2007 PONTIAC SOLSTICE heat

Ination - Tire Pressure
Tires need the correct amount of air pressure to
operate effectively.
Notice:Do not let anyone tell you that
under-ination or over-ination is all right.
It is not. If your tires do not have enough air
(under-ination), you can get the following:
Too much exing
Too much heat
Tire overloading
Premature or irregular wear
Poor handling
Reduced fuel economy
If your tires have too much air (over-ination),
you can get the following:
Unusual wear
Poor handling
Rough ride
Needless damage from road hazardsA Tire and Loading Information label is attached
to the vehicle’s center pillar (B-pillar), below
the driver’s door latch. This label shows your
vehicle’s original equipment tires and the correct
ination pressures for your tires when they
are cold. The recommended cold tire ination
pressure, shown on the label, is the minimum
amount of air pressure needed to support
your vehicle’s maximum load carrying capacity.
For additional information regarding how much
weight your vehicle can carry, and an example
of the Tire and Loading Information label,
seeLoading Your Vehicle on page 226. How you
load your vehicle affects vehicle handling and
ride comfort, never load your vehicle with more
weight than it was designed to carry.
When to Check
Check your tires once a month or more.
292

Temperature – A, B, C
The temperature grades are A (the highest),
B, and C, representing the tire’s resistance to the
generation of heat and its ability to dissipate
heat when tested under controlled conditions on a
specied indoor laboratory test wheel. Sustained
high temperature can cause the material of the tire
to degenerate and reduce tire life, and excessive
temperature can lead to sudden tire failure.
The grade C corresponds to a level of performance
which all passenger car tires must meet under
the Federal Motor Vehicle Safety Standard
No. 109. Grades B and A represent higher levels
of performance on the laboratory test wheel
than the minimum required by law.
Warning:The temperature grade for this tire is
established for a tire that is properly inated
and not overloaded. Excessive speed,
underination, or excessive loading, either
separately or in combination, can cause heat
buildup and possible tire failure.
Wheel Alignment and Tire Balance
The tires and wheels on your vehicle were aligned
and balanced carefully at the factory to give you
the longest tire life and best overall performance.
Adjustments to wheel alignment and tire
balancing will not be necessary on a regular basis.
However, if you notice unusual tire wear or your
vehicle pulling to one side or the other, the
alignment may need to be checked. If you notice
your vehicle vibrating when driving on a smooth
road, your tires and wheels may need to be
rebalanced. See your dealer for proper diagnosis.
Wheel Replacement
Replace any wheel that is bent, cracked, or badly
rusted or corroded. If wheel nuts keep coming
loose, the wheel, wheel bolts and wheel nuts
should be replaced. If the wheel leaks air, replace
it (except some aluminum wheels, which can
sometimes be repaired). See your dealer if any of
these conditions exist.
299

Appearance Care
Cleaning the Inside of Your Vehicle
Your vehicle’s interior will continue to look its
best if it is cleaned often. Although not always
visible, dust and dirt can accumulate on your
upholstery. Dirt can damage carpet, fabric, leather,
and plastic surfaces. Regular vacuuming is
recommended to remove particles from your
upholstery. It is important to keep your upholstery
from becoming and remaining heavily soiled.
Soils should be removed as quickly as possible.
Your vehicle’s interior may experience extremes
of heat that could cause stains to set rapidly.
Lighter colored interiors may require more frequent
cleaning. Use care because newspapers and
garments that transfer color to your home
furnishings may also transfer color to your
vehicle’s interior.
When cleaning your vehicle’s interior, only use
cleaners specically designed for the surfaces
being cleaned. Permanent damage may result from
using cleaners on surfaces for which they were
not intended. Use glass cleaner only on glass.Remove any accidental over-spray from other
surfaces immediately. To prevent over-spray, apply
cleaner directly to the cleaning cloth.
Notice:If you use abrasive cleaners when
cleaning glass surfaces on your vehicle, you
could scratch the glass and/or cause damage
to the rear window defogger. When cleaning
the glass on your vehicle, use only a soft cloth
and glass cleaner.
Many cleaners contain solvents that may become
concentrated in your vehicle’s breathing space.
Before using cleaners, read and adhere to
all safety instructions on the label. While cleaning
your vehicle’s interior, maintain adequate
ventilation by opening your vehicle’s doors and
windows.
Dust may be removed from small buttons and
knobs using a small brush with soft bristles.
Your dealer has a product for cleaning your
vehicle’s glass. Should it become necessary, you
can also obtain a product from your dealer to
remove odors from your vehicle’s upholstery.
314

3. Start on the outside edge of the soil and
gently rub toward the center. Continue
cleaning, using a clean area of the cloth each
time it becomes soiled.
4. Continue to gently rub the soiled area until
the cleaning cloth remains clean.
5. If the soil is not completely removed, use a
mild soap solution and repeat the cleaning
process that was used with plain water.
If any of the soil remains, a commercial fabric
cleaner or spot lifter may be necessary. When a
commercial upholstery cleaner or spot lifter is to be
used, test a small hidden area for colorfastness
rst. If the locally cleaned area gives any
impression that a ring formation may result, clean
the entire surface.
After the cleaning process has been completed,
a paper towel can be used to blot excess moisture
from the fabric or carpet.Leather
A soft cloth dampened with water may be used
to remove dust. If a more thorough cleaning
is necessary, a soft cloth dampened with a mild
soap solution can be used. Allow the leather to
dry naturally. Do not use heat to dry. Never
use steam to clean leather. Never use spot lifters
or spot removers on leather. Many commercial
leather cleaners and coatings that are sold
to preserve and protect leather may permanently
change the appearance and feel of your leather
and are not recommended. Do not use silicone or
wax-based products, or those containing organic
solvents to clean your vehicle’s interior because
they can alter the appearance by increasing
the gloss in a non-uniform manner. Never use
shoe polish on your leather.
316

