432 Operation
Vehicle care
Use a soft, clean cloth and a mild win-
dow cleaning solution on all outside
and inside glass surfaces.
An automotive glass cleaner is recom-
mended.Light alloy wheels
If possible, clean wheels once a week.
Use Mercedes-Benz approved Wheel
Care, a soft bristle brush and a strong
spray of water for cleaning the light al-
loy wheels.Plastic and rubber parts
Use a gentle dishwashing detergent or
mild detergent for delicate fabrics as a
washing solution.
Wipe with a cloth moistened in a
lukewarm solution.
The surface may temporarily change
color. If this is the case, wait for it to
dry.
!Fold the windshield wiper arms back onto
the windshield before turning the SmartKey in
the starter switch or pressing the KEYLESS-GO
start/stop button (vehicles with KEYLESS-GO*).
Hold on to the wiper when folding the wiper arm
back. If released, the force of the impact from
the tensioning spring could crack the windshield.
!To clean the window interior, do not use a
dry cloth, abrasives, solvents or cleaners con-
taining solvents. Do not touch the inside of the
front, rear or side windows and the power
tilt/sliding sunroof* or rear panorama roof with
hard objects such as an ice scraper or ring.
Doing so may damage the windows.
!Only use acid-free cleaning materials. Acid
may cause corrosion or damage the clear coat.
!The vehicle should not be parked for an ex-
tended period of time immediately after it has
been cleaned, especially not after the wheel rims
have been cleaned with wheel rim cleaner.
Wheel rim cleaners can lead to increased
corrosion of the brake disks and brake pads.
Non-approved wheel cleaners may also damage
the wheel paint if the car is not driven after
cleaning. Therefore, the vehicle’s brake system
should always be warmed-up before it is parked
after cleaning. To do so, please drive your vehicle
for several minutes to allow the brakes to dry.
When applying Mercedes-Benz approved Tire
Care and Mercedes-Benz approved Wheel Care
products, take care not to spray them on the
brake disks.
Warning!G
Do not use cleaners or cockpit care sprays
containing solvents to clean the cockpit or
the steering wheel. Cleaners containing sol-
vents will make the surface porous and vehi-
cle occupants could suffer serious injuries
from plastic parts coming loose in the event
of air bag deployment.
520 Practical hints
Replacing wiper blades
Front wiper blades
Removing
Remove the SmartKey from the starter
switch.
Vehicles with KEYLESS-GO*:
Make sure the vehicle’s on-board
electronics have status0
(
page 44).
Fold the wiper arms forward until they
engage.
1Wiper blade
2Cover
3Attachment
4Tab
5Removing
Press tabs4 together and tilt wiper
blade1 to detach tabs4 on both
recesses of attachment3.
Wiper blade1 is released on one end.
Maintaining its tilted position, slide
wiper blade1 out of attachment3 in
direction of arrow5.
Warning!G
For safety reasons, switch off wipers and
remove SmartKey from starter switch (vehi-
cles with KEYLESS-GO*: Make sure the
vehicle’s on-board electronics have
status
0) before replacing a wiper blade.
Otherwise the motor could suddenly turn on
and cause injury.
Warning!G
Wiper blades are components that are sub-
ject to wear and tear. Replace the wiper
blades twice a year, preferably in the spring
and fall. Otherwise the windows will not be
properly wiped. As a result, you may not be
able to observe surrounding traffic condi-
tions and could cause an accident.
!Never open the hood when the wiper arms
are folded forward.
Hold on to the wiper when folding the wiper arm
back. If released, the force of the impact from
the tensioning spring could crack the windshield.
Do not allow the wiper arms to contact the wind-
shield glass without a wiper blade inserted.
Make sure the wiper blades are properly
installed. Improperly installed wiper blades may
cause windshield damage.
For your convenience, we recommend that you
have this work carried out by an authorized
Mercedes-Benz Light Truck Center.
!Do not pull on the wiper blade inserts. They
could tear.
521 Practical hints
Replacing wiper blades
Installing
1Installing
2Tab
3Attachment
4Guide tab
5Cover
Slide the wiper blade into
attachment3 in direction of
arrow1.
Make sure guide tab4 will be placed
under cover5 when fully inserting the
wiper blade into attachment.
Let tab2 latch into both recesses of
attachment3.
Check if the wiper blade is securely
fastened.
Fold the wiper arm backward to rest on
the windshield.
