2007 MERCEDES-BENZ ML320CDI jump start

511 Practical hints
Battery
2Perforated floor carpet, unfolded
Fold the floor carpet piece2 in
direction of the arrow.

Move the front passenger seat to the
most forward and upward position
again (
page 44).

Switch off the ignition (
page 40).

Remove SmartKey from starter switch.
Vehicles with KEYLESS-GO*:
Make sure the vehicle’s on-board
electronics have status0 (Turn off
the engine or all electrical systems
using the KEYLESS-GO start/stop
button. Open the driver’s door. With
the driver’s door open, the vehicle’s
on-board electronics have status0,
same as with the SmartKey
removed from the starter switch).

Enter the rear passenger compartment
again.Step 4 (Disconnecting)
3Air channel
4Clip with pin insert

Pull pin out of clip4 in direction of
arrow.

Pull clip with pin4 outwards.

Remove air channel3 by pulling it out
in direction of arrow.
i
If the vehicle battery is discharged and you
had the vehicle jump started, turn off the engine.

514 Practical hintsBattery
Connect the positive lead to the posi-
tive terminal and fasten it’s cover
(page 512).

Connect the negative lead to the nega-
tive terminal (
page 512).
Charging the battery
If the battery is discharged, the battery can
be charged using the jump-start contacts
located in the engine compartment
(page 516).

Charge the battery in accordance with
the instructions of the battery charger
manufacturer.
Batteries contain materials that can harm
the environment if disposed of improperly.
Large 12-volt storage batteries contain
lead. Recycling of batteries is the preferred
method of disposal. Many states require
sellers of batteries to accept old batteries
for recycling.
!
Never invert the terminal connections!
i
The following procedures must be carried
out following any interruption of battery power
(e.g. due to reconnection):


Set the clock (
page 169).
Vehicles with COMAND system with naviga-
tion module*: Time and date are set auto-
matically.


Synchronize the door windows
(page 238).


Synchronize the power tilt/sliding sunroof*
(page 244).


Synchronize the power folding exterior rear
view mirrors* (
page 202).
Warning!
G
Never charge a battery while still installed in
the vehicle unless the accessory battery
charge unit approved by Mercedes-Benz is
being used. Gases may escape during charg-
ing and cause explosions that may result in
paint damage, corrosion or personal injury.
An accessory battery charge unit specially
adapted for Mercedes-Benz vehicles and
tested and approved by Mercedes-Benz is
available, permitting the charging of the
battery in its installed position. Contact an
authorized Mercedes-Benz Light Truck
Center for information and availability.
Charge battery in accordance with the
separate instructions for the accessory
battery charger.


515 Practical hints
Jump starting
Jump starting
If the battery is discharged, the engine can
be started with jumper cables and the bat-
tery of another vehicle. Observe the follow-
ing:

Jump starting should only be performed
using the jump-start contacts located
in the engine compartment
(page 516).


Jump starting should only be performed
when the engine and catalytic
converter
1 are cold.


Do not start the engine if the battery is
frozen. Let the battery thaw out first.


Only jump start from batteries with the
same voltage rating (12 V). Jump start-
ing with a more powerful battery could
damage the vehicle’s electrical system,
which will not be covered by the
Mercedes-Benz Limited Warranty.


Only use jumper cables with sufficient
cross-section and insulated terminal
clamps.


Always make sure the jumper cables
are not on or near pulleys, fans or other
parts that move when the engine is
started or running.
Warning!
G
Failure to follow these directions will cause
damage to the electronic components, and
can lead to a battery explosion and severe
injury or death.
Never lean over batteries while connecting
or jump starting, you might get injured.
Battery fluid contains sulfuric acid. Do not
allow this fluid to come in contact with eyes,
skin or clothing. In case it does, immediately
flush affected area with water, and seek
medical help if necessary.
A battery will also produce hydrogen gas,
which is flammable and very explosive. Keep
flames or sparks away from battery, avoid
improper connection of jumper cables,
smoking, etc.
Attempting to jump start a frozen battery
can result in it exploding, causing personal
injury.
Read all instructions before proceeding.
1Vehicles with gasoline engine only.
!
Do not tow-start the vehicle.
!
Avoid repeated and lengthy starting
attempts.
Do not attempt to start the engine using a
battery quick charge unit.
If the engine does not run after several unsuc-
cessful starting attempts, have it checked at the
nearest authorized Mercedes-Benz Light Truck
Center.
Excessive unburned fuel generated by repeated
failed starting attempts may damage the catalyt-
ic converter
1.
Make sure the jumper cables do not have loose
or missing insulation.
Make sure the cable clamps do not touch any
other metal part while the other end is still at-
tached to a battery.

516 Practical hintsJump startingThe jump-start contacts are located in the
engine compartment.1Negative (-) terminal
2Positive (+) terminal

Make sure the two vehicles do not
touch.

Turn off all electrical consumers.

Apply parking brake.

Set automatic transmission to
positionP.

Open the hood (
page 356).

Open cover of positive terminal2.1Positive terminal of charged battery
2Positive terminal of discharged battery
3Negative terminal of charged battery
4Negative terminal of discharged
battery
Warning!
G
Keep flames or sparks away from battery.
Do not smoke.
Observe all safety instructions and precau-
tions when handling automotive batteries
(page 507).

517 Practical hints
Jump starting

Connect positive terminal1 and2
with the jumper cable. Clamp cable to
charged battery1 first.

Start engine of the vehicle with the
charged battery and run at idle speed.

Connect negative terminals3 and4
of the batteries with the second jumper
cable. Clamp the cable to negative
terminal3 of the charged battery
first.

Start the engine of the disabled vehi-
cle.You can now turn on the electrical con-
sumers. Do not switch on the headlamps
under any circumstances.

