FRONT DISC BRAKE
BR-33
C
D
E
G
H
I
J
K
L
MA
B
BR
Revision: 2006 November2007 350Z
4. Attach the brake tube bracket to the knuckle spindle and tighten
to the specified torque.
5. Using a flare nut crowfoot and torque wrench, tighten the caliper
assembly and brake tube connection flare nut to the specified
torque.
6. Attach brake pad. Refer to BR-30, "
Removal and Installation of
Brake Pad (With Brembo Calipers)" .
7. Refill new brake fluid and bleed air. Refer to BR-11, "
Bleeding Brake System" .
8. Install tires to vehicle.
Disassembly and Assembly of Brake Caliper Assembly (Other than Brembo
Calipers)
NFS000AW
NOTE:
Do not remove torque member, brake pads, shims, shim covers and pad retainers, when disassembling or
assembling cylinder body.
DISASSEMBLY
1. Remove caliper assembly from vehicle. Refer to BR-31,
"Removal and Installation of Brake Caliper Assembly (Other
than Brembo Calipers)" .
2. Remove sliding pin bolts from cylinder body, and remove pads,
shims, shim cover and pad retainers from torque member.
CAUTION:
When removing pad retainer from torque member, lift the
pad retainer in the direction shown by arrow (shown in the
figure) so as not to deform it.
3. Remove sliding pins and sliding pin boots from torque member.
4. Place a wooden block as shown in the figure, and blow air from
union bolt mounting hole to remove pistons and piston boots.
CAUTION:
Do not get fingers caught in the pistons.
5. Using a flat-bladed screwdriver, remove piston seals from cylin-
der body.
CAUTION:
Be careful not to damage the inner wall of cylinder.: 10.8 – 15.6 N·m (1.1 – 1.5 kg-m, 8 – 11 ft-lb)
: 14.8 – 17.6 N·m (1.5 – 1.7 kg-m, 11 – 12 ft-lb)
PFIA0229E
SBR556E
BRB0032D
SFIA0141E
