2007 MERCEDES-BENZ S CLASS brakes

584 Practical hintsWhat to do if …?Display
Possible cause/consequence
Possible solution
Currently unavailable
See Oper. Manual
ESP
® and PRE-SAFE
® are temporarily un-
available. It is possible that the self-diag-
nostics have not yet completed.
In addition, the yellow ESP
® warning
lampv comes on.
The brake system functions normally.

Synchronize the ESP
®:
Drive a short distance with gentle turns at a
speed above 12 mph (20 km/h).
The message disappears when ESP
® is again
available.
Currently unavailable
See Oper. Manual
ESP
® and PRE-SAFE
® are switched off due
to undervoltage. It is possible that the bat-
tery is not charged.
The brake system functions normally.

Continue driving with added caution.

Have the system checked at an authorized
Mercedes-Benz Center as soon as possible.
Failure to follow these instructions increases the
risk of an accident.
Currently unavailable
See Oper. Manual
If the yellow ESP
® warning lampv flash-
es while driving and this message appears,
the ETS has switched off to prevent over-
heating of the drive wheel brakes.
As soon as the brakes have cooled off, the ETS
switches on again.
The message in the multifunction display disap-
pears and the ESP
® warning lampv goes
out.

632 Practical hintsFlat tire
Replace this wheel bolt with alignment
bolt1 supplied in the tool kit.

Remove the remaining bolts.

Remove the wheel.
Mounting the Minispare wheel
1Wheel bolt for light alloy rims
2Wheel bolt for Minispare wheel
(located in trunk with spare wheel)

Clean contact surfaces of wheel and
wheel hub.

Guide the Minispare wheel onto the
alignment bolt and push it on.

Insert wheel bolts2 and tighten them
slightly.
!
Do not place wheel bolts in sand or dirt. This
could result in damage to the bolt and wheel hub
threads.
!
Wheel bolts2 must be used when mount-
ing the Minispare wheel. The use of any wheel
bolts other than wheel bolts2 for the Minispare
wheel will physically damage the vehicle’s
brakes.
Warning!
G
Make sure to use the original length wheel
bolts when remounting the original wheel
after it has been repaired.!
To avoid paint damage, place wheel flat
against hub and hold it there while installing first
wheel bolt.
Warning!
G
Always replace wheel bolts that are dam-
aged or rusted.
Never apply oil or grease to wheel bolts.
Damaged wheel hub threads should be re-
paired immediately. Do not continue to drive
under these circumstances! Contact an au-
thorized Mercedes-Benz Center or call
Roadside Assistance.
Incorrect wheel bolts or improperly tight-
ened wheel bolts can cause the wheel to
come off. This could cause an accident.
Make sure you are using the correct wheel
bolts.


642 Practical hintsTowing the vehicleMercedes-Benz recommends that the vehi-
cle be transported with all wheels off the
ground using flatbed or appropriate wheel
lift/dolly equipment. This method is pref-
erable to other types of towing.
When circumstances do not permit the
recommended towing methods, the vehi-
cle may be towed with all wheels on the
ground or front wheels raised only so far as necessary to have the vehicle moved to a
safe location where the recommended
towing methods can be employed.!
Do not tow-start the vehicle.
!
Use flatbed or wheel lift/dolly equipment
with SmartKey in starter switch turned to posi-
tion 0.
Do not tow with sling-type equipment. Towing
with sling-type equipment over bumpy roads will
damage radiator and supports.
To prevent damage during transport, do not tie
down vehicle by its chassis or suspension parts.
Switch off the ESP
® (page 73), the tow-away
alarm (
page 76) and the automatic central
locking (page 313).
If the vehicle’s transmission is damaged, only
have it towed with the drive shaft disconnected.
!
Make sure that the electric parking brake is
released. If the electric parking brake is malfunc-
tioning, release it mechanically (
page 616).
!
In vehicles with KEYLESS-GO, insert the
SmartKey into the starter switch under the
KEYLESS-GO button and turn the SmartKey in
the starter switch to 0.
!
If the vehicle is towed with the front axle
raised, the engine must be shut off (SmartKey in
starter switch starter switch position 0 or 1).
Otherwise the ESP
®/ETS will immediately be en-
gaged and will apply the rear wheel brakes.
While towing, the battery must be connected and
charged. Otherwise:


you will not be able to switch on the ignition


you will not be able to engage the automatic
transmission in position N
When towing the vehicle with all wheels on the
ground, the automatic transmission must be
shifted to N and the SmartKey must be in starter
switch position2.
In vehicles with KEYLESS-GO*, you must use the
starter switch under the KEYLESS-GO* button
(
page 315).
When towing the vehicle with all wheels on the
ground or the front axle raised, the vehicle may
be towed only for distances up to 30 miles
(50 km) and at a speed not to exceed 30 mph
(50 km/h).
!
To be certain to avoid a possibility of dam-
age to the drivetrain, however, we recommend
the drive shaft be disconnected at the rear axle
drive flange for any towing beyond a short tow to
a nearby garage.

672 Technical termsDVD+RW
(D
igital V
ersatile D
isc R
ew
ritable)
->DVD which can be read and written
to many times.
Dynamic Rear View Monitor*
The Dynamic Rear View Monitor is an
optical parking aid. It shows you the
area behind the vehicle on the
->COMAND display. In addition, the Dy-
namic Rear View Monitor contains
guide lines to help you with reverse
parking and parallel parking. The Dy-
namic Rear View Monitor is also called
“Park Assist” in ->COMAND display.
EBP
(E
lectronic B
rake P
roportioning)
The EBP enhances braking effective-
ness by allowing the rear brakes to sup-
ply a greater proportion of the braking
effort without a loss of vehicle stability.ELCODE
(E
lectronic Code
System)
System that electronically checks
whether a person entering or driving
the vehicle is authorized to do so. It is
part of the Mercedes-Benz anti-theft
protection program.
Electric parking brake
Protects the vehicle from rolling away
when parked. The electric parking
brake is also called “Parking brake” in
->multifunction display messages.
Emergency call
This function places a call to a local
911 provider. It does not initiate a
->Tele Aid call. Please note that the
911 emergency call system is a public
service. Using it without due cause is a
criminal offense.
Engine number
The number set by the manufacturer
and stamped on the cylinder block to
uniquely identify each engine pro-
duced.Engine oil viscosity
Measurement for the inner friction (vis-
cosity) of the oil at different tempera-
tures. The higher the temperature an
oil can tolerate without becoming thin,
or the lower the temperature it can tol-
erate without becoming viscous, the
better the viscosity.
ESP
®(Electronic S
tability P
rogram)
Improves vehicle handling and direc-
tional stability.
ETD
(E
mergency T
ensioning D
evice)
Device which deploys in certain frontal
and rear collisions exceeding the sys-
tem’s threshold to tighten the seat
belts.
->SRS

673 Technical terms
ETS
(E
lectronic T
raction S
ystem)
Automatically brakes spinning wheels,
thus ensuring
optimal ->traction at all times.
FAT
(F
ile A
llocation T
able)
A table used to locate files on a disk or
memory device.
FSS PLUS (Canada vehicles)
(F
lexible S
ervice S
ystem PLUS)
Maintenance service indicator in the
->multifunction display that informs the
driver when the next vehicle mainte-
nance service is due. FSS evaluates en-
gine temperature, oil level, vehicle
speed, engine speed, distance driven
and the time elapsed since your last
service, and calls for the next mainte-
nance service accordingly.GAWR
(G
ross A
xle W
eight R
ating)
(
page 526)
Gear range
Number of gears which are available to
the automatic transmission for shifting.
The automatic gear shifting process
can be adapted to specific operating
conditions using the selector lever.
GPS
(Global P
ositioning S
ystem)
Satellite-based system for relaying
geographic location information to and
from vehicles equipped with special re-
ceivers. Employs DVD digital maps for
navigation.
GSM
(G
lobal S
ystem for M
obile Communica-
tion)
A standard network protocol used
throughout the world for digital cellular
communication.GVW
(G
ross V
ehicle W
eight)
(
page 526)
GVWR
(Gross V
ehicle W
eight R
ating)
(
page 527)
HiP
(High P
erformance light bulbs)
Light bulbs filled with xenon which are
used in rear lamps.
ID3 tag
Additional information which may be
included in MP3 files (e.g. title, artist,
album).
Instrument cluster control system
The Instrument cluster control system
is used to call up vehicle information
and to change component settings. In-
formation and messages appear in the
->multifunction display. The driver uses
the buttons on the ->multifunction
steering wheel to navigate through the
system and to adjust settings.

