signal that
something is wrong before it becomes serious
enough to cause an expensive repair or
replacement. Paying attention to the warning lights
and gages could also save you or others from
injury.
Warning lights come on when there may be or is a
problem with one of your vehicle’s functions. As
the details show on the next few pages, some
warning lights come on briey when you start the
engine just to let you know they are working. If
you are familiar with this section, you should
not be alarmed when this happens.Gages can indicate when there may be or is a
problem with one of your vehicle’s functions. Often
gages and warning lights work together to let
you know when there is a problem with your
vehicle.
When one of the warning lights comes on and
stays on as you are driving, or when one of
the gages shows there may be a problem, check
the section that tells you what to do about it.
Please follow this manual’s advice. Waiting to do
repairs can be costly and even dangerous. So
please get to know your vehicle’s warning
lights and gages. They can be a big help.
161
ProCarManuals.com

Instrument Panel Cluster
Your instrument panel cluster is designed to let you know at a glance how your vehicle is running. You
will know how fast you are going, how much fuel you are using, and many other things you will need
to drive safely and economically.
Your vehicle has this instrument panel cluster, which includes indicator warning lights and gages that are
explained on the following pages.
United States version shown, Canada Similar
162
ProCarManuals.com

Speedometer and Odometer
Your speedometer lets you see your speed in
miles per hour (mph) or kilometers per hour (km/h).
SeeDIC Vehicle Personalization on page 187
for more information.
Your odometer shows how far your vehicle has
been driven, in either miles (used in the United
States) or kilometers (used in Canada).
Your vehicle has a tamper resistant odometer.
The digital odometer will read 999,999 if someone
tries to turn it back.
You may wonder what happens if your vehicle
needs a new odometer installed. If the new
one can be set to the mileage total of the old
odometer, then it must be. But if it can’t, then it is
set at zero and a label must be put on the
driver’s door to show the old mileage reading
when the new odometer was installed.
Trip Odometer
The trip odometer can tell you how far you have
driven since you last reset it.
The trip odometer is accessed and reset through
the Driver Information Center (DIC). SeeDIC
Operation and Displays on page 180for more
information.
Tachometer
Your tachometer displays the engine speed in
revolutions per minute (rpm).
Your vehicle has auto stop and the indicator for
this is on the tachometer. For more information see
Auto Stop Mode on page 178.
Safety Belt Reminder Light
When the key is turned to ON or START, a chime
will come on for several seconds to remind
people to fasten their safety belts, unless the
driver’s safety belt is already buckled.
The safety belt light will
also come on and stay
on for several
seconds, then it will
ash for several more.
This chime and light is repeated if the driver
remains unbuckled and the vehicle is in motion.
If the driver’s belt is already buckled, neither
the chime nor the light will come on.
163
ProCarManuals.com

Passenger Safety Belt Reminder
Light
Several seconds after the key is turned to ON or
START, a chime will sound for several seconds to
remind the front passenger to buckle their safety
belt. This would only occur if the passenger airbag
is enabled. SeePassenger Sensing System on
page 77for more information. The passenger
safety belt light will also come on and stay on for
several seconds, then it will ash for several more.
This chime and light are
repeated if the
passenger remains
unbuckled and
the vehicle is in motion.
If the passenger’s safety belt is buckled, neither
the chime nor the light will come on.
Airbag Readiness Light
There is an airbag readiness light on the
instrument panel cluster, which shows the airbag
symbol. The system checks the airbag’s
electrical system for malfunctions. The light tells
you if there is an electrical problem. The
system check includes the airbag sensor, the
pretensioners, the airbag modules, the wiring and
the crash sensing and diagnostic module. For
more information on the airbag system, seeAirbag
System on page 67.
This light will come on
when you start your
vehicle, and it will ash
for a few seconds.
Then the light should go
out. This means the
system is ready.
If the airbag readiness light stays on after you
start the vehicle or comes on when you are driving,
your airbag system may not work properly.
Have your vehicle serviced right away.
164
ProCarManuals.com