2007 PONTIAC VIBE engine

At Least Once a Year
Key Lock Cylinders Service
Lubricate the key lock cylinders with the lubricant
specied in Part D.
Seat Operation Check
Make sure the head restraints stay in position and
all seat latches lock. Check that the recliner
holds by pushing and pulling the seatback while it
is reclined.
Body Lubrication Service
Lubricate all hood latch assembly, secondary
latch, pivots, spring anchor, release pawl, hood
and body door hinges, rear compartment, and any
folding seat hardware. Part D tells you what to
use. More frequent lubrication may be required
when exposed to a corrosive environment.
Starter Switch Check
{CAUTION:
When you are doing this inspection, the
vehicle could move suddenly. If the
vehicle moves, you or others could be
injured.
1. Before you start, be sure you have enough
room around the vehicle.
2. Firmly apply both the parking brake and the
regular brake. SeeParking Brake on
page 114.
Do not use the accelerator pedal, and be
ready to turn off the engine immediately if
it starts.
388

3. On automatic transaxle vehicles, try to start
the engine in each gear. The vehicle should
start only in PARK (P) or NEUTRAL (N). If the
vehicle starts in any other position, contact
your GM Goodwrench
®dealer for service.
On manual transaxle vehicles, put the
shift lever in NEUTRAL (N), push the clutch
pedal down halfway, and try to start the
engine. The vehicle should start only when
the clutch pedal is pushed down all the way to
the oor. If the vehicle starts when the
clutch pedal is not pushed all the way down,
contact your GM Goodwrench
®dealer for
service.
Automatic Transaxle Shift Lock Control
System Check
{CAUTION:
When you are doing this inspection, the
vehicle could move suddenly. If the
vehicle moves, you or others could be
injured.
1. Before you start, be sure you have enough
room around the vehicle. It should be parked
on a level surface.
2. Firmly apply the parking brake. SeeParking
Brake on page 114.
Be ready to apply the regular brake
immediately if the vehicle begins to move.
3. With the engine off, turn the ignition to ON,
but do not start the engine. Without applying
the regular brake, try to move the shift
lever out of PARK (P) with normal effort. If the
shift lever moves out of PARK (P), contact
your GM Goodwrench
®dealer for service.
389

Park on a fairly steep hill, with the vehicle facing
downhill. Keeping your foot on the regular
brake, set the parking brake.
To check the parking brake’s holding ability:
With the engine running and transaxle in
NEUTRAL (N), slowly remove foot pressure
from the regular brake pedal. Do this until the
vehicle is held by the parking brake only.
To check the PARK (P) mechanism’s holding
ability: With the engine running, shift to
PARK (P). Then release the parking brake
followed by the regular brake.
Contact your GM Goodwrench
®dealer if service is
required.
Underbody Flushing Service
At least every spring, use plain water to ush any
corrosive materials from the underbody. Take
care to clean thoroughly any areas where mud and
other debris can collect.
391

Part C: Periodic Maintenance
Inspections
Listed in this part are inspections and services
which should be performed at least twice a
year (for instance, each spring and fall).You
should let your dealer’s service department
do these jobs. Make sure any necessary repairs
are completed at once.
Proper procedures to perform these services may
be found in a service manual. SeeService
Publications Ordering Information on page 417.
Steering, Suspension and Front
Drive Axle Boot and Seal Inspection
Inspect the front and rear suspension and
steering system for damaged, loose or missing
parts, signs of wear or lack of lubrication. Inspect
the power steering lines and hoses for proper
hook-up, binding, leaks, cracks, chang, etc. Clean
and then inspect the drive axle boot seals for
damage, tears or leakage. Replace seals if
necessary.
Exhaust System Inspection
Inspect the complete exhaust system. Inspect the
body near the exhaust system. Look for broken,
damaged, missing or out-of-position parts as
well as open seams, holes, loose connections or
other conditions which could cause a heat
build-up in the oor pan or could let exhaust fumes
into the vehicle. SeeEngine Exhaust on
page 119.
Fuel System Inspection
Inspect the complete fuel system for damage
or leaks.
392

Engine Cooling System Inspection
Inspect the hoses and have them replaced if
they are cracked, swollen or deteriorated. Inspect
all pipes, ttings and clamps; replace as needed.
Clean the outside of the radiator and air
conditioning condenser. To help ensure proper
operation, a pressure test of the cooling system
and pressure cap is recommended at least
once a year.
Throttle System Inspection
Inspect the throttle system for interference or
binding, and for damaged or missing parts.
Replace parts as needed. Replace any
components that have high effort or excessive
wear. Do not lubricate accelerator and cruise
control cables.
Brake System Inspection
Inspect the complete system. Inspect brake lines
and hoses for proper hook-up, binding, leaks,
cracks, chang, etc. Inspect disc brake pads for
wear and rotors for surface condition. Also inspect
drum brake linings for wear and cracks. Inspect
other brake parts, including drums, wheel
cylinders, calipers, parking brake, etc. Check
parking brake adjustment. You may need to have
your brakes inspected more often if your driving
habits or conditions result in frequent braking.
393

