2007 Mercury Mariner Hybrid warning light

[x] Cancel search: warning light

Page 17 of 336

Mercury Mariner Hybrid 2007  Owners Manuals Never remove the coolant reservoir cap while the engine is
running or hot.
Low tire pressure warning:
Illuminates when your tire pressure
is low. If the light remains ON at
start up or while driving,

Page 98 of 336

Mercury Mariner Hybrid 2007  Owners Manuals HIGH ENGINE TEMPERATURE.Displayed when the engine coolant
is overheating. Engine coolant temperature warning lamp will illuminate
indicating coolant temperature is high. Stop the vehicle as soon as sa

Page 99 of 336

Mercury Mariner Hybrid 2007  Owners Manuals CHECK FUEL CAP.Displayed when the fuel filler cap is not properly
installed. Check the fuel filler cap for proper installation. Refer toFuel
filler capin theMaintenance and Specificationschapter.
SERV

Page 128 of 336

Mercury Mariner Hybrid 2007  Owners Manuals •Front crash severity sensor
•Restraints Control Module (RCM) with impact and safing sensors
•Driver’s seat position sensor
•Restraint system warning light and back-up tone
•The electrical

Page 130 of 336

Mercury Mariner Hybrid 2007  Owners Manuals will light and stay lit to remind you that the front passenger frontal
airbag is off. SeeFront passenger sensing systemin the airbags section
of this chapter.
Front safety belt usage sensors
The front

Page 131 of 336

Mercury Mariner Hybrid 2007  Owners Manuals •A series of five beeps will be heard. The tone pattern will repeat
periodically until the problem and warning light are repaired.
If any of these things happen, even intermittently, have the Safety

Page 136 of 336

Mercury Mariner Hybrid 2007  Owners Manuals Safety belt extension assembly
If the safety belt is too short when fully extended, there is an 8 inch (20
cm) safety belt extension assembly that can be added (part number
611C22). This assembly can

Page 137 of 336

Mercury Mariner Hybrid 2007  Owners Manuals Conditions of operation
If... Then...
The driver’s safety belt is not
buckled before the ignition
switch is turned to the ON
position...The safety belt warning light
illuminates 1 minute and the war