INTERIOR ROOM LAMP
LT-147
C
D
E
F
G
H
I
J
L
MA
B
LT
Revision: 2006 November2007 350Z
4. CHECK POWER SUPPLY CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect BCM connector and map lamp connector.
3. Check continuity between BCM harness connector (A) and map
lamp harness connector (B).
OK or NO
OK >> GO TO 5.
NG >> Repair harness or connector.
5. CHECK SHORT CIRCUIT
Check continuity between map lamp harness connector and ground.
OK or NG
OK >> Replace BCM if map lamp does not work after setting
the connector again. Refer to BCS-17, "
Removal and
Installation of BCM" .
NG >> Repair harness or connector.
6. CHECK MAP LAMP
1. Turn ignition switch OFF.
2. Disconnect map lamp connector.
3. Check continuity between map lamp.
OK or NG
OK >> GO TO 7.
NG >> Replace map lamp.
Terminals
Continuity AB
Connector Terminal Connector Terminal
M91 41 R53 2 Yes
SKIB9084E
Map lamp connector Terminal
GroundContinuity
R53 2 No
SKIB9085E
Terminal
Condition Continuity
Map lamp
32Map lamp switch is DOOR. Yes
Map lamp switch is OFF. No
SKIB9086E
