2007 MINI Hardtop 2 Door wheel bolts

Replacing components
108
Distributing liquid sealant
Immediately drive for approx. 10 minutes, so
that the liquid sealant is uniformly distributed.
Do not exceed a speed of 35 mph/
60 km/h.
If possible, do not drive at a speed lower than
12 mph/20 km/h.<
Checking tire inflation pressure
1.After driving for approx. 10 minutes, pull
over at a suitable location.
2.Screw the hose with manometer back onto
the tire valve.
3.Check the tire inflation pressure.
The tire inflation pressure must be at
least 18.9 psi/1.3 bar. If it is not, do not
continue driving.<
If at least 18.9 psi/1.3 bar are displayed:
1.Switch on the compressor. Correct the tire
inflation pressure to the specified value,
page86.
2.Replace the tire as soon as possible.
Driving on
Do not exceed the permitted maximum
speed of 50 mph/80 km/h; doing so may
result in an accident.<
Replace the defective tire as soon as possible
and have the new wheel/tire assembly bal-
anced.
Have the MINI Mobility System refilled.
Tire change set
When changing a tire, always observe the safety
measures and the procedure for changing tires
described below.
In case of a flat tire the tire change set is
not needed due to the availability of the
MINI Mobility System.<
Changing wheels
Tire change set for space-saver spare
tire*
On vehicles with a space-saver spare tire, the
tire change set with onboard tools is stored in
the cargo area under the floor mat.
1Chock, folding
2Wheel stud wrench
3Vehicle jack
4Special wrench for removing the space-
saver spare tire
5Flat screwdriver/Phillips screwdriver
6Towing eyelet
7Adapter for wheel lug lock
8Wrench
9Lifting handle
The onboard tool kit includes a pouch with a
plastic bag in which you can place the damaged
wheel.
Space-saver spare tire*
To change a space-saver spare tire, proceed as
follows:
>Remove space-saver spare tire, page109
>Prepare for tire change, page109
>Jack up vehicle, page110
>Mount space-saver spare tire, page110
>Tighten lug bolts, page110
>Drive with space-saver spare tire, page109

Replacing components
110
Only change the tire when parked on a surface
that is level, firm and not slippery.
The vehicle or the jack could slip sideways on
soft or slippery support surfaces, such as snow,
ice, flagstones, etc.
Do not use a wooden block or similar object as a
support base for the jack, as this would prevent
it from extending to its full support height and
reduce its load-carrying capacity.
Do not lie under the vehicle or start the engine
when the vehicle is supported by the jack; other-
wise there is a risk of fatal injury.<
1.Place the foldable chock
* behind the front
wheel on the other side of the vehicle or in
front of the wheel if the vehicle is on an
incline. If the wheel is changed on a surface
with a more severe slope, take additional
precautions to secure the vehicle from roll-
ing.
2.Uncover the lug bolts if necessary.
If the wheel is equipped with a hub cover,
pry it off using the screwdriver from the tire
change kit.
3.Loosen the lug bolts by a half turn.
Jacking up the vehicle
The vehicle jack is designed for changing
wheels only. Do not attempt to raise
another vehicle model with it or to raise any load
of any kind. To do so could cause accidents and
personal injury.<
1.Place the jack at the jacking point closest to
the wheel.The jack base must be perpendicular to the
surface beneath the jacking point.
2.During jacking up, insert the jack head in the
square recess of the jacking point.
3.Jack the vehicle up until the wheel you are
changing is raised off the ground.
Mounting the space-saver spare tire
1.Unscrew the lug bolts and remove the
wheel.
2.Remove accumulations of mud or dirt from
the mounting surfaces of the wheel and
hub. Clean the lug bolts.
3.Lift the new wheel into place.
4.Screw at least two lug bolts finger-tight into
opposite bolt holes.
5.Screw in the remaining bolts.
6.Tighten all the lug bolts firmly in a diagonal
pattern.
7.Lower the vehicle.
8.Remove the jack.
Tightening the lug bolts
Tighten the lug bolts in a diagonal pattern.
Immediately have the wheels checked
using a calibrated torque wrench to
ensure that the lug bolts are firmly seated, oth-
erwise a serious accident could result if a wheel
comes loose.<
Tightening torque: 103.3 lb ft/140 Nm.
Replace the defective tire as soon as possible
and have the new wheel/tire assembly bal-
anced.

From A to Z
142
Temperature of coolant, refer
to Coolant temperature44
Temperature setting
– air conditioner65
– automatic climate control67
Tensioning straps, refer to
Securing cargo80
The individual vehicle5
Third brake lamp, refer to
Center brake lamp106
Three-point safety belt30
Tightening the lug bolts
– keys108
– torque110
Tightening torque, refer to
Tightening the lug bolts110
Tire change set
– MINI Mobility System108
– space-saver spare tire108
Tire failure
– MINI Mobility System106
– space-saver spare tire108
Tire inflation pressure86
– loss56
– space-saver spare tire86
Tire pressure monitoring, refer
to Flat Tire Monitor55
Tire Quality Grading90
Tires
– age91
– breaking in76
– changing, refer to Changing
wheels108
– condition91
– damage91
– flat tire92
– inflation pressure86
– minimum tread depth91
– new tires92
– pressure monitoring, refer to
Flat Tire Monitor55
– puncture56
– size90
– wear indicators, refer to
Minimum tread depth91
– winter tires93
Tires with safety features, refer
to Run-Flat Tires92Tools, refer to Onboard tool
kit102
Torque130
– lug bolts110
Tow bar114
Tow fitting113
– screw thread113
Tow fittings for tow-starting
and towing away113
Towing113
– car with automatic
transmission114
– methods
114
Tow rope114
Tow-starting113
Track width, refer to
Dimensions131
Traction control, refer to
– DSC Dynamic Stability
Control54
Trailer towing
– trailer load and gross
weight132
Transmission
– automatic transmission with
Steptronic37
– manual transmission37
– overriding selector lever lock
for automatic transmission
with Steptronic39
Transporting children safely33
Transport securing devices,
refer to Securing cargo80
Tread depth, refer to Minimum
tire tread91
Trip-distance counter, refer to
Trip odometer44
Triple turn signal activation40
Trip odometer44
Trunk lamp, refer to Cargo area
lamp62
Trunk lid, refer to Tailgate23
Turning circle, refer to
Dimensions131
Turn signal indicator
– front, replacing bulb104
– rear, replacing bulb105
– side, replacing bulb105Turn signal indicators39
– indicator lamp12
Tying down loads, refer to
Cargo loading80
U
Uniform Tire Quality Grading
UTQR90
Units
– average consumption47
– temperature47
Universal garage door opener,
refer to Integrated universal
remote control69
Universal remote control69
Unlatching, refer to
Unlocking24
Unlocking
– from inside22
– from outside19
– tailgate24
– without remote control, refer
to Convenient access24
Upholstery, care100
V
Valve
– dust cap109
Vehicle
– battery111
– breaking in76
– cargo loading78
– dimensions131
– Identification Number, refer
to Engine compartment95
– parking36
– storage101
– weight132
Vehicle jack108
Ventilation
– air conditioner68
Vents, refer to Air vents64
Vents, refer to Ventilation68
Volume of cargo area132