WT-36
TROUBLE DIAGNOSIS FOR SYMPTOMS
Revision: 2006 November2007 350Z
2. CHECK TIRE PRESSURE WARNING CHECK SWITCH CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect BCM harness connector.
3. Check continuity between BCM harness connector M90 terminal
15 and ground.
OK or NG
OK >> Replace BCM. Refer to BCS-17, "Removal and Installa-
tion of BCM" .
NG >> Repair or replace harness connector.
Turn Signal Lamp Blinks When Ignition Switch Is Turned OnNES0001T
DIAGNOSTIC PROCEDURE
1. CHECK TIRE PRESSURE WARNING CHECK SWITCH CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect BCM harness connector.
3. Check continuity between BCM harness connector M90 terminal
15 and ground.
OK or NG
OK >> Check turn signal lamp operation. Refer to LT- 6 5 ,
"TURN SIGNAL AND HAZARD WARNING LAMPS" .
NG >> Repair or replace harness connector.
ID Registration Can Not Be CompletedNES0001U
DIAGNOSTIC PROCEDURE
1. ID REGISTRATION (ALL)
Perform ID registration of all transmitters.
Can ID registration of all transmitters be completed?
YES >> INSPECTION END
NO >> GO TO WT-30, "
TROUBLE DIAGNOSIS FOR SELF-DIAGNOSTIC ITEMS" . Continuity should exist.
SEIA0438E
Continuity should exist.
SEIA0438E