Make sure you hold on to the wiper arm
when folding it back.
Rear wiper blade
Warning!G
For safety reasons, switch off wipers and
remove SmartKey from starter switch
(vehicles with KEYLESS-GO*: Make sure the
vehicle’s on-board electronics have
status
0) before replacing a wiper blade.
Otherwise the motor could suddenly turn on
and cause injury.
!Hold on to the wiper when folding the wiper
arm back. If released, the force of the impact
from the tensioning spring could crack the rear
window.
Do not allow the wiper arm to contact the rear
window glass without a wiper blade inserted.
Make sure the wiper blade is properly installed.
Improperly installed wiper blades may cause
rear window damage.
For your convenience, we recommend that you
have this work carried out by an authorized
Mercedes-Benz Light Truck Center.
522 Practical hints
Replacing wiper blades
Removing
Remove the SmartKey from the starter
switch.
Vehicles with KEYLESS-GO*:
Make sure the vehicle’s on-board
electronics have status0
(
page 44).
Fold wiper arm1 away from the rear
window until it engages.
1Wiper arm
2Wiper blade
Turn wiper blade2 to form a right
angle with wiper arm1 as shown.
Hold wiper arm1 and disengage wip-
er blade2 by carefully sliding it in
direction of arrow.
Remove wiper blade2.
Installing
1Wiper arm
2Wiper blade
Insert wiper blade2 into wiper
arm1.
Hold wiper arm1 and engage wiper
blade2 by pushing it in direction of
arrow until it locks into place.
Check whether the wiper blade is
securely fastened.
Fold the wiper arm to rest on the rear
window.
M a k e s u r e t o h o l d o n t o t h e w i p e r w h e n
folding the wiper arm back.
!Do not pull on the wiper blade insert. It
could tear.
537 Practical hints
Battery
Connect the positive lead to the posi-
tive terminal and fasten it’s cover
(
page 535).
Connect the negative lead to the nega-
tive terminal (
page 535).
Charging the battery
If the battery is discharged, the battery can
be charged using the jump-start contacts
located in the engine compartment
(
page 539).
Charge the battery in accordance with
the instructions of the battery charger
manufacturer.
Batteries contain materials that can harm
the environment if disposed of improperly.
Large 12-volt storage batteries contain
lead. Recycling of batteries is the preferred
method of disposal. Many states require
sellers of batteries to accept old batteries
for recycling.
!Never invert the terminal connections!
iThe following procedures must be carried
out following any interruption of battery power
(e.g. due to reconnection):
Set the clock (page 176).
Vehicles with COMAND system with naviga-
tion module*: Time and date are set auto-
matically.
Synchronize the door windows
(
page 251).
Synchronize the power tilt/sliding sunroof*
(
page 255).
Synchronize the power folding exterior rear
view mirrors* (
page 212).
Warning!G
Never charge a battery while still installed in
the vehicle unless the accessory battery
charge unit approved by Mercedes-Benz is
being used. Gases may escape during charg-
ing and cause explosions that may result in
paint damage, corrosion or personal injury.
An accessory battery charge unit specially
adapted for Mercedes-Benz vehicles and
tested and approved by Mercedes-Benz is
available, permitting the charging of the
battery in its installed position. Contact an
authorized Mercedes-Benz Light Truck
Center for information and availability.
Charge battery in accordance with the
separate instructions for the accessory
battery charger.