681 Index
Batteries, vehicle 634
Charging 637
Discharged, Jump starting 639
Disconnecting 636
For electrical consumers 634
For starter 634
Message in display 586
Reconnecting 638
Removing 637
Bead 526
Beverage holder see Cup holder
Bi-Xenon headlamps see Headlamps
Bluetooth
Settings (COMAND) 217
Brake assist system (BAS Plus) 71
Brake assist system (BAS) 71
Brake fluid 490, 662, 663
Brake lamp bulbs 622
Brake lamp, high mounted 622
Brake pads
Message in display 575
Brake warning lamp 29
Brakes 480
Warning lamp 545Break-in period 478
Bulbs, replacing 621
Additional turn signals 622
Brake lamps 622
Fog lamps 622
Front lamps 622
High beam 622
High mounted brake lamp 622
License plate lamps 622
Low beam 622
Parking and standing lamps 622
Rear fog lamp 622
Turn signal lamps 622
C
CAC (Customer Assistance Center) 670
California retail buyers and lessees, impor-
tant notice for 15
Can holder see Cup holder
CAN system 670
Canceling
Cruise control 382
Capacities and recommended
fuel/lubricants 661Cargo area see Trunk
Cargo tie-down hooks 453
Carpets, Cleaning and care of 542
Catalytic converter 487
CD
Ejecting (COMAND) 109
Loading (COMAND) 107
Menu overview (COMAND) 110
Playback options (COMAND) 114
Selecting a medium (COMAND) 112
Selecting a track (COMAND) 113
CD (COMAND) 104
Central locking
Automatic 313
Locking/unlocking from inside 314
Central locking/unlocking switches 314
Certification label 652
Change of address or ownership 16
Changing
Vehicle level (ABC*) 404
Vehicle level (Airmatic) 402

689 Index
L
Labels 652
Certification 652
Emission control information 652
Supplemental tire inflation pressure
information 489
Tire and Loading Information 504
Vacuum line routing diagram 652
Lamp bulbs, exterior 621
Lamps, exterior
Front 622
Light sensor 596
Rear 622
Lamps, indicator and warning
ABS 29, 69, 544
Air bag Off 49
Battery (SmartKey with
KEYLESS-GO*) 310
Battery check lamp (SmartKey) 305
Brakes 545
DISTRONIC Plus* 29, 388, 397, 549
Engine diagnostics 547
Engine malfunction 547
ESP
®
549
Front passenger front air bag off 53,
555Fuel reserve 550
Instrument cluster 544
Maintenance service indicator 532
Seat belts telltale 550
SRS 552
Language (COMAND) 216
LATCH-type child seat anchors see Chil-
dren in the vehicle
Leather upholstery, Cleaning and care
of 542
Lever
For automatic transmission (gear se-
lector lever) 367
For cruise control 381
For DISTRONIC Plus* 390
License plate lamps
Messages in display 597
Replacing bulbs 622
Light alloy wheels, Cleaning 541
Light sensor
Message in display 596
Lighter see Cigarette lighter
Lighting 342
Automatic headlamp mode 343
Combination switch 346
Corner-illuminating lamps 347Courtesy lighting 350
Daytime running lamp mode 344
Door entry lamps 350
High beam flasher 347
High beams 346
Instrument cluster illumination 81,
378
Interior 348
Manual headlamp mode 343
Trunk 350
Limp-home mode 377
Line of fall 674
Loading see Vehicle loading
Locator lighting (COMAND) 221
Lock button
Door handle (KEYLESS-GO*) 309,
358
Key, SmartKey 304
Key, SmartKey with
KEYLESS-GO* 306
Trunk lid (KEYLESS-GO*) 310
Locking 363
Automatic central locking
(COMAND) 223
Vehicle in an emergency 615
Locking knob 312, 674