Part D: Recommended Fluids and
Lubricants
Fluids and lubricants identied below by name,
part number, or specication can be obtained from
your dealer.
Usage Fluid/Lubricant
Engine OilEngine oil which meets GM
Standard GM6094M and displays
the American Petroleum Institute
Certied for Gasoline Engines
starburst symbol. GM Goodwrench
®
oil meets all the requirements for
your vehicle. To determine the
proper viscosity for your vehicle’s
engine, seeEngine Oil on page 284.
Engine Coolant50/50 mixture of clean, drinkable
water and use only DEX-COOL
®
Coolant. SeeEngine Coolant on
page 294.
Hydraulic
Brake/Clutch
SystemDelco
®Supreme 11 Brake Fluid or
equivalent DOT-3 brake uid.
Usage Fluid/Lubricant
Windshield
Washer SolventGM Optikleen
®Washer Solvent.
Power Steering
SystemDEXRON
®-VI Automatic
Transmission Fluid.
Manual
TransaxleGM Goodwrench
®Synthetic
Manual Transmission Fluid
(GM Part No. U.S. 12346190,
in Canada 10953477 — 1 quart) or
SAE 75W-90 GL-5 gear oil.
Automatic
TransaxleUse only T-IV Automatic
Transmission Fluid
(GM Part No. U.S. 88900925, in
Canada 22689186). SeeAutomatic
Transaxle Fluid on page 290.
Key Lock
CylindersMulti-Purpose Lubricant, Superlube
(GM Part No. U.S. 12346241,
in Canada 10953474).
Manual
Transaxle Shift
LinkageChassis Lubricant
(GM Part No. U.S. 12377985,
in Canada 88901242) or lubricant
meeting requirements of NLGI #2,
Category LB or GC-LB.
394

Reporting Safety Defects to
General Motors
In addition to notifying NHTSA (or Transport
Canada) in a situation like this, we certainly hope
you’ll notify us. Please call us at 1-800-762-2737,
or write:
Pontiac Customer Assistance Center
P.O. Box 33172
Detroit, MI 48232-5172
In Canada, please call us at 1-800-263-3777
(English) or 1-800-263-7854 (French). Or, write:
General Motors of Canada Limited
Customer Communication Centre, CA1-163-005
1908 Colonel Sam Drive
Oshawa, Ontario L1H 8P7
Service Publications Ordering
Information
Service Manuals
Service Manuals have the diagnosis and repair
information on engines, transmission, axle
suspension, brakes, electrical, steering, body, etc.
Transmission, Transaxle, Transfer
Case Unit Repair Manual
This manual provides information on unit
repair service procedures, adjustments, and
specications for GM transmissions, transaxles,
and transfer cases.
Service Bulletins
Service Bulletins give technical service information
needed to knowledgeably service General
Motors cars and trucks. Each bulletin contains
instructions to assist in the diagnosis and service
of your vehicle.
In Canada, the service bulletin reference number
can be obtained by contacting your General Motors
dealer or by calling 1-800-GM-DRIVE
(1-800-463-7483). This reference number is
needed to order the service bulletin from Helm, Inc.
RETAIL SELL PRICE: $6.00 US + Processing Fee
417

A
Accessories and Modications..................... 272
Accessory Power Outlet(s).......................... 150
Adding Equipment to Your Airbag-Equipped
Vehicle....................................................... 81
Additives, Fuel............................................ 275
Add-On Electrical Equipment....................... 364
Air Cleaner/Filter, Engine............................. 288
Air Conditioning........................................... 152
Airbag
Passenger Status Indicator....................... 163
Readiness Light....................................... 162
Airbag Sensing and Diagnostic
Module (SDM).......................................... 411
Airbag System............................................... 63
Adding Equipment to Your
Airbag-Equipped Vehicle......................... 81
How Does an Airbag Restrain?.................. 72
Passenger Sensing System....................... 74
Servicing Your Airbag-Equipped Vehicle..... 80
What Makes an Airbag Inate?.................. 71
What Will You See After an Airbag
Inates?................................................. 72
When Should an Airbag Inate?................. 70
Where Are the Airbags?............................. 66Antenna, Fixed Mast................................... 219
Antenna, XM™ Satellite Radio
Antenna System....................................... 219
Anti-Lock Brake System (ABS).................... 227
Anti-Lock Brake, System Warning Light....... 167
Appearance Care
Aluminum Wheels.................................... 359
Care of Safety Belts................................ 357
Chemical Paint Spotting........................... 361
Cleaning Exterior Lamps/Lenses.............. 358
Cleaning the Inside of Your Vehicle.......... 354
Fabric/Carpet........................................... 356
Finish Care.............................................. 358
Finish Damage......................................... 361
Instrument Panel, Vinyl, and Other
Plastic Surfaces.................................... 357
Leather.................................................... 356
Sheet Metal Damage............................... 360
Tires........................................................ 360
Underbody Maintenance........................... 361
Vehicle Care/Appearance Materials.......... 362
Washing Your Vehicle.............................. 358
Weatherstrips........................................... 358
Windshield, Backglass, and
Wiper Blades........................................ 359
Ashtray(s).................................................... 151
419