569 Index
A
ABS 103
Indicator lamp 436
Messages in the
multifunction display 453
Off-road - ABS 104
Accelerator position, automatic
transmission 198
Accessory weight 415
Accident 67
Active head restraint 92, 135, 504
Adaptive Damping System (ADS)* 280
Air bags 76
Children 77, 93
Front passenger front air bag off
indicator lamp 31, 32, 85
Front, Driver 79
Front, Passenger 79
Occupant Classification System*
(OCS) 81
Safety guidelines 78
Side impact (front and rear*) 80
Window curtain 80Air conditioning refrigerant 562
Air conditioning system see
Climate control or
Automatic climate control (3-zone)*
Air conditioning, Cooling 226, 241
Air distribution, Front 221, 236
Air distribution, Rear 229, 245
Air pressure see Tire inflation pressure
Air recirculation mode 224, 239
Air suspension package 280
Adaptive Damping System
(ADS)* 280
Messages in the
multifunction display 490
Vehicle level control 281
Air vents 229
Air vents*, Rear 246
Air vents, Front 222, 236
Air volume 222, 237
Alarm system see Anti-theft systems
Alignment bolt (vehicle tool kit) 496, 526
Anticorrosion/antifreeze 561, 566Antiglare, Interior rear view mirror 210
Antiglare, Rear view mirrors* 211
Antilock Brake System see ABS
Anti-theft systems 112
Anti-theft alarm system 111, 112
Immobilizer 111
Aquaplaning see Hydroplaning
Armrest storage compartments
Front 318
Ashtrays* 322
Aspect ratio 415
ATF 382
Attaching a trailer 368
Audio menu 166
CD operation 167
Radio operation 166
Satellite radio* operation
(USA only) 166
Auto-dimming*, Rear view mirrors 211
Automatic central locking,
Control system 183
570 Index
Automatic climate control (3-zone)* 230
Air conditioning refrigerant 561
Air conditioning, Cooling 241
Air distribution, Front 236
Air distribution, Rear 245
Air recirculation mode 239
Air vents*, second-row seats 246
Air vents*, third-row seats 247
Air vents, Front 236
Air volume 237
Control panel, Front 232
Control panel, Rear 243
Deactivating system 234
Defogging 237
Defrosting 237
Maximum cooling, MAXCOOL 239
Rear passenger compartment 243
Rear window defroster 215
Residual engine heat (REST) 242
Using driver-side settings for
all temperature zones 242Automatic headlamp mode 146
Automatic lighting control,
Interior lighting 152
Automatic locking when driving 130
Automatic transmission 58
Accelerator position 198
Emergency operation
(limp-home mode) 202
Gear ranges 200
Gear selector lever 58, 192
Gear selector lever position 195
Gear shifting malfunctions 202
Hill start assist system 199
Kickdown 198
Shifting procedure 195
Starting the engine 57
Steering wheel gearshift control 201
Towing a trailer 200
Transmission fluid level 382
Transmission positions 196
Automatic Transmission Fluid see ATFB
BabySmartTM
Air bag deactivation system 87, 450
Self-test 87
Backrest
Seat 46
Seat, Lumbar support 139
Seat, Multicontour* 140
Backup lamps
Messages in the
multifunction display 481
Replacing bulbs 515
Bar 416
BAS 105
Lamps in instrument cluster 436
Messages in the
multifunction display 453
Basic cross bars* 297
Batteries, SmartKey
Check lamp 114, 117
Checking battery condition 122
Messages in the
multifunction display 469
Replacing 506
572 Index
Children in the vehicle 93
Air bags 77, 93
Blocking rear door window
operation 100
Indicator lamp, Front passenger front
air bag 85, 87, 450
Infant and child restraint systems 88,
94
LATCH-type child seat anchors 97
Occupant Classification System*
(OCS) 81
Cigarette lighter* 324
Climate control 216
Air conditioning refrigerant 561
Air conditioning, Cooling 226, 227
Air distribution, Front 221
Air distribution, rear 229
Air recirculation mode 224
Air vents*, second-row seats 222
Air vents, Front 222
Air volume 222
Control panel*, Rear 228
Control panel, Front 218
Deactivating system 220
Defogging 224
Defrosting 223Rear window defroster 215
Residual engine heat (REST) 227
Clock 27, 176
Setting time 176
Cloth upholstery, Cleaning and
care of 434
Cockpit 24
Cockpit Management and Data System
see COMAND System
Cold tire inflation pressure 416
Collapsible wheel chock 498
COMAND System see separate operating
instructions
Combination switch 63, 65, 149
Compass 345
Adjustment 181
Calibration 182
Calling up the compass 345
Control and operation of radio
transmitters 372
Control system 157
Multifunction display 157
Multifunction steering wheel 158
Resetting to factory default 171Control system menus 157
Audio 166
DISTRONIC* 169
NAV* 168
Off-road 168
Settings 170
Standard display 164
TEL* 189
Trip computer 187
Vehicle configuration 185
Vehicle status message memory 169
Control system submenus 161, 163, 173
Comfort* 184
Instrument cluster 174, 175
Lighting 178
Time/Date 176
Vehicle 181
Coolant 382, 565
Anticorrosion/antifreeze mixing ratio
and quantity 566
Capacities 560
Checking coolant level 377, 382
Messages in the
multifunction display 473, 475
Temperature 374
Temperature display 164