2007 NISSAN ALTIMA light

[x] Cancel search: light

Page 289 of 344

NISSAN ALTIMA 2007 L32A / 4.G Owners Manual Replacement procedures
All other lights are either type A, B, C or D. When
replacing a bulb, first remove the lens, lamp
and/or cover.
Indicates bulb removal
Indicates bulb installation
WDI0263
Step l

Page 290 of 344

NISSAN ALTIMA 2007 L32A / 4.G Owners Manual Rear map light
LDI0572
High-mounted stop light (rear window)
WDI0320
Trunk light
WDI0343
8-30Maintenance and do-it-yourself
ZREVIEW COPYÐ2007 Altima(alt)
Owners ManualÐUSA_English(nna)
10/27/06Ðdeb

Page 291 of 344

NISSAN ALTIMA 2007 L32A / 4.G Owners Manual If you have a flat tire, see the “In case of
emergency” section of this manual.
TIRE PRESSURE
Tire Pressure Monitoring System
(TPMS)
This vehicle is equipped with the Tire
Pressure Monitoring Syst

Page 300 of 344

NISSAN ALTIMA 2007 L32A / 4.G Owners Manual cThe original tires have built-in
tread wear indicators. When the
wear indicators are visible, the
tire(s) should be replaced.
cTires degrade with age and use.
Have tires, including the spare,
over 6

Page 304 of 344

NISSAN ALTIMA 2007 L32A / 4.G Owners Manual The following are approximate capacities. The actual refill capacities may be slightly different. When refilling, follow the procedure
described in the “Maintenance and do-it-yourself” section to

Page 306 of 344

NISSAN ALTIMA 2007 L32A / 4.G Owners Manual If any driveability problems such as engine stall-
ing and difficult hot-starting are experienced after
using oxygenate-blend fuels, immediately
change to a non-oxygenate fuel or a fuel with a
low ble

Page 314 of 344

NISSAN ALTIMA 2007 L32A / 4.G Owners Manual Use the following steps to mount the front license
plate:
s1Make a shallow hole in each plastic finisher
at the location mark (small dimple) using a
0.31 in (8 mm) drill. To avoid damaging the
threads

Page 322 of 344

NISSAN ALTIMA 2007 L32A / 4.G Owners Manual Safety chains
Always use suitable safety chains between your
vehicle and the trailer. The safety chains should
be crossed and should be attached to the hitch,
not to the vehicle bumper or axle. Be sur