Look at the silver-colored band inside the fuse.
If the band is broken or melted, replace the fuse.
Be sure you replace a bad fuse with a new
one of the identical size and rating.
If you ever have a problem on the road and do not
have a spare fuse, you can borrow one that has
the same amperage. Just pick some feature of your
vehicle that you can get along without — like the
radio or cigarette lighter — and use its fuse, if it
is the correct amperage. Replace it as soon as
you can.
Floor Console Fuse Block
The oor console fuse block is located on the
passenger’s side of the vehicle under the carpet.
Remove the fuse block cover to access the
fuses. Use the fuse puller to remove fuses.
After re-installing the fuse block cover, be sure to
tuck the carpet under the heater oor outlets.
Fuses Usage
1 Fuse Puller
2 Empty
3 Empty
4 Empty
5 Empty
327

Part C: Periodic Maintenance
Inspections
Listed in this part are inspections and services
which should be performed at least twice a
year (for instance, each spring and fall).You
should let your dealer’s service department
do these jobs. Make sure any necessary repairs
are completed at once.
Proper procedures to perform these services may
be found in a service manual. SeeService
Publications Ordering Information on page 380.
Steering and Suspension Inspection
Inspect the front and rear suspension and
steering system for damaged, loose or missing
parts, signs of wear or lack of lubrication. Inspect
the power steering lines and hoses for proper
hook-up, binding, leaks, cracks, chang, etc.
Exhaust System Inspection
Inspect the complete exhaust system. Inspect the
body near the exhaust system. Look for broken,
damaged, missing or out-of-position parts as
well as open seams, holes, loose connections
or other conditions which could cause a heat
build-up in the oor pan or could let exhaust fumes
into the vehicle. SeeEngine Exhaust on page 91.
Fuel System Inspection
Inspect the complete fuel system for damage
or leaks.
351

Electronic Stability Control Indicator Light...... 136
Engine
Air Cleaner/Filter...................................... 254
Battery..................................................... 273
Check and Service Engine Soon Light..... 138
Coolant.................................................... 257
Coolant Temperature Warning Light.......... 137
Cooling System Inspection....................... 352
Drive Belt Routing.................................... 356
Engine Compartment Overview................ 244
Exhaust..................................................... 91
Oil ........................................................... 247
Oil Life System........................................ 252
Overheating............................................. 260
Reduced Power Light............................... 143
Starting...................................................... 80
Entry/Exit Lighting....................................... 120
Event Data Recorders (EDR)...................... 373
Extender, Safety Belt..................................... 26
F
Filter
Engine Air Cleaner................................... 254
Finish Damage............................................ 322
Fixed Mast Antenna.................................... 187Flashers, Hazard Warning........................... 110
Flash-to-Pass.............................................. 113
Flat Tire...................................................... 302
Fluid
Automatic Transmission............................ 256
Manual Transmission................................ 256
Power Steering........................................ 268
Windshield Washer.................................. 269
Fog Lamps.................................................. 120
Fuel............................................................ 237
Additives.................................................. 238
California Fuel.......................................... 238
Filling a Portable Fuel Container.............. 242
Filling Your Tank...................................... 240
Fuels in Foreign Countries....................... 239
Gage....................................................... 144
Gasoline Octane...................................... 237
Gasoline Specications............................ 237
Low Warning Light................................... 145
System Inspection.................................... 351
Fuses
Floor Console Fuse Block........................ 327
Fuses and Circuit Breakers...................... 326
Underhood Fuse Block............................. 329
387

G
Gage
Fuel......................................................... 144
Speedometer........................................... 129
Tachometer.............................................. 129
Gasoline
Octane..................................................... 237
Specications........................................... 237
Glove Box..................................................... 98
GM Mobility Reimbursement Program.......... 367
H
Hazard Warning Flashers............................ 110
Headlamp Wiring......................................... 326
Headlamps.........................................118, 280
Bulb Replacement.................................... 280
Daytime Running Lamps.......................... 119
Flash-to-Pass........................................... 113
Front Turn Signal, Parking and
Fog Lamps........................................... 281
Halogen Bulbs......................................... 280
High/Low Beam Changer......................... 112
On Reminder........................................... 119
Heater......................................................... 122Highbeam On Light..................................... 143
Highway Hypnosis....................................... 217
Hill and Mountain Roads............................. 218
Hood
Checking Things Under............................ 242
Release................................................... 243
Horn............................................................ 110
How to Use This Manual................................ 4
How to Wear Safety Belts Properly............... 18
Hydraulic Clutch.......................................... 256
I
Ignition Positions........................................... 77
Infants and Young Children, Restraints.......... 30
Ination - Tire Pressure............................... 292
Inator Kit, Tire........................................... 303
Inspection
Brake System.......................................... 352
Engine Cooling System............................ 352
Exhaust System....................................... 351
Fuel System............................................ 351
Part C - Periodic Maintenance.................. 351
Steering and Suspension ......................... 351
Throttle System........................................ 352
388