STEERING WHEEL SWITCHES FOR AUDIO
CONTROL (if so equipped)
To choose Preset A, B, C, CD or SAT (if so
equipped) press MODE repeatedly.
The tuning up or down< > switch can be used to
perform the following:
• Push the< > switch for less than 1.5 seconds
to change to a preset station.
• Push and hold the
< > switch for more than 1.5 seconds to seek the next or previous
broadcasting radio station.
• Push the
< >
switch while playing a CD (if so equipped) for less than 1.5 seconds to
change programs on the CD.
• If the vehicle is equipped with a CD changer, push and hold the
< >
switch for more
than 1.5 seconds to change between CDs.
CRUISE CONTROL
To activate the cruise control, push the ON.OFF
switch. The indicator light in the instrument panel
will illuminate.
To set cruising speed, accelerate the vehicle to
desired speed, push the COAST/SET switch
and release it. The SET indicator light in the
instrument panel will illuminate.
To reset at a faster cruising speed, push and hold the ACCEL/RES switch. When
the vehicle attains the speed you desire, release the switch.
To reset at a slower cruising speed, push and hold the COAST/SET switch.
Release the switch when the vehicle slows to the desired speed.
To cancel cruise control, push the CANCEL switch or tap the brake pedal. The SET
indicator light in the instrument panel will go out.
To resume a preset speed, push and release the ACCEL/RES switch. The
vehicle returns to the last set cruising speed when the vehicle speed is over
25 MPH (40 km/h)
To turn off cruise control, push the ON.OFF switch. Both the CRUISE indicator light and
the SET light in the instrument panel will go out.
SEAT BELT WARNING LIGHT AND CHIME
The light and chime remind you to fasten your seat belts. The light illuminates whenever the ignition key is turned to the ON or START position and remains illuminated until the driver’s seat belt is fastened. At the same time, the chime sounds for approximately 6 seconds unless the driver’s seat belt is securely fastened.
The seat belt warning light may also illuminate if the front passenger’s seat belt is not fastened when the front passenger’s seat is occupied. For 7 seconds after the ignition switch is in the ON position, the system does not activate the warning light for the front passenger.
Refer to the Owner’s Manual for detailed information regarding seat belt usage.
FRONT SEAT ADJUSTMENTS
With manual seats (passenger’s seat if so equipped):
F ORWARD AND BACKWARD
Pull up on the lever under the front of the seat and slide forward or backward. Release
the lever to lock the seat in position.
R ECLINING
Lift the lever on the side of the seat to adjust your seatback forward or backward;
release the lever when you have found a comfortable angle and the seat belt fits
properly.
W ITH POWER SEATS
(driver’s seat, if so equipped for passenger’s seat):
F ORWARD AND BACKWARD
Move the control 01 forward or backward to
adjust the seat cushion forward or backward.
Pull up on the control 01 to raise the
driver’s seat cushion; press down to lower
the cushion.
R ECLINING
Push the switch 02 forward to move the seatback
forward; push it back to move the seatback backward.
L UMBAR SUPPORT
(driver’s seat, manual or power, if so equipped):
Your driver’s seat has a lumbar support; adjust it by moving the manual lever up or
down. Or, if equipped with power lumbar, adjust it by pushing the switch 03 forward
or backward.
02
03
01
FOLDING DOWN THE REAR SEATS
(5 passenger model only)
FROM INSIDE THE VEHICLE
Press the release button 01 to fold down the
center/passenger’s side rear seat.
Reach through the opening and pull on the
strap 02 located behind the seat to fold
down the driver’s side rear seat.
F ROM THE TRUNK
Pull the strap 03 located behind the seat to
fold down the center/passenger’s side rear
seat.
Pull on the strap 04 located behind the seat
to fold down the driver’s side rear seat.
0304
01
02