Remove the jumper cables first from
negative terminals4 and3 and then
from positive terminals2 and1.
You can now switch on the headlamps.

Have the battery checked at the near-
est authorized Mercedes-Benz Light
Truck Center.
!
Never invert the terminal connections!

519 Practical hints
Towing the vehicle
Warning!
G
If circumstances require towing the vehicle
with all wheels on the ground, always tow
with a tow bar if:

the engine will not run


there is a malfunction in the power
supply or in the vehicle’s electrical sys-
tem
Prior to towing the vehicle with all wheels on
the ground, make sure the starter switch is
in position2 (
page 40).
Warning!
G
With the engine not running, there is no
power assistance for the brake and steering
systems. In this case, it is important to keep
in mind that a considerably higher degree of
effort is necessary to brake and steer the
vehicle. Adapt your driving accordingly.
i
To signal turns while being towed with
hazard warning flasher in use, set the starter
switch to position2 and activate combination
switch for left or right turn signal in usual manner
– only the selected turn signal will operate.
Upon canceling the turn signal, the hazard
warning flasher will operate again.
i
If the battery is disconnected or discharged,
the automatic transmission will remain locked in
positionP and the SmartKey will not turn in the
starter switch. For more information, see “Bat-
tery” (page 507) and “Jump starting”
(
page 515).
!
When towing the vehicle with all wheels on
the ground, note the following:
With the automatic central locking activated and
the ignition in position2 (
page 40), the vehicle
doors lock if the left front wheel is turning at a
speed of approximately 9 mph (15 km/h) or
above.
To prevent the vehicle doors from locking,
deactivate the automatic central locking
(
page 126).
Towing of the vehicle should only be done using
the towing eye bolt. Never attach tow cable, tow
rope or tow rod to vehicle chassis, frame or sus-
pension parts.

554 IndexAutomatic climate control (3-zone)* 220
Air conditioning, Cooling 230, 231
Air distribution, Front 226
Air distribution, Rear 234
Air recirculation mode 228
Air vents, Front 226
Air volume 227
Control panel, Front 222
Control panel, Rear 232
Deactivating system 224
Defogging 227
Defrosting 227
Maximum cooling, MAX COOL 228
Rear passenger compartment 232
Rear window defroster 205
Residual engine heat (REST) 232
Using driver-side settings for
all temperature zones 231
Automatic headlamp mode 137
Automatic lighting control, Interior
lighting 143
Automatic locking when driving 126
Automatic shift program
(ML 63 AMG only) 196Automatic transmission 54
Accelerator position 191
Automatic shift program
(ML 63 AMG only) 196
Emergency operation
(Limp-Home Mode) 198
Gear ranges 193
Gear selector lever 54, 185
Gear shifting malfunctions 198
Hill start assist system 192
Kickdown 191
Kickdown, manual shift program
(ML 63 AMG only) 198
Manual shift progam
(ML 63 AMG only) 196
Program mode selector switch
(ML 63 AMG only) 195
Shift program (ML 63 AMG only) 195
Shifting procedure 188
Starting the engine 54
Steering wheel gearshift control 194
Towing a trailer 192
Transmission fluid level 362
Transmission positions 189
Automatic Transmission Fluid see ATFB
Backrest
Seat 44
Seat, Lumbar support 130
Seat, Multicontour* 130
Backup lamps
Messages in the
multifunction display 458
Replacing bulbs 490
Bar 395
BAS 97
Lamps in instrument cluster 414
Messages in the
multifunction display 430
Basic carrier bars* 281
Batteries, SmartKey
Check lamp 108, 112
Checking battery condition 111
Messages in the
multifunction display 446
Replacing 480
Battery, Vehicle 507
Charging 514
Disconnecting and connecting 509
Jump starting 515
Removing and installing 509

559 Index
Emergency operations
Remote door unlock, Tele Aid* 315
Unlocking/opening the tailgate 476
Emergency Tensioning Device see ETD
Emergency, In case of
Battery, Jump starting 515
Engine shut-down 525
First aid kit 469
Flat tire 497
Fuses 522
Hazard warning flasher 142
Instrument cluster, Indicator
lamps 414, 415, 416, 417, 418,
419, 420, 421, 422, 423, 424
Roadside Assistance 12, 312
Towing the vehicle 518
Emission control 350
Information label 531
System warranties 10
Vacuum line routing diagram
label 531Engine
Belt layout (ML 320 CDI) 532
Belt layout (ML 350) 532
Belt layout (ML 500) 532
Belt layout (ML 63 AMG) 533
Block heater (Canada only) 400
Break-in recommendations 358
Cleaning 406
Compartment 356
Emergency engine shut-down 525
Malfunction indicator lamp 29, 449
Maximum engine speed 146, 534,
535
Messages in the
multifunction display 449
Number 531
Starting 54
Starting with KEYLESS-GO* 55
Starting with the SmartKey 55
Tachometer 29, 146
Technical data 534
Turning off with KEYLESS-GO* 67
Turning off with the SmartKey 67Engine coolant see Coolant
Engine oil 358, 546
Adding 361, 546
Additives 546
Changing 361, 546
Checking level 358
Checking level with the
control system (ML 500 only) 358
Checking with the oil dipstick
(except ML 500) 360
Consumption 358
Filler neck (ML 350, ML 320 CDI) 361
Filler neck (ML 500, ML 63 AMG) 361
Messages in display 359, 453
Messages in the
multifunction display 453
Recommended engine oils
and oil filters 546
Engine oil level 358
ESP
®
27, 98
Four wheel electronic traction system
with ESP
®
98
Messages in the
multifunction display 436, 437
Off-road-ESP®
101
Warning lamp 27, 419, 420