Page 145 of 406

Cruise Control
Cruise control lets you maintain a speed of about
25 mph (40 km/h) or more without keeping
your foot on the accelerator. This can really help
on long trips. Cruise control does not work at
speeds below 25 mph (40 km/h).
{CAUTION:
Cruise control can be dangerous where
you cannot drive safely at a steady speed.
So, do not use your cruise control on
winding roads or in heavy traffic.
Cruise control can be dangerous on
slippery roads. On such roads, fast
changes in tire traction can cause
excessive wheel slip, and you could lose
control. Do not use cruise control on
slippery roads.
Setting Cruise Control
{CAUTION:
If you leave your cruise control on when
you are not using cruise, you might hit a
button and go into cruise when you do not
want to. You could be startled and even
lose control. Keep the cruise control switch
off until you want to use cruise control.
The cruise control
buttons are located on
the steering wheel.
I(On/Off):PressIto turn the cruise control
system on and off.
145
Page 146 of 406

RES+ (Resume):Press RES+ to resume a set
speed and to accelerate the speed.
SET−(Set):Press SET– to set a speed and to
decrease the speed.
To set a speed do the following:
1. Press
Ito turn cruise control on. The
indicator light on the button comes on.
2. Get up to the desired speed.
3. Press the SET−and release it. The cruise
symbol displays in the instrument panel
cluster to show the system is engaged.
4. Take your foot off the accelerator pedal.
When the brakes are applied, the cruise control
shuts off.
If the vehicle is in cruise control and the Traction
Control System (TCS) begins to limit wheel
spin, the cruise control automatically disengages.
SeeTraction Control System (TCS) on page 217.
When road conditions allow, the cruise control
can be used again.
Resuming a Set Speed
Suppose you set the cruise control at a desired
speed and then apply the brakes. This disengages
the cruise control. The cruise symbol in the
instrument panel cluster also goes out indicating
cruise is no longer engaged. To return to the
previously set speed, you do not need to
go through the set process again. Once the
vehicle is at a speed of about 25 mph (40 km/h) or
more, you can brie y press the RES+.
This takes the vehicle back up to the previously
chosen speed and stays there.
Increasing Speed While Using Cruise
Control
There are two ways to go to a higher speed.
If the cruise control system is already
engaged, press the RES+. Hold it there until
you reach the desired speed, and then release
the button.
To increase the vehicle’s speed in very small
amounts, brie y press the RES+ and then
release it. Each time this is done, the vehicle
goes about 1 mph (1.6 km/h) faster.
146
Page 151 of 406

Instrument Panel Brightness
The control for this
feature is located on the
instrument panel to
the left of the steering
wheel.
Turn the knob clockwise or counterclockwise to
brighten or dim the lights.
Dome Lamp
Your vehicle might have a dome lamp without a
switch. If the dome lamp has a switch, the
following are the settings.
9(Off):Move the lever to this position to turn
the lamp off, even when a door is open.
1(Door):Move the lever to this position so that
the lamp comes on when a door is opened.
+(On):Move the lever to this position to turn
the dome lamp on.
Entry/Exit Lighting
The lamps inside the vehicle come on when any
door is opened. These lamps fade out about
20 seconds after all of the doors have been closed
or when the ignition is turned to ON. They also
go on when you press the unlock symbol button or
the horn symbol on the Remote Keyless Entry
(RKE) system transmitter.
The lamps inside the vehicle stay on for about
20 seconds after the key is removed from
the ignition to provide light as you exit.
151
Page 160 of 406

Outlet Adjustment
There are four main air outlets on the instrument
panel. Use the lever located in the center of
each outlet by moving it either side-to-side or up
and down, to change the direction and amount
of air ow in the vehicle. The center thumbwheel
does not control the main outlets.
Dedicated Rear Seat Air Outlet
For vehicles with this feature, the dedicated rear
seat air outlet is located in the center of the
instrument panel above the two main center
outlets. This outlet is aimed to provide comfort to
the rear seat passengers, especially while
using air conditioning in warm weather.
Use the thumbwheel in the center of the outlet to
turn the air ow on or off. This can be adjusted
to improve front seat passenger comfort if
there are no rear seat passengers. The direction
of air ow cannot be adjusted since it is directed
towards the rear seat passengers.
Do not attempt to move the horizontal vent vane,
as breakage can occur.
Operation Tips
Clear away any ice, snow, or leaves from the
air inlets at the base of the windshield that
can block the ow of air into your vehicle.
Do not use non-GM approved hood de ectors
as they could adversely affect the performance
of the system.
Keep the path under the front seats clear of
objects to help circulate the air inside of
your vehicle more effectively.
When an objectionable odor outside the
vehicle is encountered, use the recirculation
mode, with the temperature knob at a
comfortable setting to prevent the odor from
entering the vehicle through the ventilation
system. This can be helpful when driving
through a long tunnel with poor ventilation.
However, extended usage of this mode in cold
or cool weather can cause window fogging.
160
Page 179 of 406